Amidation asymmetric

In the case of A-benzoylaniline complex 71, the chiral lithium amide asymmetric induction was found to be dependent upon the substituent group on the IV-acyl part of the chromium complex. Thus for EX = BnCl, (R)-21 resulted in higher enantioselectivity than (R,R)-3 (Scheme 52)92. This was attributed to an equilibrium between the trans- and c -rotamers of the amide. 

Industrial Synthetic Improvements. One significant modification of the Stembach process is the result of work by Sumitomo chemists in 1975, in which the optical resolution—reduction sequence is replaced with a more efficient asymmetric conversion of the meso-cyc. 02Lcid (13) to the optically pure i7-lactone (17) (Fig. 3) (25). The cycloacid is reacted with the optically active dihydroxyamine [2964-48-9] (23) to quantitatively yield the chiral imide [85317-83-5] (24). Diastereoselective reduction of the pro-R-carbonyl using sodium borohydride affords the optically pure hydroxyamide [85317-84-6] (25) after recrystaUization. Acid hydrolysis of the amide then yields the desired i7-lactone (17). A similar approach uses chiral alcohols to form diastereomic half-esters stereoselectivity. These are reduced and direedy converted to i7-lactone (26). In both approaches, the desired diastereomeric half-amide or half-ester is formed in excess, thus avoiding the cosdy resolution step required in the Stembach synthesis. 

The chiral naphthyloxazoline substrates can also be employed in asymmetric carbon-heteroatom bond-forming reactions with lithium amides, which provide unusual... 

The [2 + 2] cycloaddition reaction of A -benzyl-l,4-dihydropyridine 34b with acrylonitrile, followed by catalytic reduction gave two pairs of diastereoisomeric amides 36 and 37 with a low diastereomeric excess, probably due to the large distance between the asymmetric center and the site of acrylonitrile attack. Compounds 36 and 37 were resolved into the four individual diastereoisomers (ca 5% for compound 36 and 15% for 37) [97JCR(M)321], Irradiation of 1,4-dibenzyl-1,4,5,6-tetrahydropyridine 38 in the presence of 29 gave two stereoisomers. 

The reaction of diacetylene and its asymmetric homologs (penta-l,3-diyne, hexa-1,3-diyne) with semicarbazide (72ZOR2605) affords the amides of 3-methyl-pyrazole- 1-carboxylic acid (27) (80°C, EtONa, EtOH, 40 h). Amide 26 undergoes irreversible rearrangement to amide 27 at 80°C (EtONa, EtOH). 

The synthesis of key intermediate 6 begins with the asymmetric synthesis of the lactol subunit, intermediate 8 (see Scheme 3). Alkylation of the sodium enolate derived from carboximide 21 with allyl iodide furnishes intermediate 26 as a crystalline solid in 82 % yield and in >99 % diastereomeric purity after recrystallization. Guided by transition state allylic strain conformational control elements5d (see Scheme 4), the action of sodium bis(trimethylsilyl)amide on 21 affords chelated (Z)-enolate 25. Chelation of the type illustrated in 25 prevents rotation about the nitrogen-carbon bond and renders... 

A key step in the synthesis of the spiroketal subunit is the convergent union of intermediates 8 and 9 through an Evans asymmetric aldol reaction (see Scheme 2). Coupling of aldehyde 9 with the boron enolate derived from imide 8 through an asymmetric aldol condensation is followed by transamination with an excess of aluminum amide reagent to afford intermediate 38 in an overall yield of 85 % (see Scheme 7). During the course of the asymmetric aldol condensation... 

The synthesis of the polyol glycoside subunit 7 commences with an asymmetric aldol condensation between the boron enolate derived from imide 21 and a-(benzyloxy)acetaldehyde (24) to give syn adduct 39 in 87 % yield and in greater than 99 % diastereomeric purity (see Scheme 8a). Treatment of the Weinreb amide,20 derived in one step through transamination of 39, with 2-lithiopropene furnishes enone 23 in an overall yield of 92 %. To accomplish the formation of the syn 1,3-diol, enone 23 is reduced in a chemo- and... 

There have been two general approaches to the direct asymmetric epoxidation of carbonyl-containing compounds (Scheme 1.2) ylide-mediated epoxidation for the construction of aryl and vinyl epoxides, and a-halo enolate epoxidation (Darzens reaction) for the construction of epoxy esters, acids, amides, and sulfones. 

In general sulfur ylide-mediated epoxidation cannot be used to form an epoxide with an adjacent anion-stabilizing group such as an ester, as the requisite ylide is too stable and does not react with aldehydes [23], With the less strongly electron-withdrawing amide group, however, the sulfur ylide possesses sufficient reactivity for epoxidation. The first example of an asymmetric version of this reaction was by... 

More recently, the same group has used a simpler and more easily prepared chiral ammonium phase-transfer catalyst 99 derived from BINOL in asymmetric Darzens reactions with a-halo amides 97 to generate glycidic tertiary amides 98 (Table 1.13). Unfortunately the selectivities were only moderate to low [48]. As mentioned in Section 1.2.3.1, tertiary amides can be converted to ketones. 

A-Acido imines (R R"C = N —X=0) like /V-acyl (X = CR) /V-sulfonyl [X = S(R)=0]2-7 or /V-diphenylphosphinoylimines [X = P(C6H5)2]3 are masked inline derivatives of ammonia. Compared to the imines themselves these activated derivatives are better electrophiles showing less tendency to undergo undesired deprotonation rather than addition of organometal-lics1812 The apparent advantages of these compounds have been exploited for asymmetric syntheses of amines, amides, amino acids and /J-lactams1-8 I6. 

Substantially high diastereoselectivity was accomplished by the conjugate addition of Grignard reagents to the amide 1 derived from 1-ephedrine32. The reagent attacked from the Re-face of the double bond, as shown in 2, via a chelated intermediate. Low asymmetric induction was observed when butyllithium was used instead of butylmagnesium bromide. 

The original procedure for the trifluoroacetylation of amino acids used trifluoroacetic anhydride [Acetic acid, trifluoro-, anhydride].4 This reagent, although inexpensive and readily available, has certain disadvantages it is a highly reactive compound and thus has caused undesired reactions such as the cleavage of amide or peptide bonds,5 unsymmetrical anhydrides are formed between the newly formed A-trifluoroacetylamino acids and the by-product trifluoroacetic acid, and excess trifluoroacetic anhydride has caused racemization of asymmetric centers. 

Reaction of p-nitrophenyl 2-(p-tolylsulfinyl)acetate 161 with aryl aldimines in the presence of imidazole was found to give /j-lactams 162 and amides 163206. In the cyclization, only the two 3,4-trans derivatives were formed out of a possible four diastereomeric pairs and, interestingly, the ratio of two diastereomeric pairs went up to 6.7 1. This means not only that internal asymmetric induction207 affords the trans derivative, but that also a relatively high asymmetric induction took place during the reaction. 

Biocatalysts have received great attention in these last few years. Due to their capacity to perform asymmetric transformations under mild conditions [78], they have been useful tools for synthesizing optically active organic molecules. They promote a variety of chemical transformations, including the syntheses of esters and amides and oxidations, reductions, eliminations and carbon carbon forming. Little is known about biocatalyst-promoted Diels Alder reactions. 

Using a chiral auxiliary via the amide" or ester" leads to asymmetric induction. 

An asymmetric synthesis of 1-aryltetrahydroisoquinolines 79 from chiral amide 78 was reported <96TL(37)4369>. Optically active cis- or rranj-1,3-disubstituted tetrahydro-isoquinolines can he prepared hy a modification of this procedure. 

---