Aldol reaction, reverse

Utilization of the chiral promotor (i )-l-2-[(A -naphthylamino)methyl]pyrrolidine (140) in this aldol reaction reverses the diastereoselectivity, so that all four possible optically active... 

The higjily water-soluble dienophiles 2.4f and2.4g have been synthesised as outlined in Scheme 2.5. Both compounds were prepared from p-(bromomethyl)benzaldehyde (2.8) which was synthesised by reducing p-(bromomethyl)benzonitrile (2.7) with diisobutyl aluminium hydride following a literature procedure2.4f was obtained in two steps by conversion of 2.8 to the corresponding sodium sulfonate (2.9), followed by an aldol reaction with 2-acetylpyridine. In the preparation of 2.4g the sequence of steps had to be reversed Here, the aldol condensation of 2.8 with 2-acetylpyridine was followed by nucleophilic substitution of the bromide of 2.10 by trimethylamine. Attempts to prepare 2.4f from 2.10 by treatment with sodium sulfite failed, due to decomposition of 2.10 under the conditions required for the substitution by sulfite anion. 

This cleavage is a retro aldol reaction It is the reverse of the process by which d fruc tose 1 6 diphosphate would be formed by aldol addition of the enolate of dihydroxy acetone phosphate to d glyceraldehyde 3 phosphate The enzyme aldolase catalyzes both the aldol addition of the two components and m glycolysis the retro aldol cleavage of D fructose 1 6 diphosphate... 

Cleavage reactions of carbohydrates also occur on treatment with aqueous base for prolonged periods as a consequence of base catalyzed retro aldol reactions As pointed out m Section 18 9 aldol addition is a reversible process and (3 hydroxy carbonyl com pounds can be cleaved to an enolate and either an aldehyde or a ketone... 

For the other broad category of reaction conditions, the reaction proceeds under conditions of thermodynamic control. This can result from several factors. Aldol condensations can be effected for many compounds using less than a stoichiometric amount of base. Under these conditions, the aldol reaction is reversible, and the product ratio will be determined by the relative stability of the various possible products. Conditions of thermodynamic control also permit equilibration among all the enolates of the nucleophile. The conditions that permit equilibration include higher reaction temperatures, protic solvents, and the use of less tightly coordinating cations. 

The ratio of products 15 and 16 is dependent on the structures, base, and the solvent. The kinetics of the reaction is likewise dependant on the structures and conditions of the reaction. Thus addition or cyclization can be the rate-determining step. In a particularly noteworthy study by Zimmerman and Ahramjian, it was reported that when both diastereomers of 20 were treated individually with potassium r-butoxide only as-epoxy propionate 21 was isolated. It is postulated that the cyclization is the rate-limiting step. Thus, for these substrates, the retro-aldolization/aldolization step reversible. ... 

The aldol reaction as well as the dehydration are reversible. In order to obtain the desired product, the equilibrium might have to be shifted by appropriate reaction conditions (see below). 

Various competitive reactions can reduce the yield of the desired Michael-addition product. An important side-reaction is the 1,2-addition of the enolate to the C=0 double bond (see aldol reaction, Knoevenagel reaction), especially with a ,/3-unsaturated aldehydes, the 1,2-addition product may be formed preferentially, rather than the 1,4-addition product. Generally the 1,2-addition is a kinetically favored and reversible process. At higher temperatures, the thermodynamically favored 1,4-addition products are obtained. 

Aldehydes and ketones with an a hydrogen atom undergo a base-catalyzed carbonyl condensation reaction called the aldol reaction. For example, treatment of acetaldehyde with a base such as sodium ethoxide or sodium hydroxide in a protic solvent leads to rapid and reversible formation of 3-hydroxybutanal, known commonly as aldol (aidehyde + alcohol), hence the general name of the reaction. 

Aldol reactions, Like all carbonyl condensations, occur by nucleophilic addition of the enolate ion of the donor molecule to the carbonyl group of the acceptor molecule. The resultant tetrahedral intermediate is then protonated to give an alcohol product (Figure 23.2). The reverse process occurs in exactty the opposite manner base abstracts the -OH hydrogen from the aldol to yield a /3-keto alkoxide ion, which cleaves to give one molecule of enolate ion and one molecule of neutral carbonyl compound. 

