Carbon adsorptive properties

Activated carbons contain chemisorbed oxygen in varying amounts unless special cate is taken to eliminate it. Desired adsorption properties often depend upon the amount and type of chemisorbed oxygen species on the surface. Therefore, the adsorption properties of an activated carbon adsorbent depend on its prior temperature and oxygen-exposure history. In contrast, molecular sieve 2eohtes and other oxide adsorbents are not affected by oxidi2ing or reducing conditions. 

As a possible method of concentrating trace amounts of bioactive organic compounds occurring in the hydrosphere, adsorption properties of various compounds have been explored by employing hydrous metal oxides as the adsorbents. To date, a family of organophosphoms compounds and carbonic acids were adsorbed onto hydrous iron oxide, along with the adsoi ption of monosaccharides onto hydrous zirconium oxide. 

The value of r can be estimated as that of saturated liquid at the same temperature or related to supercritical properties at temperatures above critical. Critoph [2] found that for the practical purposes of modelling ammonia - carbon adsorption cycles, using experimentally determined porosity data, that the complexity of estimating both r and p at sub and supercritical levels was not justified. The measured porosity data could be fitted to a much simpler version of the equation with no loss of accuracy, as follows ... 

The term activation refers to the development of the adsorption properties of carbon. Raw materials such as coal and charcoal do have some adsorption capacity, but this is greatly enhanced by the activation process. There are three main forms of activated carbon. 

II and III). This result was expected because of the well known adsorptive properties of carbon for radon and thoron. However, the activated carbon data on Tables II and III is in sharp disagreement with previous, and numerous, data obtained in the large RTTF (see Table I). This topic is under investigation. It should be noted that there are substantial quantitative differences between the behaviour of the radon and thoron progeny relative to activated carbon. 

These adsorptions appear to be inconsistent with the evolution of carbon dioxide and other volatiles out of the charring solid in the pyrolysis process. The adsorptive properties develop as pyrolysis frees sites for adsorption debris escaping from thermally decomposing lignocellulosics leaves the char residue with a highly reactive, eagerly adsorbing inner surface. 

The present paper focuses on the interactions between iron and titania for samples prepared via the thermal decomposition of iron pentacarbonyl. (The results of ammonia synthesis studies over these samples have been reported elsewhere (4).) Since it has been reported that standard impregnation techniques cannot be used to prepare highly dispersed iron on titania (4), the use of iron carbonyl decomposition provides a potentially important catalyst preparation route. Studies of the decomposition process as a function of temperature are pertinent to the genesis of such Fe/Ti02 catalysts. For example, these studies are necessary to determine the state and dispersion of iron after the various activation or pretreatment steps. Moreover, such studies are required to understand the catalytic and adsorptive properties of these materials after partial decomposition, complete decarbonylation or hydrogen reduction. In short, Mossbauer spectroscopy was used in this study to monitor the state of iron in catalysts prepared by the decomposition of iron carbonyl. Complementary information about the amount of carbon monoxide associated with iron was provided by volumetric measurements. 

On the other hand, irreversible changes in the PZC can be effected in some surfaces. The oxidation of carbon surfaces, for example, changes the PZC and does affect the adsorptive properties. Carbon will be discussed in a later section. 

The monomer type and ratio change the adsorption properties of the polymer on the calcium carbonate particles. The type of end group (which depends on the polymerisation process) can also influence adsorption characteristics. 

---