Aluminum oxide mechanical properties

Quantifying the effect of surface roughness or morphology is difficult, however. Surface preparations that provide different degrees of surface roughness also usually produce surfaces that have different oxide thicknesses and mechanical properties, different compositions, or different contaminant levels. The problem of separation of these variables was circumvented in a recent study [52] by using a modified microtome as a micro milling machine to produce repeatable, well-characterized micron-sized patterns on clad 2024-T3 aluminum adherends. Fig. 2 shows the sawtooth profile created by this process. 

Molten Carbonate Fuel Cell The electrolyte in the MCFC is a mixture of lithium/potassium or lithium/sodium carbonates, retained in a ceramic matrix of lithium aluminate. The carbonate salts melt at about 773 K (932°F), allowing the cell to be operated in the 873 to 973 K (1112 to 1292°F) range. Platinum is no longer needed as an electrocatalyst because the reactions are fast at these temperatures. The anode in MCFCs is porous nickel metal with a few percent of chromium or aluminum to improve the mechanical properties. The cathode material is hthium-doped nickel oxide. 

Most structural PMCs consist of a relatively soft matrix, such as a thermosetting plastic of polyester, phenolic, or epoxy, sometimes referred to as resin-matrix composites. Some typical polymers used as matrices in PMCs are listed in Table 1.28. The list of metals used in MMCs is much shorter. Aluminum, magnesium, titanium, and iron- and nickel-based alloys are the most common (see Table 1.29). These metals are typically utilized due to their combination of low density and good mechanical properties. Matrix materials for CMCs generally fall into fonr categories glass ceramics like lithium aluminosilicate oxide ceramics like aluminnm oxide (alnmina) and mullite nitride ceramics such as silicon nitride and carbide ceramics such as silicon carbide. 

Although few applications have so far been found for ceramic matrix composites, they have shown considerable promise for certain military applications, especially in the manufacture of armor for personnel protection and military vehicles. Historically, monolithic ("pure") ceramics such as aluminum oxide (Al203), boron carbide (B4C), silicon carbide (SiC), tungsten carbide (WC), and titanium diboride (TiB2) have been used as basic components of armor systems. Research has now shown that embedding some type of reinforcement, such as silicon boride (SiBg) or silicon carbide (SiC), can improve the mechanical properties of any of these ceramics. 

Fareed, A.S., Sonuparlak, B., Lee, C.T., Fortini, A.J., Schiroky, G.H. (1990), Mechanical properties of 2-D Nicalon fiber-reinforced LANXIDE aluminum oxide and aluminum nitride matrix composites , Ceram. Eng. Sci. Proc., 11(7-8), 782-794. 

Metal-metal eutectics have been studied for many years due to their excellent mechanical properties. Recently, oxide-oxide eutectics were identified as materials with potential use in photonic crystals. For example, rodlike micrometer-scaled microstructures of terbium-scandium-aluminum garnet terbium-scandium per-ovskite eutectics have been solidified by the micro-pulling-down method (Pawlak et al., 2006). If the phases are etched away, a pseudohexagonally packed dielectric periodic array of pillars or periodic array of pseudohexagonally packed holes in the dielectric material is left. 

---