Problem 23.2 Using curved arrows to indicate the electron flow in each step, show how the base-catalyzed reverse aldol reaction of 4-hydroxy-4-methyi-2-pentanone takes place to yield 2 equivalents of acetone. 

The selectivity observed in the intramolecular aldol reaction of 2,5-hexanedione is due to the fact that all steps in the mechanism are reversible, so an... 

Fructose, a /3-hydroxy ketone, is then cleaved into two three-carbon molecules—one ketone and one aldehyde—by a reverse aldol reaction. Still further carbonyl-group reactions then occur until pyruvate results. 

The aldol reaction is a carbonyl condensation that occurs between two aldehyde or ketone molecules. Aldol reactions are reversible, leading first to a /3-hydroxy aldehyde or ketone and then to an cr,/6-unsaturated product. Mixed aldol condensations between two different aldehydes or ketones generally give a mixture of all four possible products. A mixed reaction can be successful, however, if one of the two partners is an unusually good donor (ethyl aceto-acetate, for instance) or if it can act only as an acceptor (formaldehyde and benzaldehyde, for instance). Intramolecular aldol condensations of 1,4- and 1,5-diketones are also successful and provide a good way to make five-and six-inembered rings. 

By this concept, a reversible enzymatic aldol reaction generates a mixture of l-threo/erythro aldol diastereomers (133) from which the i-threo isomer is preferentially decomposed by an irreversible decarboxylation to furnish aromatic aminoalcohol (R)-(134) vhth 78% ee in high yield. 

Lewis-Acid Catalyzed. Recently, various Lewis acids have been examined as catalyst for the aldol reaction. In the presence of complexes of zinc with aminoesters or aminoalcohols, the dehydration can be avoided and the aldol addition becomes essentially quantitative (Eq. 8.97).245 A microporous coordination polymer obtained by treating anthracene- is (resorcinol) with La(0/Pr)3 possesses catalytic activity for ketone enolization and aldol reactions in pure water at neutral pH.246 The La network is stable against hydrolysis and maintains microporosity and reversible substrate binding that mimicked an enzyme. Zn complexes of proline, lysine, and arginine were found to be efficient catalysts for the aldol addition of p-nitrobenzaldehyde and acetone in an aqueous medium to give quantitative yields and the enantiomeric excesses were up to 56% with 5 mol% of the catalysts at room temperature.247... 

Zinc-containing compounds have also been used as catalyst. Recently, Trost et al. reported asymmetric aldol reactions of methyl ynones 331 with pyruvaldehyde ketals 330 in the presence of a dinuclear zinc catalyst 329 generated from ZnEt2 and a pentadentate 0,N,0,N,0-ligand (328, Scheme 168).428 This reaction is a unique case of enantioselective autoinduction with product incorporation into the catalyst and a reversal of the absolute configuration. 

Now, we examine the interaction of chiral aldehyde (-)-96 with chiral enolate (S )-lOOb. This aldol reaction gives 104 and 105 in a ratio of 104 105 > 100 1. Changing the chirality of the enolate reverses the result Compound 104 and 105 are synthesized in a ratio of 1 30 (Scheme 3-38).66 The two reactions (—)-96 + (S )-lOOb and (—)-96 + (7 )-100b are referred to as the matched and mismatched pairs, respectively. Even in the mismatched pair, stereoselectivity is still acceptable for synthetic purposes. Not only is the stereochemical course of the aldol reaction fully under control, but also the power of double asymmetric induction is clearly illustrated. 

Three tactical approaches were surveyed in the evolution of our program. As outlined in Scheme 2.7, initially the aldol reaction (Path A) was performed direcdy between aldehyde 63 and the dianion derived from tricarbonyl 58. In this way, it was indeed possible to generate the Z-lithium enolate of 58 as shown in Scheme 2.7 which underwent successful aldol condensation. However, the resultant C7 P-hydroxyl functionality tended to cyclize to the C3 carbonyl group, thereby affording a rather unmanageable mixture of hydroxy ketone 59a and lactol 59b products. Lac-tol formation could be reversed following treatment of the crude aldol product under the conditions shown (Scheme 2.7) however, under these conditions an inseparable 4 1 mixture of diastereomeric products, 60 (a or b) 61 (a or b) [30], was obtained. This avenue was further impeded when it became apparent that neither the acetate nor TES groups were compatible with the remainder of the synthesis. 

---