Booker

Booker Gr, Laczik Z and Toeroek P 1995 Applications of Scanning Infra-red Microscopy to Bulk Semiconductors (Inst. Phys. Conf Ser., 146) pp 681-92... 

Ashworth V and Booker C J L (eds) 1985 Cathodic Protection Theory and Practice (New York Ellis Norwood)... 

Booker Morey, Ph.D., Senior Consultant, SRI International Member, Society of Mining, Metallurgy and Exploration (SME of AIME), The Filtration Society, Air and Waste Management Association Registered Professional Engineer (California and Massachusetts) (Section 18, Liquid-Solid Operations and Equipment)... 

In the development of the assembly variability risks analysis, expert knowledge, data found in many engineering references and information drawn from the CSC DFA/MA practitioner s manual (CSC Manufacturing, 1995) were collated and issues related to variability converged on. Much of the knowledge for the additional assembly variability risks analysis was reviewed from the fabrication and joining data sheets called PRocess Information MAps (PRIMAs) as given in Swift and Booker (1997). 

It is important that the produet development team be familiar with the main eapabilities and eharaeteristies of the manufaeturing and assembly methods seleeted, as well as the materials eonsidered, in order to obtain the full benefit from the methodology. Teehnieal and eeonomie knowledge for some eommon manufaeturing proeesses ean also be found in Swift and Booker (1997). 

Figure 5.10 Percentage of UK companies surveyed using a particular tool or technique (Araujo etal., 1996 Booker, 1994)...

Before setting about the task of developing such a model, the product development process requires definition along with an indication of its key stages, this is so the appropriate tools and techniques can be applied (Booker et al., 1997). In the approach presented here in Figure 5.11, the product development phases are activities generally defined in the automotive industry (Clark and Fujimoto, 1991). QFD Phase 1 is used to understand and quantify the importance of customer needs and requirements, and to support the definition of product and process requirements. The FMEA process is used to explore any potential failure modes, their likely Occurrence, Severity and Detectability. DFA/DFM techniques are used to minimize part count, facilitate ease of assembly and project component manufacturing and assembly costs, and are primarily aimed at cost reduction. 

Booker, J. D. 1994 Project Specification Quality Questionnaire. Internal Document - EPSRC GR/J97922, School of Engineering, University of Hull. 

Booker, J. D., Dale, B., McQuater, R., Spring, M. and Swift, K. G. 1997 Effective use of Tools and Techniques in New Product Development. Manchester UMIST Press. 

Swift, K. G., Raines, M. and Booker, J. D. 1998 Techniques in Capable and Reliable Design. In Proceedings EDIProD 98, Subutka, Poland, IXl-29. 

J.D. Booker, M. Raines, K.G. Swift Sehool of Engineering, University of EIull, UK... 

Fig. 1.19 Potential-pH diagram for copper in solutions containing and (NH4>2S04 (after Mattson ) with superimposed times to fracture Tf of direct-loaded a-brass wires held at various potentials in the solution of pH 7-2 the specimen without external polarisation had Ff = 3y h (after Hoar and Booker S)...

Scheweitzer, P. A.. Corrosion and Corrosion Protection Handbook, Dekker AG, Basle (1989) Ashworth, V. and Booker, C. J. L. (Eds.), Cathodic Protection Theory and Practice, Ellis Horwood (1986)... 

---