Bis-aryl halide

Palladium-catalyzed intramolecular cross-coupling reaction of bis-aryl halides using ditin reagents. 

A novel route to prepare bifimctional initiating systems susceptible to anionic polymerization was recently devel-oped. For the synthesis of PMMA-PBd-PSt-PBd-PMMA, a bis(aryl halide) was metalated by a lithium/halide exchange reaction. The initiator that resulted was used to polymerize sequentially St, Bd, and MMA (Scheme 11). To ensure solubilization of the initiator in nonpolar organic media (benzene). 

The reaction of benzotriazoles with aryl halides catalyzed by a mixture of Pd(dppe)Cl2 (DPPE = bis-(diphenylphosphino)ethane) or Pd(dppf)Cl2, copper(I)iodide or copper(II)carboxylates, and a phase-transfer catalyst has been shown to proceed in good yield in DMF solvent.104 Both copper and palladium were required for these reactions to occur at the N-l position in high yields. Similar results for the coupling of amines with aryliodonium salts in aqueous solvent were observed.105... 

Vinyl and Aryl Halides and Triflates. The organosilane reduction of aryl halides is possible in high yields with triethylsilane and palladium chloride.195 The reaction is equally successful with aryl chlorides, bromides, and iodides. Aryl bromides and iodides, but not chlorides, are reduced with PMHS/Pd(PPh3)4 in moderate to excellent yields.199 This system also reduces vinyl bromides.199 p-Chlorobenzophenone is reduced to benzophenone with yym-tetramethyldisilo-xane and Ni/C in excellent yield (Eq. 59).200 There is a report of the organosilane reduction of aryl and vinyl triflates in very high yields with the combination of Et3SiH/Pd(OAc)2/dppp (l,3-bis(diphenylphosphino)propane) (Eq. 60).201... 

Halopyridines, like simple carbocyclic aryl halides, are viable substrates for Pd-catalyzed crosscoupling reactions with terminal acetylenes in the presence of Pd/Cu catalyst. The Sonogashira reaction of 2,6-dibromopyridine with trimethylsilylacetylene afforded 2,6-bis(trimethylsilyl-ethynyl)pyridine (130), which was subsequently hydrolyzed with dilute alkali to provide an efficient access to 2,6-diethynylpyridine (131) [106]. Extensions of the reactions to 2-chloropyridine, 2-bromopyridine, and 3-bromopyridine were also successful albeit at elevated temperatures [107]. 

In the direct synthesis of aryl terminal alkynes via Pd-catalyzed cross-coupling of aryl halides with ethynylmetals, formation of diarylethynes is one of the potential side reactions. Indeed, the Kumada coupling of 2-iodo-5-methylthiophene (29) with ethynylmagnesium chloride gave the desired 2-ethynyl-5-methylthiophene (30) in only 35% yield, along with 24% of bis(5-methyl-2-thienyl)ethyne (31) [29], The high propensity for H-Mg exchange reaction to occur was blamed for the diarylethyne formation. 

Scheme 2.51 Synthesis of bis- and trisallenes by palladium-catalyzed coupling of allenylindium reagents with aryl halides.

Although sodium sulphide reacts readily with haloalkanes [2] and activated aryl halides (see Chapter 2) [e.g. 3-5] in the presence of a quaternary ammonium catalyst to form symmetrical thioethers (Table 4.1), a major side reaction results in the formation of disulphides owing to the oxidation of the intermediate thiols under the basic conditions. Consequently, little use has been made of this procedure for the synthesis of thioethers [3, 6], but the corresponding reaction of the a,(0-dihaloalkanes to yield cyclic thioethers has proved to be a valuable procedure for the synthesis of thietanes [7] (Table 4.2). The ring closure with the secondary dihaloalkanes is considerably more difficult to effect than is the reaction of the primary dihaloalkanes. 1,3-Dihydrobenzo[c]thiophene (89%) is produced in the reaction of 1,2-bis(bromomethyl)benzene with sodium sulphide (Scheme 4.1) [8]. The direct... 

S)-(-)-CITRONELLOL from geraniol. An asymmetrically catalyzed Diels-Alder reaction is used to prepare (1 R)-1,3,4-TRIMETHYL-3-C YCLOHEXENE-1 -CARBOXALDEHYDE with an (acyloxy)borane complex derived from L-(+)-tartaric acid as the catalyst. A high-yield procedure for the rearrangement of epoxides to carbonyl compounds catalyzed by METHYLALUMINUM BIS(4-BROMO-2,6-DI-tert-BUTYLPHENOXIDE) is demonstrated with a preparation of DIPHENYL-ACETALDEHYDE from stilbene oxide. A palladium/copper catalyst system is used to prepare (Z)-2-BROMO-5-(TRIMETHYLSILYL)-2-PENTEN-4-YNOIC ACID ETHYL ESTER. The coupling of vinyl and aryl halides with acetylenes is a powerful carbon-carbon bond-forming reaction, particularly valuable for the construction of such enyne systems. 

Nickel(O) triphenylphosphine can be used to couple aryl halides and alkenes to synthesize substituted olefins [149], 1,2-bis[(di-2-propylphosphino)benzene]nick-el(0) can be used to couple aryl halides [150], and l,2-bis[(diphenylphos-phino)ethane]nickel(0) can be used to prepare benzoic acid from bromobenzene in the presence of carbon dioxide [151]. 

Biaryl synthesis from aryl halides is a more interesting reaction due to the value of these molecules and their difficult access by chemical methods. The first electrosyntheses were simultaneously done in 1979-80 by three groups [21-23] who used NiCljPPha (1-20%) as catalyst precursor in the presence of excess PPhs. Later, several groups investigated the use of bidentate phosphines like dppe associated with nickel in the synthesis of various biaryls, and notably 2,2 -bipyridine and of 2,2 -biquinoline from respectively 2-chloropyridine and 2-chloroquinoline [24], More recently new nickel complexes with l,2-bis(di-2-alkyl-phosphino)benzene have been studied from both fundamental and synthetic points of view [25]. They have been applied to the coupling of aryl halides. 

---