Benzene formylation

Benzene- sulphon- amlde /)-Tolu- enesul- phon- amlde Benzal Derivative Plcrate 3-Nltro- phthal- Imlde 2 4- Dinitro- phenyl Derivative Formyl Derivative Phenyl thio- urea... 

Bento amide Benzene- sulphon- amide p-Tolu- enesul- phon- amide Plcrate Formyl Derivative Other Derivatives... 

The effect of substituents on the reactivity of heterocyclic nuclei is broadly similar to that on benzene. Thus mem-directing groups such as methoxycarbonyl and nitro are deactivating. The effects of strongly activating groups such as amino and hydroxy are difficult to assess since simple amino compounds are unstable and hydroxy compounds exist in an alternative tautomeric form. Comparison of the rates of formylation and trifiuoroacetylation of the parent heterocycle and its 2-methyl derivative indicate the following order of sensitivity to substituent effects furan > tellurophene > selenophene = thiophene... 

Fig. 10.3. Orbital coefficients for HOMO and next highest n orbital for some substituted benzenes. (From CNDO/2 ealculations. Ortho and meta eoefficients have been averaged in the case of the unsymmetrical methoxy and formyl substituents. Orbital energies are given in atomic units.)...

Although crude cyanoamidine (10) can be used for many reactions, reduction to the 2-formyl-A-norsteroid (11) is most satisfactory when purified material is employed. The crude cyanoamidine is stirred for about 15 min with boiling toluene (120 ml/g of steroid) to effect dissolution, the hot solution is filtered quickly through fluted paper, and the filtrate is cooled and diluted with an equal volume of petroleum ether. The mixture is cooled for 0.5 hr in ice, affording from 25 g of crude material about 18 g of colorless 2a-(A-pyrrolidinylcyanoiminomethyl)-A-nor-5a-androstan-17 -ol (10) mp 252-255° (anal, sample mp 262-263°, from benzene-hexane 250 m ... 

Apparently the role of methanol is to intercept unstable species which otherwise tend to polymerize or rearrange. The methoxy peroxide (72) can be isolated in crystalline form if desired, but it is preferable to treat the methylene dichloride solution at 0° with zinc dust and acetic acid until the mixture shows a negative potassium iodide test. The resulting crude seco-aldehyde (73) is then cyclized to (74) by stirring with neutral alumina in benzene at room temperature for 3 hr. ° Wechter has recently reported a number of transformations of a 5yS-hydroxy-6yS-formyl-B-norpregnane prepared in 8% yield by photolysis and hydrolysis of a 5a-hydroxy-6 -azidopregnane. 

It is thus apparent that the selectivity of a reagent toward thiophene and benzene can differ appreciably, and this difference in selectivity is also strongly noticeable in the proportions of 2- and 3-isomers formed. Although in certain reactions no 3-isomer has been detected, appreciable amounts have been found in other reactions. Thus 0.3% of the 3-isomer has been found in the chlorination of thiophene.- Earlier results indicated that 5-10% 3-nitrothiophene is formed in the nitration of thiophene and a recent gas-chromatographic analysis by Ostman shows that the mononitrothiophene fraction contains as much as 16% of the 3-isomer. It appears that gas-chromatographic analysis should be very useful for the detection of small amounts of 3-isomers in other substitution reactions. However, from routine analyses of IR spectra, it appears to the present author that the amount of 3-isomers formed in acylation, formylation, and bromina-tion of thiophene are certainly less than a few per cent. 

In 1927 Putochin studied the effect of temperature on the nature of the products formed when the formylation reaction was carried out in benzene and observed that 1-formyl derivatives were the major products obtained at low temperatures, whereas the 3-formyl derivatives predominated at higher temperatures. Britton et al. in 1947 claimed that the formation of the 3 -formylindole derivative is probably favored, relative to the alternate 1-formylation process, by elevated temperatures and pressures.However, it was apparently not possible to suppress completely the formation of the 1-formyl derivatives and yields of the order of 40% of both products were usually obtained. 

Reaction of 2-(A -allylamino)-3-formyl-4//-pyrido[l, 2-u]pyrimidin-4-ones 219 in EtOH with HONH2 HCI yielded ( )-oximes 220 at 0°C and 221 (R = PhCH2) under reflux. Heating 220 (R = H) in a boiling solvent afforded cw-fused tetracyclic cycloadducts 221 (R = H). In an aprotic solvent (e.g., benzene or MeCN) the main a>fused cycloadducts 221 (R = H) were accompanied by a mixture of trauA-fused cycloadducts 222, A -oxides 223 and tetracyclic isoxazoline 224 (96T887). The basicity of the 2-allylamino moiety of compounds 219 affected the rate of the conversion. Cycloadditions were also investigated in dioxane and BuOH. 

