Alkenes Sharpless asymmetric

Aminohydroxylation of Alkenes. Sharpless asymmetric aminohydroxylation (AA) allows for the catalytic and enantios-elective symthesis of protected vicinal aminoalcohols in a single step. This reaction is significant as it applies to the synthesis of a wide variety of biologically active agents and natural products. For example, new monoterpene /3-amino alcohols can effectively be synthesized from (+)-2-carene, (+)-3-carene, (—)-/3-pinene, and... 

Further variations on the epoxyketone intermediate theme have been reported. In the first (Scheme 9A) [78], limonene oxide was prepared by Sharpless asymmetric epoxidation of commercial (S)-(-)- perillyl alcohol 65 followed by conversion of the alcohol 66 to the crystalline mesylate, recrystallization to remove stereoisomeric impurities, and reduction with LiAlH4 to give (-)-limonene oxide 59. This was converted to the key epoxyketone 60 by phase transfer catalyzed permanganate oxidation. Control of the trisubstituted alkene stereochemistry was achieved by reaction of the ketone with the anion from (4-methyl-3-pentenyl)diphenylphosphine oxide, yielding the isolable erythro adduct 67, and the trisubstituted E-alkene 52a from spontaneous elimination by the threo adduct. Treatment of the erythro adduct with NaH in DMF resulted... 

More recently, in light of the development of the Sharpless asymmetric dihydroxylation protocol [20], we have approached the synthesis of diols such as 14 (Scheme 2) from the alkene. Thus, treatment of the alkenyl D-glucosides 15 vmder the conditions of the Sharpless dihydroxylation gave a range of diols 16 with varying diastereoisomeric excesses (Table 1). One of these mixtures of diols, upon recrystallization, yielded the pure diastereoisomer, namely the diol 14. This procedure now gives a very rapid and efficient entry into one of the precursor diols for the synthesis of the optically-pure epoxides [21]. 

It was of obvious interest to prepare the inhibitors 60 as their pure dia-stereoisomers, 66 and 67. Following on from our successful treatment of alkenyl D-glucosides under Sharpless asymmetric dihydroxylation conditions [21], we treated the alkenes 64 with the a-AD - and AD -mLxes - the results are summarized in Table 2. In no case did we ever obtain a satisfactory diastereo-isomeric excess of the diol 68 over the diol 69, or vice versa. A similar lack of stereoselectivity was also obtained with the triol 70 and the amine 71 [48]. 

Transformation of alkene 9 into diol 30 is a Sharpless asymmetric dihydroxylation.8 Its catalytic cycle with K3Fe(CNV, as co-oxidant is shown below. 

Once this and the principle of stereocontrol of Sharpless asymmetric dihydroxylations is understood it is clear that both cis- and /ra/ ,v-disubsti luted alkenes allow for two orientations in the transition state. See for yourself by explicitly writing down the corresponding dihydroxylations according to the general format laid out in Figure 17.21 (part II) based on cis-... 

Hie first of Sharpless s reactions is an oxidation of alkenes by asymmetric epoxidation. You met vanadium as a transition-metal catalyst for epoxidation with r-butyl hydroperoxide in Chapter 33, and this new reaction makes use of titanium, as titanium tetraisopropoxide, Ti(OiPr)4, to do the same thing. Sharpless surmised that, by adding a chiral ligand to the titanium catalyst, he might be able to make the reaction asymmetric. The ligand that works best is diethyl tartrate, and the reaction shown below is just one of many that demonstrate that this is a remarkably good reaction. 

The reaction was also successful for substituted salicylaldehydes. When Jacobsen came to develop his asymmetric epoxidation, which, unlike the Sharpless asymmetric epoxidation, works for simple alkenes and not just for allylic alcohols, he chose salens as his catalysts, partly because they could be made so easily from salicylaldehydes. For example ... 

Jacobsen epoxidation turned out to be the best large-scale method for preparing the cis-amino-indanol for the synthesis of Crixivan, This process is very much the cornerstone of the whole synthesis. During the development of the first laboratory route into a route usable on a very large scale, many methods were tried and the final choice fell on this relatively new type of asymmetric epoxidation. The Sharpless asymmetric epoxidation works only for allylic alcohols (Chapter 45) and so is no good here. The Sharpless asymmetric dihydroxylation works less well on ris-alkenes than on trans-alkenes, The Jacobsen epoxidation works best on cis-alkenes. The catalyst is the Mn(III) complex easily made from a chiral diamine and an aromatic salicylaldehyde (a 2-hydroxybenzaldehyde). 

