Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Aqua-Wrap

The wet lay-up systems most commonly used in the industry are Aqua-Wrap, Armor Plate wrap, BlackDiamond wrap and StrongBack systems. [Pg.687]

Aqua-Wrap (California, US) is manufactured commercially in compliance with the US Department of Transportation (DOT). Aqua-Wrap (see Fig. 18.10) uses water-activated polyurethane resin, which cures in wet conditions and under water. Thus, it can be applied and fully cured in water. [Pg.687]

Advanced Waterproof Technologies (2005) AqauWrap pipeline repair (online). Available at http //ridwater.com/aqua-wrap.htm, retrieved October 2011. [Pg.702]

For a number of years the following desiccator method of corrosive tests was used at MPRI NASH [49-51,98]. Metallic samples in the form of plates 50 X 50 X 2 in size are wrapped in an inhibited film and placed into the desiccator inside which 98 2% relative air humidity is maintained by aqua solution of glycerin, and are subjected to cyclic heating-cooling. One cycle consists of the endurance of the samples in the same humidity at a temperature of 55 2°C for 8h and at a similar humidity and a temperature of 20 2°C for 16 h. The protective ability of the films is estimated by the corrosion resistance of metallic samples after 21 test cycles (Table 1.11). [Pg.70]


See other pages where Aqua-Wrap is mentioned: [Pg.687]    [Pg.687]    [Pg.721]    [Pg.95]   
See also in sourсe #XX -- [ Pg.687 ]




SEARCH



Aqua

Wrapping

Wraps

© 2024 chempedia.info