Arsenic/ions/salts determination

The geometry and abolute configuration of the (—)5g,-tris(catechol)-arsenate ion have been determined in the potassium salt. The ion has normal octahedral tris-chelate geometry with As-O bonds averaging 1.84 A. The absolute configuration was also determined by the analysis of the c.d. spectrum and the result was corroborative. 

Antimony pyrogallate, Sb(C6H503). Antimony(III) salts in the presence of tartrate ions may be quantitatively predpitated with a large excess of aqueous pyrogallol as the dense antimony pyrogallate. The method fadlitates a simple separation from arsenic the latter element may be determined in the filtrate from the predpitation of antimony by direct treatment with hydrogen sulphide. 

The ability of metal ions to form complexes with formazans is utilized to determine these ions either directly (for low valent reducing ions) or indirectly in the presence of a reducing agent. Among others, molybdenum(VI) and vanadium(V) have been determined using this method.442,443 Indirect methods have been reported for the analyses of substances that do not reduce tetrazolium salts. Examples include arsenic in nickel ores436 and traces of selenium.437 A method for the extraction and analysis of a number of metal ternary ion association complexes has been described.444 - 448... 

Cano-Aguilera, I., Haque, N., Morrison, G.M. et al. (2005) Use of hydride generation-atomic absorption spectrometry to determine the effects of hard ions, iron salts and humic substances on arsenic sorption to sorghum biomass. Microchemical Journal, 81(1), 57-60. 

Often, greater accuracy may be obtained, as in Volhard type titration, by performing a back titration of the excess silver ions. In such a case, a measured amount of standard silver nitrate solution is added in excess to a measured amount of sample. The excess Ag+ that remains after it reacts with the analyte is then measured by back titration with standard potassium thiocyanate (KSCN). If the silver salt of the analyte ion is more soluble than silver thiocyanate (AgSCN), the former should be filtered off from the solution. Otherwise, a low value error can occur due to overconsumption of thiocyanate ion. Thus, for the determination of ions (such as cyanide, carbonate, chromate, chloride, oxalate, phosphate, and sulfide, the silver salts of which are all more soluble than AgSCN), remove the silver salts before the back titration of excess Ag.+ On the other hand, such removal of silver salt is not necesary in the Volhard titration for ions such as bromide, iodide, cyanate, thiocyanate, and arsenate, because the silver salts of these ions are less soluble than AgSCN, and will not cause ary error. In the determination of chloride by Volhard titration, the solution should be made strongly acidic to prevent interference from carbonate, oxalate, and arsenate, while for bromide and iodide analysis titration is carried out in neutral media. 

The most important application of the Volhard method is the indirect determination of halide ions. A measured excess of standard silver nitrate solution is added to the sample, and the excess silver is determined by back-titration with a standard thiocyanate solution. The strong acidic environment required for the Volhard procedure represents a distinct advantage over other titrimetric methods of halide analysis because such ions as carbonate, oxalate, and arsenate (which form slightly soluble silver salts in neutral media but not in acidic media) do not interfere. 

---