The Sharpless asymmetric dihydroxylation works best for tram disubstituted alkenes, while the Jacobsen epoxidation works best for cis disubstituted alkenes. Even in this small area, there is a need for better and more general methods. Organic chemistry has a long way to go. 

Figure 2.19 Oxygen transfer to the alkene using the Kalsuki-Sharpless asymmetric epoxidation system.

The aminocyclitol moiety was synthesized in a stereocontrolled manner from cis-2-butene-l,4-diol (Scheme 40)112 by conversion into epoxide 321 via Sharpless asymmetric epoxidation in 88% yield.111 Oxidation of 321 with IBX, followed by a Wittig reaction with methyl-triphenylphosphonium bromide and KHMDS, produced alkene 322. Dihydroxylation of the double bond of 322 with OSO4 gave the diol 323, which underwent protection of the primary hydroxyl group as the TBDMS ether to furnish 324. The secondary alcohol of 324 was oxidized with Dess-Martin periodinane to... 

Sharpless and co-workers first reported the aminohydroxyIation of alkenes in 1975 and have subsequently extended the reaction into an efficient one-step catalytic asymmetric aminohydroxylation. This reaction uses an osmium catalyst [K20s02(OH)4], chloramine salt (such as chloramine T see Chapter 7, section 7.6) as the oxidant and cinchona alkaloid 1.71 or 1.72 as the chiral ligand. For example, asymmetric aminohydroxylation of styrene (1.73) could produce two regioisomeric amino alcohols 1.74 and 1.75. Using Sharpless asymmetric aminohydroxylation, (IR)-N-ethoxycarbonyl-l-phenyl-2-hydroxyethylamine (1.74) was obtained by O Brien et al as the major product and with high enantiomeric excess than its regioisomeric counterpart (R)-N-ethoxycarbonyl-2-phenyl-2-hydroxyethylamine (1.75). The corresponding free amino alcohols were obtained by deprotection of ethyl carbamate (urethane) derivatives. 

Asymmetric epoxidation The catalytic asymmetric epoxidation of alkenes has been the focus of many research efforts over the past two decades. The non-racemic epoxides are prepared either by enantioselective oxidation of a prochiral carbon-carbon double bond or by enantioselective alkylidenation of a prochiral C=0 bond (e.g. via a ylide, carbene or the Darzen reaction). The Sharpless asymmetric epoxidation (SAE) requires allylic alcohols. The Jacobsen epoxidation (using manganese-salen complex and NaOCl) works well with ds-alkenes and dioxirane method is good for some trans-alkenes (see Chapter 1, section 1.5.3). 

Asymmetric dihydroxylation Sharpless developed a catalytic system (AD-mix- 3 or AD-mix-a) that incorporates a chiral ligand into the oxidizing mixture which can be used for the asymmetric dihydroxylation of alkenes. The chiral ligands used in Sharpless asymmetric dihydroxylation are quinoline alkaloids, usually dihydroquinidine (DHQD) or dihydroquinine (DHQ) linked by a variety of heterocyclic rings such as 1,4-phthalhydrazine (PHAL) or pyridazine (PYR) (see section 1.6, reference 32 of Chapter 1). 

Aminohydroxylation of unsymmetrically substituted alkenes, in contrast to dihydroxylation, may give two possible regioisomers of aminoalcohol derivatives but asymmetric aminohydroxylation, by using the same catalytic system as that used for Sharpless asymmetric dihydroxylation, can be highly regioselective as well as enantioselective. 

The Sharpless asymmetric epoxidation is an enantioselective reaction that oxidizes alkenes to epoxides. Only the double bonds of allylic alcohols—that is, alcohols having a hydroxy group on the carbon adjacent to a C=C —are oxidized in this reaction. 

An asymmetric route affording a low yield of 3-carboxysultam 281 (R = R = R = H) has been described (see Section 4.05.7.3). As intermediate, compound 429 is prepared through intramolecular ring opening of the epoxide 428 obtained by Sharpless asymmetric epoxidation of the corresponding alkene <2000JOC7690>. 

The hrst of Sharpless s reactions is an oxidation of alkenes by asymmetric epoxidation. You met vanadium as a transition-metal catalyst for epoxidation with f-butyl hydroperoxide in Chapter 33,... 

Starting with geraniol (126), Sharpless asymmetric epoxidation [68] proceeded in 95% yield and with 93% ee (see Scheme 29) [69]. Hydrobromination of the alkene was achieved under standard conditions using NBS in THF and water (5 1) to afford a 64% yield of diastereomeric bromo alcohols (127). Cyclization to the tetrahydropyran diol was accomplished by treating 127 with camphorsulphonic acid in diethyl ether, followed by diol cleavage with sodium periodate to give a mixture of aldehydes 128 and 129. Upon... 

---