Anodized coatings

Titanium has potential use in desalination plants for converting sea water into fresh water. The metal has excellent resistance to sea water and is used for propeller shafts, rigging, and other parts of ships exposed to salt water. A titanium anode coated with platinum has been used to provide cathodic protection from corrosion by salt water. 

Because of limited commercial experience with anode coatings in membrane cells, commercial lifetimes have yet to be defined. Expected lifetime is 5—8 years. In some cases as of this writing (ca 1995), 10-years performance has already been achieved. Actual lifetime is dictated by the membrane replacement schedule, cell design, the level of oxygen in the chlorine gas, and by the current density at which the anode is operated. 

As a final step, anodized parts must be sealed to ensure corrosion resistance of the anodic coating. Sealing involves plugging the anodic pores completely so contaminants caimot reach the base metal. A variety of sealing methods are used by anodizers (see Sealants). 

Another method for preparing alkah bromates is by electrolysis of bromine in alkah solutions. Anodes coated with Pb02 are used and a small amount of dichromate is added to prevent reduction of BrO at the cathode (76). 

Dichromates and chromic acid are used as sealers or after-dips to improve the corrosion resistance of various coatings on metals. Eor example, phosphate coatings on galvani2ed iron or steel as well as sulfuric acid anodic coatings on aluminum can be sealed by hexavalent chromium baths. 

In aqueous chloride where it is necessary to use platinised titanium anodes coated over only part of their surface, e.g. titanium rod tipped with a thin platinum film, it may be necessary to limit the applied voltage to 12 V. 

The major electrochemical reaction at the anode surface is oxygen and chlorine evolution coupled with oxidation of the active carbon to carbon dioxide. Eventually all the carbon is removed from the anode coating and this allows perforation of the copper conductor leading to ultimate anode failure. 

In atmospheric exposure to industrial environments its corrosion rate is only about one-third that of zinc and the corrosion reaction is stifled by the tenacious oxide which is produced nevertheless it can frequently function as an anodic coating both for steel and for the less corrosion-resistant aluminium alloys. 

Hardness It is not possible to obtain a reliable figure for the hardness of anodic coatings with either the indentation or scratch methods, because of the influence of the relatively soft metal beneath the anodic film, and the presence of a soft outer layer on thick films. On Moh s Scale, the hardness of normal anodic films lies between 7 and 8, i.e. between quartz and topaz. 

A similar improvement in expectation of life for thin anodic coatings has... 

---