Aqueous reactions tris amine

DSG should be dissolved in an organic solvent prior to addition to an aqueous reaction medium. Suitable solvents include DMF and DMSO. To initiate a reaction, add an aliquot of the organic solution to the buffered medium containing the molecules to be crosslinked. Reaction buffers should not contain any competing amine compounds such as Tris or glycine,... 

ABNP is soluble in dimethylformamide (DMF) but insoluble directly in aqueous solution. Insulin labeling was done in DMF water at a ratio of 9 1. For molecules not soluble in organic solvent, such as proteins, the trifunctional first may be dissolved in DMF and a small aliquot added to an aqueous reaction medium. The nitrophenyl ester reactive group can be coupled to amine groups at alkaline pFI (7-9) and in buffers containing no extraneous amines (avoid Tris). Unfortunately, ABNP is not commercially available at the time of this writing. 

Dissolve the amine-dendrimer to be modified in DMF or buffer (50mM sodium borate, pH 8.5) at a concentration of at least lOmg/ml. Avoid the use of amine-containing buffers for an aqueous reaction, such as Tris or imidazole, as these will react with the... 

Cascade Blue diamine derivatives are soluble in aqueous solution. A concentrated stock solution may be prepared in water, dissolved quickly, and an aliquot immediately added to a buffered reaction medium. For aqueous reactions, 0.1M MES, pH 4.7-6.5, may be used to stabilize the pH during the coupling process. Avoid amine- or carboxylate-containing buffers such as Tris or glycine, since these can compete with the coupling reaction. 

Direct addition of ammonia to olefmic bonds would be an attractive method for amine synthesis, if it could be carried out smoothly. Like water, ammonia reacts with butadiene only under particular reaction conditions. Almost no reaction takes place with pure ammonia in organic solvents. The presence of water accelerates the reaction considerably. The reaction of aqueous ammonia (28%) with butadiene in MeCN in the presence orPd(OAc)i and PhjP at 80 C for 10 h gives tri-2,7-octadienylamine (47) as the main product, accompanied by a small amount of di-2,7-octadienylamine (46)[46,47], Isomeric branched... 

When the distribution coefficient for the desired solute from aqueous solutions into even the best of solvents is unfavourable it may become attractive to superimpose reaction. Consider the. separation of citric acid from aqueous solutions, for which physical extraction is unattractive. Here we can use a bulky tertiary amine, e.g. tri-2-ethylhexylamine, which has a very low solubility in water, and dissolve it in a suitable, water-insoluble solvent this will... 

Craig and co-workers247 reported the synthesis of l-aza-2,4,10-trithiaada-mantane (227) as a by-product in the reaction of ammonium dithiocarbamate with an aqueous solution of chloroacetaldehyde. The same compound is reported to be obtained by the reaction of mercaptoacetaldehyde with ammonia248 and then by the reaction of tri(2,2-bis(ethoxy)ethyl]amine (228) with hydrogen sulfide in the presence of hydrobromic acid.249 The... 

If an amine P-NH2 is used in the aqueous solution, one obtains RCONHP instead of RCOOH. Rates of cleavage of three acyl nitrophenyl esters were followed by the appearance of p-nitrophenolate ion as reflected by increased absorbances at 400 nm. The reaction was carried out at pH 9.0, in 0.02 M tris(hydroxymethyl)aminomethane buffer, at 25°C. Rate constants were determined from measurements under pseudo-first-order conditions, with the residue molarity of primary amine present in approximately tenfold excess. First-order rate graphs were linear for at least 80% of the reaction. With nitrophenyl acetate and nitrophenyl caproate, the initial ester concentration was 6.66xlO 5M. With nitrophenyl laur-ate at this concentration, aminolysis by polymer was too fast to follow and, therefore, both substrate and amine were diluted tenfold for rate measurements. 

Reaction of AMCA-NHS with proteins proceeds efficiendy in the pH range 7—9. Avoid buffers containing amines that can compete in the coupling reaction, such as Tris or glycine, and avoid imidazole buffers since they promote hydrolysis of the NHS ester. AMCA-NHS is relatively insoluble in aqueous buffers. The compound must be first dissolved in organic solvent prior to addition of a small aliquot to the reaction mixture. A concentrated stock solution may be prepared in DMSO and stored up to 2 weeks refrigerated or frozen without loss of activity. The solid and all solutions of AMCA-NHS should be protected from light to avoid photodecomposition of the fluorophore. 

---