Back-extraction, definition

Heteropolyadd compounds. Some anions react with molybdate and other ions in solution, yielding heteropolyacids of definite chemical composition. These heteropolyacid compounds are then usually extracted into an organic phase. The metal of the compound is determined by AAS either in the organic phase or in aqueous solution after back-extraction. 

This chemical cross-reference has been compiled by extracting information from chemistry textbooks, industrial references, and chemical formularies back to the early 1800 s. Equivalents, definitions, and cross-reference entries were loaded into our computer, sorted into alphabetical order, and then merged into one master cross-reference which follows. 

Here Zg is the number of tt electrons provided by atom is essentially an ionization potential for an electron extracted from in the presence of the part of the framework associated with atom r alone (a somewhat hypothetical quantity), is a framework resonance integral, and is the coulomb interaction between electrons in orbitals < >, and <(>,. The essential parameters, in the semi-empirical form of the theory, are cug, and and from their definition these quantities are expected to be characteristic of atom r or bond r—s, not of the particular molecule in which they occur (for a discussion see McWeeny, 1964). In the SCF calculation, solution of (95) leads to MO s from which charges and bond orders are calculated using (97) these are used in setting up a revised Hamiltonian according to (98) and (99) and this is put back into (95) which is solved again to get new MO s, the process being continued until self-consistency is achieved. It is now clear that prediction of the variation of the self-consistent E with respect to the parameters is a matter of considerable difficulty. 

Integrating liquid-liquid extraction and detection is far from easy, as reflected in the few attempts made so far. Many of the devices developed for this purpose fail to comply with the definition of sensor. Such is the case with continuous liquid-liquid extraction systems without phase separation, where programmed switching of the propulsion system (a peristaltic pump) allows the extracting phase to be passed iteratively by the detection point in a back-and-forth motion that enriches it gradually with the extracted species [9-11]. This type of system is much too Complex to be considered a sensor, though in addition, the extraction process is not completely simultaneous with detection. 

Mechanically Extracted Meals. Solvent extracted oilseed meals typically contain less than 1.5% residual fat unless the gums (hydrated phosphatides) or soapstock have been added back to the meal before the desolventizer-toaster or meal dryer. Mechanically extracted (expeller or screw-pressed) meals can contain 4—9% oil, which can be a significant calorie source in animal feeds. Fat contents of extracted meals are not part of the definition, although typical analyses are shown below. 

With fluids, we think of the pump as the source of pressure as well as the flow rate determining device. However, with supercritical fluids (in contrast to t3q)ical liquids), a pump needs a control point downstream to hmit the passage of molecules per unit time. This restriction then "holds-back" the previously unlimited flow of molecules to a definite, but not always pre-determined level. Ideally then, the restrictor serves to restrict the flow until the density of molecules distributed from the pump through the extraction region right up to the final restriction point in space is such that the operating density desired in the extraction zone is achieved. This is much easier to state in words than it is to achieve in actual experimental practice. This is especially true if you wish to achieve an experimental set of parameters and hold those values over a finite period of time (ranging from minutes to hours) and do it with the statistical precision and accuracy that are necessary to attain the final quantitative analytical results. 

Whatever the forum, the trend is to broaden the definition of the supply chain. One consensus definition holds that the supply chain is all that happens to a product from "dirt to dust." In this view, the supply chain begins with mining ores or growing crops, extracting raw material from Mother Earth. The chain goes on to a multitude of conversion and distribution processes that deliver the product to the end user. It ends with ultimate disposal — presumably back in Motiier Earth somewhere. 

---