Aramid temperatures

Properties. As prepared, the polymer is not soluble in any known solvents below 200°C and has limited solubiUty in selected aromatics, halogenated aromatics, and heterocycHc Hquids above this temperature. The properties of Ryton staple fibers are in the range of most textile fibers and not in the range of the high tenacity or high modulus fibers such as the aramids. The density of the fiber is 1.37 g/cm which is about the same as polyester. However, its melting temperature of 285°C is intermediate between most common melt spun fibers (230—260°C) and Vectran thermotropic fiber (330°C). PPS fibers have a 7 of 83°C and a crystallinity of about 60%. 

The aramids are formed in the low temperature reaction, -10 to 60°C, of equimolar amounts of the diacid chloride and the diamine in an amide solvent, typically dimethyl acetamide (DMAc) or A/-meth5i-2-pyrrohdinone (NMP) and usually with a small amount of an alkaU or alkaline-earth hydroxide and a metal salt, such as LiOH [1310-65-2] LiCl, Ca(OH)2 [1305-62-0] or CaCl2 added to increase the solubiUty of the polymer and neutralize the hydrochloric acid generated in the reaction. 

Advanced materials can be used in extreme conditions, e.g., high temperatures (> 200°C), severe chemical environments (e.g., polytetrafluoroethylene (PTFE) with concentrated H2SO4). They are often used as a critical component in a workpiece and are frequently reinforced with glass, carbon or aramid (e.g., Kevlar ) fibres. 

The proposed model for creep rupture based on the condition of maximum shear strain and the Eyring reduced time model explain the observed relations concerning the lifetime of aramid, polyamide 66 and polyacrylonitrile fibres. However, with increasing temperatures, in particular above 300 °C, chemical degradation of PpPTA also determines the lifetime. Furthermore, the model... 

Nylon-4,6 was developed by DSM Engineering Plastics in 1990 and sold under the trade name Stanyl giving a nylon that has a higher heat and chemical resistance for the automotive industry and in electrical applications. It has a of 295°C and can be made more crystalline than nylon-6,6. A number of other nylons, such as the aromatic nylons and aramids, are strong and can operate at high temperatures, and they have good flame-resistant properties. 

A number of the polymers considered previously—polycarbonate, aramid, and polyary-late—were among the first commercial successes in the efforts to synthesize polymers with increasingly high use temperatures. In the following sections we will discuss some of the other commercially available heat-resistant polymers followed by a consideration of research efforts to move further up in the temperature scale. 

Addition poly(imide) oligomers are used as matrix resins for high performance composites based on glass-, carbon- and aramide fibers. The world wide market for advanced composites and adhesives was about 70 million in 1990. This amounted to approximately 30-40 million in resin sales. Currently, epoxy resins constitute over 90% of the matrix resin materials in advanced composites. The remaining 10% are unsaturated polyester and vinylester for the low temperature applications and cyanate esters and addition poly(imides) for high temperatures. More recently thermoplastics have become important and materials such as polyimides and poly(arylene ether) are becoming more competitive with addition polyimides. 

---