Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Hydrophobic anchor

The L and the M subunits are firmly anchored in the membrane, each by five hydrophobic transmembrane a helices (yellow and red, respectively, in Figure 12.14). The structures of the L and M subunits are quite similar as expected from their sequence similarity they differ only in some of the loop regions. These loops, which connect the membrane-spanning helices, form rather flat hydrophilic regions on either side of the membrane to provide interaction areas with the H subunit (green in Figure 12.14) on the cytoplasmic side and with the cytochrome (blue in Figure 12.14) on the periplasmic side. The H subunit, in addition, has one transmembrane a helix at the car-boxy terminus of its polypeptide chain. The carboxy end of this chain is therefore on the same side of the membrane as the cytochrome. In total, eleven transmembrane a helices attach the L, M, and H subunits to the membrane. [Pg.236]

Hydrophobic-tailed tetramers Abundant form in the mammalian CNS. Anchored to plasma membranes by a hydrophobic, 20 kDalton length polypeptide subunit named PRiMA (Proline-Rich Membrane Anchor). [Pg.359]

Rieske proteins are constituents of the be complexes that are hydro-quinone-oxidizing multisubunit membrane proteins. All be complexes, that is, bci complexes in mitochondria and bacteria, b f complexes in chloroplasts, and corresponding complexes in menaquinone-oxidizing bacteria, contain three subunits cytochrome b (cytochrome 6e in b f complexes), cytochrome Ci (cytochrome f in b(,f complexes), and the Rieske iron sulfur protein. Cytochrome 6 is a membrane protein, whereas the Rieske protein, cytochrome Ci, and cytochrome f consist of water-soluble catalytic domains that are bound to cytochrome b through a membrane anchor. In Rieske proteins, the membrane anchor can be identified as an N-terminal hydrophobic sequence (13). [Pg.86]

The pecM gene encodes a protein of 297 amino acids with a calculated molecular mass of 32 kDa. The predicted PecM protein displays the characteristics of an integral membrane protein since it is largely hydrophobic, with potential trans-membrane domains. SubceUular firactionation confirmed that PecM is anchored into the bacterial inner membrane whereas PecS is... [Pg.325]

The intramembranous part of the molecule may consist of 8-10 hydrophobic transmembrane helices (Mi-Mio) that anchor the Ca -ATPase to the lipid bilayer and form the transmembrane channel for the passage of (Fig. 2). [Pg.68]

Fig. 3.5 Representation of a scheme of an experiment (upper set of drawings) and the obtained experimental results presented as AFM images (middle part) and cross-sectional profiles (bottom) that provides evidence of silica nucleation and shell formation on biopolymer macromolecules. Scheme of experiment. This includes the following main steps. 1. Protection of the mica surface against silica precipitation. It was covered with a fatty (ara-chidic) acid monolayer transferred from a water substrate with the Langmuir-Blodgett technique. This made the mica surface hydrophobic because of the orientation of the acid molecules with their hydrocarbon chains pointing outwards. 2. Adsorption of carbohydrate macromolecules. Hydrophobically modified cationic hydroxyethylcellulose was adsorbed from an aqueous solution. Hydrocarbon chains of polysaccharide served as anchors to fix the biomacromolecules firmly onto the acid monolayer. 3. Surface treatment by silica precursor. The mica covered with an acid mono-... Fig. 3.5 Representation of a scheme of an experiment (upper set of drawings) and the obtained experimental results presented as AFM images (middle part) and cross-sectional profiles (bottom) that provides evidence of silica nucleation and shell formation on biopolymer macromolecules. Scheme of experiment. This includes the following main steps. 1. Protection of the mica surface against silica precipitation. It was covered with a fatty (ara-chidic) acid monolayer transferred from a water substrate with the Langmuir-Blodgett technique. This made the mica surface hydrophobic because of the orientation of the acid molecules with their hydrocarbon chains pointing outwards. 2. Adsorption of carbohydrate macromolecules. Hydrophobically modified cationic hydroxyethylcellulose was adsorbed from an aqueous solution. Hydrocarbon chains of polysaccharide served as anchors to fix the biomacromolecules firmly onto the acid monolayer. 3. Surface treatment by silica precursor. The mica covered with an acid mono-...

See other pages where Hydrophobic anchor is mentioned: [Pg.210]    [Pg.210]    [Pg.19]    [Pg.543]    [Pg.149]    [Pg.260]    [Pg.271]    [Pg.271]    [Pg.272]    [Pg.316]    [Pg.714]    [Pg.723]    [Pg.2]    [Pg.311]    [Pg.335]    [Pg.359]    [Pg.922]    [Pg.1059]    [Pg.125]    [Pg.112]    [Pg.45]    [Pg.371]    [Pg.506]    [Pg.528]    [Pg.93]    [Pg.744]    [Pg.34]    [Pg.602]    [Pg.814]    [Pg.521]    [Pg.548]    [Pg.101]    [Pg.212]    [Pg.21]    [Pg.21]    [Pg.25]    [Pg.41]    [Pg.206]    [Pg.191]    [Pg.325]    [Pg.271]    [Pg.160]    [Pg.114]    [Pg.862]    [Pg.315]   
See also in sourсe #XX -- [ Pg.112 , Pg.114 , Pg.115 ]




SEARCH



© 2024 chempedia.info