Combination tables aromatics

Grant et a/.397 examined the reactions of hydroxy radicals with a range of vinyl and a-methylvinyl monomers in organic media. Hydroxy radicals on reaction with AMS give significant yields of products from head addition, abstraction and aromatic substitution (Table 3.8) even though resonance and steric factors combine to favor "normal tail addition. However, it is notable that the extents of abstraction (with AMS and MMA) arc less than obtained with t-butoxy radicals and the amounts of head addition (with MMA and S) are no greater than those seen with benzoyloxy radicals under similar conditions. It is clear that there is no direct correlation between reaclion rale and low specificity. 

Further evidence to support the case for polycarbonates comes from the work of Kricheldorf and Lubbers [75]. They prepared several series of copolycarbonates of 4,4 -dihydroxybiphenyl and various other aromatic diols (Table 5). It is noteworthy that all their series of copolymers cease to exhibit a nematic phase when the MI 10.5. Hence by combining both sets of results it can be said that the critical value for polycarbonates lies between 10.1 and 10.5. 

The largest correlation times, and thus the slowest reorientational motion, were shown by the three C- Fl vectors of the aromatic ring, with values of between approximately 60 and 70 ps at 357 K, values expected for viscous liquids like ionic liquids. The activation energies are also in the typical range for viscous liquids. As can be seen from Table 4.5-1, the best fit was obtained for a combination of the Cole-Davidson with the Lipari-Szabo spectral density, with a distribution parame-... 

The ease of dehalogenation of C H X by Ni(ll)/ IMes HCl 1/NaO Pr decreased in the order 1 > Br > Cl F. Subsequent work showed that a 1 1 combination of Ni and NHC in the presence of NaOCHEt resulted in enhanced reactivity towards aryl fluorides [6], Again, the A-mesityl substituted ligand IMes HCl 1 imparted the highest level of catalytic activity. Table 8.2 illustrates that hydrodefluorination is sensitive to both the nature of the substituents on the aromatic ring and the specific regioisomer. Thus, 2- or 4-fluorotoluene (Table 8.2, entry 2) proceeded to only 30% conversion after 15 h, whereas quantitative conversion of 2-fluoroanisole (Table 8.2, entry 3) and high conversion of 3-fluoropyridine (Table 8.2, entry 5) was achieved in only 2-3.5 h. The reactivity of 2-fluoropyridine was compromised by more efficient nucleophilic aromatic substitution. 

So to a large extent, 1-D 13C NMR interpretation is a case of matching observed singlets to predicted chemical shifts. These predictions can be made by reference to one of the commercially available databases that we ve mentioned, or it can be done the hard way - by a combination of looking up reference spectra of relevant analogues and using tables to predict the shifts of specific parts of your molecule (e.g., aromatic carbons). We have included some useful 13C shift data at the end of the chapter but it is by necessity, very limited. 

The nmr analyses of the bottoms products given in Table IV show the material to have a large aliphatic content. The aromatic/aliphatic ratios of the fractions are higher than for the whole coal because of the presence of combined phenol reaction with Tetralin reduces these ratios considerably, presumably by transfer of much of this material to the solvent-range product, but some of it must remain in the bottoms as the aromatic/aliphatic ratio of the composite bottoms product from the fractions is higher than that from the whole coal. It was not possible to calculate the contribution that the diluents, excess solvent and combined phenol, made to the aromatic H, but the large monoaromatic content of the bottoms product must be due, in part, to these. 

A combination of a Diels-Alder and a Fisher carbene-cyclopentannulation is described as the last example in this subgroup. Thus, Barluenga and coworkers used a [4+2] cycloaddition of 2-amino-l,3-butadienes 4-115 with a Fischer alkoxy-arylalky-nylcarbene complex 4-116 this is followed by a cyclopenta-annulation reaction with the aromatic ring in 4-116 to give 4-117 (Scheme 4.25) [36]. An extension of this domino process is the reaction of 4-118 with 2equiv. of the alkynyl carbene 4-119 containing an additional C-C-double bond (Table 4.2) [37]. The final product 4-120, which was obtained in high yield, is formed by a second [4+2] cycloaddition of the primarily obtained cyclopenta-annulated intermediate. 

When naphtha or gas oil is cracked, imagine the limitless combinations possible. Naphthas are made up of molecules in the C5 to Cio range gas oils from Cio to perhaps C30 or C40. The structures include everything from simple paraffins (aliphacics) to complex polynuclear aromatics, so a-much wider range of possible molecules can form. Ethylene yields.froin..cracking naphtha or gas oil are much smaller than those from ethane or propane, as you can see from Table 5-1- But to compensate the plant operator, a full range of other hydrocarbons is produced as by-products also. 

By using l,6-diiodo-r,6 -biferrocenylene (I-Fc-Fc-I) instead of I-Fc-I, the corresponding polymer (PAE-Fc5, Table 3) is given. Also attempted was the polycondensation with a reverse-type combination of monomer Ll -diethynyl-ferrocene (=Fc=) and dihalo aromatic compound (X-Ar-X). This proved to... 

---