The reaction of electron-rich aromatic compounds with yV,A -dimethylformamide 2 and phosphorus oxychloride to yield an aromatic aldehyde—e.g. 3 from the substituted benzene 1—is called the Vilsmeier reaction or sometimes the Vilsmeier-Haack reaction. It belongs to a class of formylation reactions that are each of limited scope (see also Gattermann reaction). 

A solution in dry benzene of 82 grams of bis(/3-chloroethyl)amine freshly liberated from its hydrochloride is added gradually to a solution of 36 grams of carbonyl chloride (phosgene) in benzene at a temperature below 10°C. The mixture is mechanically stirred for 3 hours, the precipitate of bis()3-chloroethyl)amine hydrochloride is removed by filtration and the benzene is distilled off on a water bath. The residue is distilled in vacuo and the N-ch oro-formyl-bis((3-chloroethy )amine is obtained as a pale yellow oil with a 8P of 114° to 116°C at 1 mm Hg. 

In the Gatteinicin-Koch reaction, a formyl group (-CHO) is introduced directly onto a benzene ring. For example, reaction of toluene wjfh CO and HCJ in the presence of mixed CUCI/AICI3 gives p-methylbenzaldehyde. Propose a mechanism. 

The reaction with disubstituted formamides and phosphorus oxychloride, called the Vilsmeier or the Vilsmeier-Haack reaction,is the most common method for the formylation of aromatic rings. However, it is applicable only to active substrates, such as amines and phenols. An intramolecular version is also known.Aromatic hydrocarbons and heterocycles can also be formylated, but only if they are much more active than benzene (e.g., azulenes, ferrocenes). Though A-phenyl-A-methyl-formamide is a common reagent, other arylalkyl amides and dialkyl amides are also used. Phosgene (COCI2) has been used in place of POCI3. The reaction has also been carried out with other amides to give ketones (actually an example of 11-14),... 

Another method, formylation with CO and HCl in the presence of AICI3 and CuCl (the Gatterman-Koch reaction), is limited to benzene and alkylbenzenes. ... 

Spirothiopyrans 45b including a benzopyrylium ring have been prepared in one step by condensation of 2-aminovinyl-3-formyl chromone-4-thione 47 with 1,2,3,3-tetramethylindolinium salts in ethanol (Scheme 25).90 The precursor 47 is prepared from 3-carboxymethylene-2-methyl-chromone-4-thione 48. First, oxidation of 48 with pyridinium dichromate in CH2C12, and then condensation with dimethyl formamide dimethyl acetal in benzene gave compound 47. 

Benzene and naphthalene compounds can be formylated under Vil-smeir conditions. The formyl compounds, with or without isolating, can be condensed with amino arenes to give leuco compounds. In this reaction, the benzhydrol intermediate is not isolated.21,79,84 86 The reaction is generally carried out in an alcohol solvent such as isopropanol, butanol, or pentanol and an acid catalyst such as hydrochloric acid, sulfuric acid, or methanesul-fonic acid.87 Acetic acid can also be used both as catalyst and as the solvent. Urea sometimes is added as catalyst.84,88 Terephthaldehyde reacts with W-diethyl-3-methylaniline89 and substituted azulenes to give a bis-triphenylmethane21 57 and 58, respectively. 

However, the rate of substitution of pyrrole is too high and that of benzene too low to be followed by standard techniques, and consequently a kinetic study was limited to furan, thiophene, selenophene, and tellurophene. Activation entropies are constant for all four members of the series, indicating that the arrangement of the atoms around the reaction center is similar, i.e., the transition states of all four rings occur at similar positions along the reaction coordinate. The relative rates for the formylation are thus controlled by the activation enthalpies. At 30UC relative rates are furan (107), thiophene (1), selenophene (3.64), and tellurophene (36.8).68... 

Substrates 47 and 48 have also been used to study the relative reactivities of selenophene and thiophene and of selenophene and benzene.71 The higher reactivity of the selenophene ring was demonstrated by the fact that upon formylation 59% of compound 49a was formed and upon acylation 63% of derivative 49b. Acylation of 48 gave exclusively 2-acetyl-5-benzylselenophene. Structures of the products were determined by H NMR. 

---