Amine light stabilisers determination

Oligomeric hindered amine light stabilisers, such as Tinuvin 622 and Chimassorb 944, resist satisfactory analysis by conventional HPLC and have required direct UV spectroscopic analysis of a polyolefin extract [596], PyGC of an extract [618,648], or SEC of an extract [649]. Freitag et al. [616] determined Tinuvin 622 in LDPE, HDPE and PP by saponification of the polymer dissolution in hot toluene via addition of an... 

NMR spectroscopy is most effective in qualitative analysis when the samples examinated are substantially pure compounds and has been used to confirm the theoretically predicted low-energy conformations of the Af-acylated hindered amine light stabiliser Tinuvin 440 [210]. Trace amounts of PDMS (quantification limit 0.1 ppm) in plastic additives, dyes and pigments were determined by 111 NMR after Soxhlet extraction [211]. ll NMR was also used for the detection of octadecanol, an impurity in Irganox PS 802 (3,3 -dioctadecyl thiodipropionate). NMR has identified the nature of a supposedly UV stabiliser of empirical formula C17H18N3CIO [44] (Scheme 5.2). 

The anti-oxidant itself is often consumed in performing its function, although hindered amine light stabilisers (HALS) are self-regenerating. Depending on the polymer, their concentration in the polymer may vary from a few parts per million (e.g., in PE) to several per cent (e.g., in ABS, natural rubber). Because it is impossible to determine all the polymer down-stream end uses, nearly all have food contact approval. 

This method was applied to the determination of organotin catalysts, e.g., dibutyl tin dilaurate, stablisers, e.g., Cyanox 1790, a hindered phenol antioxidant and Tinuvin 292, a hindered amine light stabiliser (HALS) and reactive diluents (such as aliphatic epoxides, epichlorohydrin, vernonial oil and so on) in acrylate resins. 

HPLC of polymer extracts has been used to determine dilauryl dithiopropionate, Irganox 1076 and distearyl-dithiopropionate in polyolefins [18], amine antioxidants and antiozonates in rubbers [16], Irganox 1076, Irganox 1010 and BHT in PE [19] and miscellaneous antioxidants, light stabilisers in polyolefins [20,21] and Santonox R, Ethanox 736, CAO-5, Irganox 1035, Irganox 259 and Topanol [22] in polyolefins and also the determination of antioxidants and accelerators in vulcanised rubber formulations [23-25]. 

GC is extensively used to determine phenolic and amine antioxidants, UV light absorbers, stabilisers and organic peroxide residues, in particular in polyolefins, polystyrene and rubbers (cf. Table 61 of Crompton [158]). Ostromow [159] has described the quantitative determination of stabilisers and AOs in acetone or methanol extracts of rubbers and elastomers by means of GC. The method is restricted to analytes which volatilise between 160 °C and 300 °C without decomposition. A selection of 47 reports on GC analysis of AOs in elastomers (period 1959-1982) has been published... 

---