Alkenes allylic radical bromination

This allylic bromination with NBS is analogous to the alkane halogenation reaction discussed in the previous section and occurs by a radical chain reaction pathway. As in alkane halogenation, Br- radical abstracts an allylic hydrogen atom of the alkene, thereby forming an allylic radical plus HBr. This allylic radical then reacts with Br2 to yield the product and a Br- radical, which cycles back... 

In addition to its effect on stability, delocalization of the unpaired electron in the allyl radical has other chemical consequences. Because the unpaired electron is delocalized over both ends of the nr orbital system, reaction with Br2 can occur at either end. As a result, allylic bromination of an unsymmetrical alkene often leads to a mixture of products. For example, bromination of 1-octene gives a mixture of 3-bromo-l-octene and l-bromo-2-octene. The two products are not formed in equal amounts, however, because the intermediate allylic radical is... 

Simple alkyl halides can be prepared by radical halogenation of alkanes, but mixtures of products usually result. The reactivity order of alkanes toward halogenation is identical to the stability order of radicals R3C- > R2CH- > RCH2-. Alkyl halides can also be prepared from alkenes by reaction with /V-bromo-succinimide (NBS) to give the product of allylic bromination. The NBS bromi-nation of alkenes takes place through an intermediate allylic radical, which is stabilized by resonance. 

When the allylic cation reacts with Br to complete the electrophilic addition, reaction can occur either at Cl or at C3 because both carbons share the positive charge (Figure 14.4). Thus, a mixture of 1,2- and 1,4-addition products results. (Recall that a similar product mixture was seen for NBS bromination of alkenes in Section 10.4, a reaction that proceeds through an allylic radical.)... 

Radical addition of HBr to an alkene depends upon the bromine atom adding in the first step so that the more stable radical is formed. If we extend this principle to a conjugated diene, e.g. buta-1,3-diene, we can see that the preferred secondary radical will be produced if halogenation occurs on the terminal carbon atom. However, this new radical is also an allylic radical, and an alternative resonance form may be written. 

When chlorination or bromination of alkenes is carried out in the gas phase at high temperature, addition to the double bond becomes less significant and substitution at the allylic position becomes the dominant reaction.153-155 In chlorination studied more thoroughly a small amount of oxygen and a liquid film enhance substitution, which is a radical process in the transformation of linear alkenes. Branched alkenes such as isobutylene behave exceptionally, since they yield allyl-substituted product even at low temperature. This reaction, however, is an ionic reaction.156 Despite the possibility of significant resonance stabilization of the allylic radical, the reactivity of different hydrogens in alkenes in allylic chlorination is very similar to that of alkanes. This is in accordance with the reactivity of benzylic hydrogens in chlorination. 

Novel results were reported for allylic bromination. In radical bromination of cyclohexene in CCI4 under light the selectivity of substitution over addition was shown to be controlled by bromine concentration.304 Substitution via the corresponding allyl radical, while relatively slow, is irreversible and fast enough to maintain the concentration of bromine at a sufficiently low level to prevent significant addition. The reaction of two strained alkenes, fZ)-1,2-dimethyl-1,2-di-ferf-butylethylene and the -isomer (14), leads to the corresponding bromosubstituted product, instead of addition 305... 

Allylic bromination normally uses NBS as bromine itself would add to the alkene. Thus cyclohexene gives the dibromide 18 with Br2 but the allylic bromide with NBS. Bromine radicals abstract one of the marked H atoms from 19 and the intermediate allylic radical 21 is delocalised so we don t know which end of the allylic system5 ends up attached to Br. 

An allyl radical can be brominated at both termini of the radical. This is why two allyl bromides can result from the Wohl-Ziegler bromination of an alkene if the allyl radical intermediate is unsymmetrical (examples see Figures 1.29-1.31). Even more than two allyl bromides may form. This happens if the substrate possesses constitutionally different allylic H atoms, and if, as a result thereof, several constitutionally isomeric allyl radicals form and react with bromine without selectivity. 

The bromination depicted in Figure 1.29 proceeds via an unsymmetrical allyl radical. This radical preferentially (80 20) reacts to yield the bromination product with the more highly substituted C=C double bond. As this reaction proceeds under kinetic control, the selectivity is based on product development control the more stable (since higher alkylated) alkene is formed more rapidly than the isomer. 

The bromination shown in Figure 1.30 also proceeds via an unsymmetrical allyl radical intermediate, and the bromination product with the aryl-substituted C=C double bond is formed exclusively. Since this process, too, is under kinetic control, the selectivity is again due to product development control the alkene isomer, which is strongly favored because of conjugation, is formed so much faster than the non-conjugated isomer that the latter is not observed at all. 

Fig. 1.30. In some cases the allyl radical intermediate of Wohl-Ziegler brominations is available from alkene double bond isomers, which can profitably be used when one of the substrates is more easily accessible or cheaper than its isomer.

Although free-radical halogenation is a poor synthetic method in most cases, free-radical bromination of alkenes can be carried out in a highly selective manner. An allylic position is a carbon atom next to a carbon-carbon double bond. Allylic intermediates (cations, radicals, and anions) are stabilized by resonance with the double bond, allowing the charge or radical to be delocalized. The following bond dissociation enthalpies show that less energy is required to form a resonance-stabilized primary allylic radical than a typical secondary radical. 

The amide N-H may also be halogenated, oxidized and nitrosated. A -Bromosuccinimide (NBS), like a number of other iV-halo compounds, readily undergoes a radical fission to give a bromine radical. This provides a useful reagent for radical bromination at, for example, allylic or benzylic positions. In the presence of acid, NBS is also a mild source of the halonium ion, which is used for the addition of hypobromous acid (Scheme 3.74) to alkenes or for the bromination of reactive aromatic rings. 

Alkenes undergo radical halogenation at the allylic positions. NBS is used for radical bromination at the allylic position (Section 9.5). 

Because radical brominations are so selective, they can be used successfully in the laboratory to make alkyl bromides. There are relatively few ways of functionalizing an unfunctionalized centre, and radical allylic bromination is one of the most effective. We introduced this reaction in Chapter 24, where we contrasted the radical reactivity of Bt2 towards alkenes (leading to an allyl bromide by hydrogen abstraction) with its ionic reactivity (leading to addition of bromine across the alkene). We can now look in a little more detail at the selectivities involved. 

---