Bolted bracket connection

Kasai, K. Bleiman, D. 1996. Bolted brackets for repair of damaged steel moment frame Connections. 7th US-Japan Workshop on the Improvement of Structural Design and Construction Practices Lessons Learned from Northridge and Kobe, Kobe, Japan. 

Adan, S.M. Gibb, W. 2006. Cyclic behavior of the Kaiser bolted bracket steel moment-resisting connection. Technical Report, KPFF Consulting Engineers, Seattle, Washington. American Welding Society. 2006. Structural Welding Code Steel, ANSI/AWS Dl.1 12006. Miami, Elorida. 

Strengthening Techniques Code-Deficient Steei Buiidings, Fig. 3 (a) Reduced beam section (RBS) connection (Crawford 2002), (b) welded haunch coimection (Uang et al 2000), (c) bolted brackets... 

Cathodes made of steel tube rings 10 m in diameter are used m the internal protection of several 30-m-high caustic soda stirring tanks, each with a surface area of 3100 m, The cathodes were insulated and mounted on supporting brackets. The current supply was via armored parallel connected cables. One-inch bolts were used for the entrance in the tank wall as shown in Fig. 21 -13 for a feed current of 500 A. The size of the cathodes has to be such that they can maintain sufficient cathodic protection current. The surface ratio of the object to be protected and the... 

Many hand controls are attached to the steering column. Hand-controls either clamp to the steering column or are attached to a bracket which is bolted to the steering column or dash, typically where the steering column bolts to the dash. Installation of the hand-controls should not interfere with driver safety features (e.g., air bags, collapsible steering columns). The push rods of the hand-control either clamp directly to the pedals or the levers connected to them. 

Steel bracket, which is fixed by anchor bolts to the top surface of abutment, is utilized as an unseating-prevention device. A shock absorbing chain connected between the steel bracket at bottom of girder and that of vertical front wall of concrete abutment is also adopted in order to avoid the bridge falling. Injected liquid epoxy resin is effective to fix the anchor bolts in horizontally bored hole. 

Use the bolt coated with screw lock agent to connect the clump weight assembly to the clump weight bracket assembly and tighten it to the specified torque. 

D. Connections (e.g., bolted, welded, base plates, brackets)... 

---