5-Allyl thiolates, synthesis

We shall end this section with a beautiful illustration of an intramolecular 1,3-dipolar cycloaddition of a nitrile oxide that was used in the synthesis ofthe vitamin biotin. Starting at the beginning of the synthesis will allow you to revise some reactions from earlier chapters. The starting material is a simple cyclic allylic bromide that undergoes an efficient 5 2 reaction with a sulfur nucleophile. In fact, we don t know (or care ) whether this is an 5 2 or S 2 reaction as the product of both reactions is the same. This sort of chemistry was discussed in Chapter 23 if you need to check up on it. Notice that it is the sulfur atom that does the attack—it is the soft end of the nucleophile and better at Sn2 reactions. The next step is the hydrolysis ofthe ester group to reveal the thiolate anion. 

Salt metathesis [Eq. (7)] is a well-established route in the synthesis of a variety of alkaline-earth metal alkyls [186,208-210], allyls [211-214], benzylates [149,178], cyclopentadienides [17, 108, 215-219], pentadienyls [220], fluorenyls [17, 221], indenyls [222], amides [112, 113, 223], p-diketiminates [112], guanidinates [15, 194], aUcoxides [224], aryloxides [224], silanides [210, 225-228], thiolates [229], phosphanides [230, 231], selenolates [229], and germanides [232, 233]. However, the route has been rarely used for the synthesis of more reactive alkyl and aryl metal complexes, largely due to issues pertaining to ether cleavage chemistry as metathesis typically requires the presence of an ethereal solvent. 

The concentration of zinc accelerator-thiolate complexes in the rubber is not the only factor determining the balance of the two reactions in NR. Both the rate of desulfuration of polysulfide crosslinks and the rate of their thermal decomposition depend upon the positions of attachment of the sulfur chains to the backbone rubber chains and the detailed structure of the hydrocarbon at the ends of the crosslinks. In the course of normal accelerated vulcanization there are three different positions of attack on the polyisoprene backbone two of these are methylene groups in the main chain (labelled d and a in 3), and the third is the side chain methyl group (labelled b in 3). Direct analysis of the distribution of the sites of attack cannot yet be made on actual rubber vulcanizates, and information has had to be obtained solely by sulfuration of the model alkene 2-methyl-2-pentene and, more recently, 2,6-dimethyl-2,6-octadiene. The former (4) models the a-methylic site but only one of the two a-methylenic sites of polyisoprene the latter (5) models all three sites, but at the present time these are not all supported by the synthesis of relevant sulfides. Because allylic rearrangements are common in subsequent reactions of the sulfurated rubber, sulfur substituents appear not only on allylic carbon atoms but on isoallylic carbon atoms. Thus, from 2-methyl-2-pentene, the groups shown in Scheme 2 are formed. 

---