Bronsted zeolites

S. R. Blaszkowski and R. A. van Santen,/. Phys. Chem., 99, 11728 (1995). Density Functional Theory Calculations of the Activation of Methanol by a Bronsted Zeolitic Proton. 

Factors other tlian tire Si/Al ratio are also important. The alkali-fonn of zeolites, for instance, is per se not susceptible to hydrolysis of tire Al-0 bond by steam or acid attack. The concurrent ion exchange for protons, however, creates Bronsted acid sites whose AlO tetraliedron can be hydrolysed (e.g. leading to complete dissolution of NaA zeolite in acidic aqueous solutions). 

To explain how solid acids such as Nafion-H or HZSM-5 can show remarkable catalytic activity in hydrocarbon transformations, the nature of activation at the acidie sites of such solid acids must be eon-sidered. Nafion-H contains acidic -SO3H groups in clustered pockets. In the acidic zeolite H-ZSM-5 the active Bronsted and Tewis acid sites are in close proximity (—2.5 A). 

Reaction of 1 mole of aminals 352 with 4 mol of methyl 3-aminocrotonate in the presence of the solid acids montmorillonte clay (Kio) and ZF520 zeolite as strong Bronsted acidic catalysts, gave 1,4-dihydropyridines 353 and 2-methyl-4//-pyrido[l, 2-n]pyrimidin-4-one (99MI8). 

Acid-treated clays were the first catalysts used in catalytic cracking processes, but have been replaced by synthetic amorphous silica-alumina, which is more active and stable. Incorporating zeolites (crystalline alumina-silica) with the silica/alumina catalyst improves selectivity towards aromatics. These catalysts have both Fewis and Bronsted acid sites that promote carbonium ion formation. An important structural feature of zeolites is the presence of holes in the crystal lattice, which are formed by the silica-alumina tetrahedra. Each tetrahedron is made of four oxygen anions with either an aluminum or a silicon cation in the center. Each oxygen anion with a -2 oxidation state is shared between either two silicon, two aluminum, or an aluminum and a silicon cation. 

Bronsted acid sites in HY-zeolites mainly originate from protons that neutralize the alumina tetrahedra. When HY-zeolite (X- and Y-zeolites... 

The previous sections have shown that desihcation of ZSM-5 zeohtes results in combined micro- and mesoporous materials with a high degree of tunable porosity and fuUy preserved Bronsted acidic properties. In contrast, dealumination hardly induces any mesoporosityin ZSM-5 zeolites, due to the relatively low concentration of framework aluminum that can be extracted, but obviously impacts on the acidic properties. Combination of both treatments enables an independent tailoring of the porous and acidic properties providing a refined flexibility in zeolite catalyst design. Indeed, desihcation followed by a steam treatment to induce dealumination creates mesoporous zeolites with extra-framework aluminum species providing Lewis acidic functions [56]. 

The preparation was performed on a commercial microcrystalline beta zeolite. The zeolite was treated with the Fenton s reagent and less than 0.3 wt% of carbon remained after the treatment. The porosity was fully developed as revealed by the pore-size distribution. Elemental analysis combined with TPR did confirm the high degree of Fe-exchange (98%) on the Bronsted sites. 

The isomorphic substituted aluminum atom within the zeolite framework has a negative charge that is compensated by a counterion. When the counterion is a proton, a Bronsted acid site is created. Moreover, framework oxygen atoms can give rise to weak Lewis base activity. Noble metal ions can be introduced by ion exchanging the cations after synthesis. Incorporation of metals like Ti, V, Fe, and Cr in the framework can provide the zeolite with activity for redox reactions. 

Since their development in 1974 ZSM-5 zeolites have had considerable commercial success. ZSM-5 has a 10-membered ring-pore aperture of 0.55 nm (hence the 5 in ZSM-5), which is an ideal dimension for carrying out selective transformations on small aromatic substrates. Being the feedstock for PET, / -xylene is the most useful of the xylene isomers. The Bronsted acid form of ZSM-5, H-ZSM-5, is used to produce p-xylene selectively through toluene alkylation with methanol, xylene isomerization and toluene disproportionation (Figure 4.4). This is an example of a product selective reaction in which the reactant (toluene) is small enough to enter the pore but some of the initial products formed (o and w-xylene) are too large to diffuse rapidly out of the pore. /7-Xylene can, however. 

Since spillover phenomena have been most directly sensed through the use of IR in OH-OD exchange [10] (in addition, in the case of reactions of solids, to phase modification), we used this technique to correlate with the catalytic results. One of the expected results of the action of Hjp is the enhancement of the number of Bronsted sites. FTIR analysis of adsorbed pyridine was then used to determine the relative amounts of the various kinds of acidic sites present. Isotopic exchange (OH-OD) experiments, followed by FTIR measurements, were used to obtain direct evidence of the spillover phenomena. This technique has already been successfully used for this purpose in other systems like Pt mixed or supported on silica, alumina or zeolites [10]. Conner et al. [11] and Roland et al. [12], employed FTIR to follow the deuterium spillover in systems where the source and the acceptor of Hjp were physically distinct phases, separated by a distance of several millimeters. In both cases, a gradient of deuterium concentration as a function of the distance to the source was observed and the zone where deuterium was detected extended with time. If spillover phenomena had not been involved, a gradientless exchange should have been observed. 

Spectroscopy. In the methods discussed so far, the information obtained is essentially limited to the analysis of mass balances. In that re.spect they are blind methods, since they only yield macroscopic averaged information. It is also possible to study the spectrum of a suitable probe molecule adsorbed on a catalyst surface and to derive information on the type and nature of the surface sites from it. A good illustration is that of pyridine adsorbed on a zeolite containing both Lewis (L) and Brbnsted (B) acid sites. Figure 3.53 shows a typical IR ab.sorption spectrum of adsorbed pyridine. The spectrum exhibits four bands that can be assigned to adsorbed pyridine and pyridinium ions. Pyridine adsorbed on a Bronsted site forms a (protonated) pyridium ion whereas adsorption on a Lewis site only leads to the formation of a co-ordination complex. 

Figure 3.53. IR transmission absorption spectrum of pyridine adsorbed on partly dehydroxylated HY zeolite (Van Bekkum et al, 1991) B = Bronsted acid sites L = Lewis acid sites.

Two-Dimensional correlation analysis to study Bronsted acid sites in zeolites... 

Keywords Two-Dimensional correlation, Infrared spectroscopy, Dealuminated H-Y zeolite, Bronsted acidity, MQ-MAS NMR. 

Recrystallization procedure applied to the amorphous aluminosilicates of different chemical composition resulted in the formation of the dispersed zeolitic domains of the FAU and BEA structure in porous matrices. The structural transformation into the composite material was proved with TEM, XRD and 27Al and 29Si MAS NMR spectroscopies. The IR data revealed that strong Bronsted acid centers were main active sites generated in the composite materials, irrespectively of the Al content. 

The formation of heavy carbonaceous compounds in 5A calcium exchanged zeolites depends on the calcium content. These zeolites are able to protonated ammonia molecules in ammonium ions. This Bronsted acidity results from the presence of CaOH+ species which are formed by water dissociation on Ca2+ ions and have an IR signature at 3515 cm"1. 

---