Amines chemoselectivity

Hydroxylysine (328) was synthesized by chemoselective reaction of (Z)-4-acet-oxy-2-butenyl methyl carbonate (325) with two different nucleophiles first with At,(9-Boc-protected hydroxylamine (326) under neutral conditions and then with methyl (diphenylmethyleneamino)acetate (327) in the presence of BSA[202]. The primary allylic amine 331 is prepared by the highly selective monoallylation of 4,4 -dimethoxybenzhydrylamine (329). Deprotection of the allylated secondary amine 330 with 80% formic acid affords the primary ally-lamine 331. The reaction was applied to the total synthesis of gabaculine 332(203]. 

Sodium cyanoborohydride is remarkably chemoselective. Reduction of aldehydes and ketones are, unlike those with NaBH pH-dependent, and practical reduction rates are achieved at pH 3 to 4. At pH 5—7, imines (>C=N—) are reduced more rapidly than carbonyls. This reactivity permits reductive amination of aldehydes and ketones under very mild conditions (42). 

Many procedures for the formation of carboxylic acid amides are known in the literature. The most widely practiced method employs carboxylic acid chlorides as the electrophiles which react with the amine in the presence of an acid scavenger. Despite its wide scope, this protocol suffers from several drawbacks. Most notable are the limited stability of many acid chlorides and the need for hazardous reagents for their preparation (thionyl chloride, oxalyl chloride, phosgene etc.) which release corrosive and volatile by-products. Moreover, almost any other functional group in either reaction partner needs to be protected to ensure chemoselective amide formation.2 The procedure outlined above presents a convenient and catalytic alternative to this standard protocol. 

The field of alkaloid synthesis via tandem cyclizations favors the application of (TMSlsSiH over other radical-based reagents, due to its very low toxicity and high chemoselectivity. For example, cyclization of the iodoarylazide 102, mediated by (TMSlsSiH under standard experimental conditions, produced the N-Si(TMS)3 protected alkaloid 103 that after washing with dilute acid afforded the amine 104 in an overall 83% yield from 102 (Reaction 81). ° The formation of the labile N-Si(TMS)3 bond was thought to arise from the reaction of the product amine 104 with the by-product (TMSlsSil. The skeletons of ( )-horsfiline, ( )-aspidospermidine and (+ )-vindoline have been achieved by this route. - ... 

Alternatively, Ballini devised a new strategy to synthesize tri-alkylated pyrroles from 2,5-dialkylfurans and nitroalkanes <00SL391>. This method involves initial oxidation of 2,5-dimethylfuran with magnesium monoperoxyphthalate to cA-3-hexen-2,5-dione (6). Conjugate addition of the nitronate anion derived from the nitro compound 7 to 6 followed by chemoselective hydrogenation of the C-C double bond of the resulting enones 8 (obtained by elimination of nitrous acid from the Michael adduct) completes the conversion to the alkylated y-diketones 9. Final cyclization to pyrroles 10 featured improved Paal-Knorr reaction conditions involving reaction of the diketones with primary amines in a bed of basic alumina in the absence of solvent. 

In summary, the research effort aimed towards active, chemoselective hydrogenations of certain C=0 and C=N bonds have delivered several catalysts that approach the level of activity required for use in the synthesis of alcohols and amines. However, other classes of substrate require considerable additional investigations to be conducted before homogeneous catalysts may be considered for this purpose. 

Burk et al. showed the enantioselective hydrogenation of a broad range of N-acylhydrazones 146 to occur readily with [Et-DuPhos Rh(COD)]OTf [14]. The reaction was found to be extremely chemoselective, with little or no reduction of alkenes, alkynes, ketones, aldehydes, esters, nitriles, imines, carbon-halogen, or nitro groups occurring. Excellent enantioselectivities were achieved (88-97% ee) at reasonable rates (TOF up to 500 h ) under very mild conditions (4 bar H2, 20°C). The products from these reactions could be easily converted into chiral amines or a-amino acids by cleavage of the N-N bond with samarium diiodide. 

The use of a chemical mediator can alter the chemoselectivity of an electrochemical reaction. In the reaction illustrated in Scheme 2, -methylstyrene was oxidized using both direct electrolysis and mediated conditions [10]. The current density, amount of charge passed, temperature, and other variables were all kept constant. The only difference was the addition of 6.4 mole percent of tris(4-bomophenyl)amine to the mediated reaction. The direct electrolysis tended to afford the product of a four-electron oxidation (7). When 3.5 F mole of electricity was passed, a 55% yield of (7) was obtained along with a 45% yield of (6). With additional current (6.4 F mole ), a 75% yield of (7) was obtained. The mediated process led to a preponderance of the product from the two-electron oxidation. When 3.5 F mole of electricity was passed in the experiment using the triarylamine mediator, a 93% yield of (6) was obtained along with only 6% of the four-electron oxidation product. 

Electrocatalytic hydrogenation has the advantage of milder reaction conditions compared to catalytic hydrogenation. The development of various electrode materials (e.g., massive electrodes, powder cathodes, polymer film electrodes) and the optimization of reaction conditions have led to highly selective electrocatalytic hydrogenations. These are very suitable for the conversion of aliphatic and aromatic nitro compounds to amines and a, fi-unsaturated ketones to saturated ketones. The field is reviewed with 173 references in [158]. While the reduction of conjugated enones does not always proceed chemoselectively at a Hg cathode, the use of a carbon felt electrode coated with polyviologen/Pd particles provided saturated ketones exclusively (Fig. 34) [159]. 

These results represent the first ever reported evidence of strict cooperation between the steric requisites of the faujasite catalyst and the reactivity of an asymmetrical carbonate, in simultaneously inducing high methyl chemoselectivity and mono-A-methylselectivity for primary amines. 

At first glance this inversion of the monomer ratio seems to be logical and simple, but it is not. In the first reaction step, as described in Fig. 1, the advantage of the chemoselectivity of the anhydride reacting with the secondary amine is used to obtain AB2 monomers. If an excess of anhydride is used, this selectivity is lost and not only amides but also esters are formed. From the synthesis of... 

---