Capacity of exchange

For a solution of concentration c s corresponding to the inflection point, F (Figure 2), 6g equals the full capacity of exchange at the surface of the solid. 

The low capacity of exchange (S at level P) is equivalent to 110 to 105 sq.A. per =SiOH site for silica and 95 sq.A. per = SiOX site for glass. All these values are comparable to the value foxmd by Tamamushi... 

For practical purposes, it is more convenient to deal with the amount or maximum amount, Q , ( exchange capacity ) of exchangeable ions [46]. 

As an adjective applied to metals base represents the opposite of noble, i.e. a base metal would be attacked by mineral acids, base exchange An old term used to describe the capacity of soils, zeolites, clays, etc. to exchange their cations (Na, K, Ca ) for an equivalent of other cations without undergoing structural change. An example of the general process of ion exchange. ... 

AMP-1 4.0 Microcrystalline ammonium molybdo-phosphate with cation exchange capacity of 1.2 mequiv/g. Selectively adsorbs larger alkali metal ions from smaller alkali metal ions, particularly cesium. 

Example Shaking 50 mL of 0.001 Af cesium salt solution with 1.0 g of a strong cation exchanger in the H-form (with a capacity of 3.0 mequiv g ) removes the following amount of cesium. The... 

The total stationary-phase volume required to process a given feed stream is proportional to the inlet concentration and volume of the feed. For example, for a typical inlet concentration of protein of 10 g/L, in a 100 L volume of feed, a column volume of at least 100 L is needed for size-exclusion chromatography. In comparison, an ion-exchange column having an adsorption capacity of 50 g/L would only require 20 L of column volume for the same feed. 

Polymeric coagulants do not affect pH therefore, the need for supplemental alkalinity, such as lime, caustic, or soda ash, is reduced or eliminated. Polymeric coagulants do not add to the total dissolved soHds concentration, eg, 1 ppm of alum adds 0.45 ppm of sulfate ion (expressed as CaCO ) the reduction ia sulfate can significantly extend the capacity of anion-exchange systems. 

Several physicochemical properties of dietary fiber contribute to its physiological role. Water-holding capacity, ion-exchange capacity, solution viscosity, density, and molecular kiteractions are characteristics determined by the chemical stmcture of the component polysaccharides, thek crystallinity, and surface area. 

The working capacity of a sorbent depends on fluid concentrations and temperatures. Graphical depiction of soration equilibrium for single component adsorption or binary ion exchange (monovariance) is usually in the form of isotherms [n = /i,(cd or at constant T] or isosteres = pi(T) at constant /ij. Representative forms are shown in Fig. I6-I. An important dimensionless group dependent on adsorption equihbrium is the partition ratio (see Eq. 16-125), which is a measure of the relative affinities of the sorbea and fluid phases for solute. 

Adsorption with strongly favorable isotherms and ion exchange between strong electrolytes can usually be carried out until most of the stoichiometric capacity of the sorbent has been utilized, corresponding to a thin MTZ. Consequently, the total capacity of the bed is... 

---