Protecting groups carbonyl compounds

The selective intermolecular addition of two different ketones or aldehydes can sometimes be achieved without protection of the enol, because different carbonyl compounds behave differently. For example, attempts to condense acetaldehyde with benzophenone fail. Only self-condensation of acetaldehyde is observed, because the carbonyl group of benzophenone is not sufficiently electrophilic. With acetone instead of benzophenone only fi-hydroxyketones are formed in good yield, if the aldehyde is slowly added to the basic ketone solution. Aldols are not produced. This result can be generalized in the following way aldehydes have more reactive carbonyl groups than ketones, but enolates from ketones have a more nucleophilic carbon atom than enolates from aldehydes (G. Wittig, 1968). 

The most commonly used protected derivatives of aldehydes and ketones are 1,3-dioxolanes and 1,3-oxathiolanes. They are obtained from the carbonyl compounds and 1,2-ethanediol or 2-mercaptoethanol, respectively, in aprotic solvents and in the presence of catalysts, e.g. BF, (L.F. Fieser, 1954 G.E. Wilson, Jr., 1968), and water scavengers, e.g. orthoesters (P. Doyle. 1965). Acid-catalyzed exchange dioxolanation with dioxolanes of low boiling ketones, e.g. acetone, which are distilled during the reaction, can also be applied (H. J. Dauben, Jr., 1954). Selective monoketalization of diketones is often used with good success (C. Mercier, 1973). Even from diketones with two keto groups of very similar reactivity monoketals may be obtained by repeated acid-catalyzed equilibration (W.S. Johnson, 1962 A.G. Hortmann, 1969). Most aldehydes are easily converted into acetals. The ketalization of ketones is more difficult for sterical reasons and often requires long reaction times at elevated temperatures. a, -Unsaturated ketones react more slowly than saturated ketones. 2-Mercaptoethanol is more reactive than 1,2-ethanediol (J. Romo, 1951 C. Djerassi, 1952 G.E. Wilson, Jr., 1968). 

The carbonyl group forms a number of other very stable derivatives. They are less used as protective groups because of the greater difficulty involved in their removal. Such derivatives include cyanohydrins, hydrazones, imines, oximes, and semicarbazones. Enol ethers are used to protect one carbonyl group in a 1,2- or 1,3-dicarbonyl compound. 

Derivatives of carbonyl compounds that have been used as protective groups in synthetic schemes are described in this chapter some of the more important protective groups are listed in Reactivity Chart 5. ... 

A carbonyl group can be protected as a sulfur derivative—for example, a dithio acetal or ketal, 1,3-dithiane, or 1,3-dithiolane—by reaction of the carbonyl compound in the presence of an acid catalyst with a thiol or dithiol. The derivatives are in general cleaved by reaction with Hg(II) salts or oxidation acidic hydrolysis is unsatisfactory. The acyclic derivatives are formed and hydrolyzed much more readily than their cyclic counterparts. Representative examples of formation and cleavage are shown below. 

In a prostaglandin synthesis a carbonyl group was protected as an oxime in which the hydroxyl group was protected against Collins oxidation by the phenylthiome-thyl-group. The phenylthiomethyl group is readily removed to give an oxime that is then cleaved to the carbonyl compound. ... 

When only one carbonyl or hydroxyl group is to be blocked in a multifunctional compound, the choice of the protecting group will be determined by the ease with which the group can be introduced selectively into the parent molecule. 

The hydrosilylation of carbonyl compounds by EtjSiH catalysed by the copper NHC complexes 65 and 66-67 constitutes a convenient method for the direct synthesis of silyl-protected alcohols (silyl ethers). The catalysts can be generated in situ from the corresponding imidazolium salts, base and CuCl or [Cu(MeCN) ]X", respectively. The catalytic reactions usually occur at room tanperature in THE with very good conversions and exhibit good functional group tolerance. Complex 66, which is more active than 65, allows the reactions to be run under lower silane loadings and is preferred for the hydrosilylation of hindered ketones. The wide scope of application of the copper catalyst [dialkyl-, arylalkyl-ketones, aldehydes (even enoUsable) and esters] is evident from some examples compiled in Table 2.3 [51-53],... 

---