Acrolein coordination

The acrolein coordinated with catalyst then gives an acyl radical by abstracting its aldehyde hydrogen. In the general oxidation of aldehydes, the acyl radical is considered to be discontinuing coordination with catalyst, as was described by Bawn (3) and Hoare and Waters (17). However, in the acrolein oxidation, the acyl radical formed by hydrogen abstraction may not conform to this proposal, as described below. 

Note that the illustrated conformation has the acrolein oriented in an 5-cis conformation. This is in contrast to the usual 5-trans conformation of acroleins coordinated to a Lewis acid (Figure 6.13a), but it is supported by the fact that cyclo-pentadiene adds to the opposite face of acrolein itself [216]. It is likely that both s-cis and 5-trans dienophile conformers are present, and that the -cis conformer is more reactive. In other words, Curtin-Hammett kinetics [235] are operative. The rationale for this increased reactivity is as follows the j-trans conformation of 2-bromoacrolein would place the bromine above the indene ring. Cycloaddition to the top (Si) face of the 5-trans conformer would force the bromine into closer proximity to the indene as C2 rehybridizes from sp2 to sp3, a situation that is avoided in cycloaddition to the top (Re) face of the 5-cis conformer. 

Through the DPT calculations, a mechanism for the Pt(0)-catalyzed borylation of acrolein was proposed (Scheme 10), which involves oxidative addition of diboron reagents, acrolein insertion into the Pt-B bond, acrolein coordination, and reductive elimination [106]. A similar mechanism has also been proposed for the Pt(0)-catalyzed borylation of methylacrylate (Scheme 11) [106]. 

The coordination of the dienophile to a Lewis acid (in the calculations a proton was used as the Lewis acid) leads also to an increase in regioselectivity. The re-gioselectivity of reactions of electron-rich, or conjugated dienes, with electron-deficient dienophiles is also controlled hy the diene HOMO-dienophile LUMO interaction. From Fig. 8.2 it appears that the difference in magnitudes of the LUMO coefficients at carhon atoms 1 and 2 of acrolein (Ci -C2 = 0.20) is smaller than the same difference for protonated acrolein (Ci -C2 = 0.30-0.43) so that the reaction of the latter should he considerable more regioselective than the former in accordance with the experimental results [3]. 

The carbo-Diels-Alder reaction of acrolein with butadiene (Scheme 8.1) has been the standard reaction studied by theoretical calculations in order to investigate the influence of Lewis acids on the reaction course and several papers deal with this reaction. As an extension of an ab-initio study of the carbo-Diels-Alder reaction of butadiene with acrolein [5], Houk et al. investigated the transition-state structures and the origins of selectivity of Lewis acid-catalyzed carbo-Diels-Alder reactions [6]. Four different transition-state structures were considered (Fig. 8.4). Acrolein can add either endo (N) or exo (X), in either s-cis (C) or s-trans (T), and the Lewis acid coordinates to the carbonyl in the molecular plane, either syn or anti to the alkene. 

The chiral catalyst 142 achieves selectivities through a double effect of intramolecular hydrogen binding interaction and attractive tt-tt donor-acceptor interactions in the transition state by a hydroxy aromatic group [88]. The exceptional results of some Diels-Alder reactions of cyclopentadiene with substituted acroleins catalyzed by (R)-142 are reported in Table 4.21. High enantio- and exo selectivity were always obtained. The coordination of a proton to the 2-hydroxyphenyl group with an oxygen of the adjacent B-0 bond in the nonhelical transition state should play an important role both in the exo-endo approach and in the si-re face differentiation of dienophile. 

The partial oxidation of propylene occurs via a similar mechanism, although the surface structure of the bismuth-molybdenum oxide is much more complicated than in Fig. 9.17. As Fig. 9.18 shows, crystallographically different oxygen atoms play different roles. Bridging O atoms between Bi and Mo are believed to be responsible for C-H activation and H abstraction from the methyl group, after which the propylene adsorbs in the form of an allyl group (H2C=CH-CH2). This is most likely the rate-determining step of the mechanism. Terminal O atoms bound to Mo are considered to be those that insert in the hydrocarbon. Sites located on bismuth activate and dissociate the O2 which fills the vacancies left in the coordination of molybdenum after acrolein desorption. 

Ammonia also reacts with the acrolein intermediate, via the formation of an imine or possibly oxime intermediate which transforms faster to the acrylonitrile than to the acrylamide intermediate. This pathway of reaction occurs at lower temperatures in comparison to that involving an acrylate intermediate, but its relative importance depends on the competitive reaction of the acrolein intermediate with the ammonia species and with catalyst lattice oxygens. NH3 coordinated on Lewis sites also inhibits the activation of propane differently from that absorbed on Brsurface reaction network in propane ammoxidation. 

As described in the preceding sections, many domino reactions start with the formation of vinyl palladium species, these being formed by an oxidative addition of vinylic halides or triflates to Pd°. On the other hand, such an intermediate can also be obtained from the addition of a nucleophile to a divalent palladium-coordinated allene. Usually, some oxidant must be added to regenerate Pd11 from Pd° in order to achieve a catalytic cycle. Lu and coworkers [182] have used a protonolysis reaction of the formed carbon-palladium bond in the presence of excess halide ions to regenerate Pd2+ species. Thus, reaction of 6/1-386 and acrolein in the presence of Pd2+ and LiBr gave mainly 6/1-388. In some reactions 6/1-389 was formed as a side product (Scheme 6/1.98). 

A number of examples have been reported documenting the use of palladium phosphine complexes as catalysts. The dialkyl species [PtL2R2] (L2 = dmpe, dppe, (PMe3)2 R = Me, CH2SiMe3) catalyze the reaction of [PhNH3]+ with activated alkenes (acrylonitrile, methyl acrylate, acrolein).176 Unfunctionalized alkenes prove unreactive. The reaction mechanism is believed to proceed via protonation of Pt-R by the ammonium salt (generating PhNH2 in turn) and the subsequent release of alkane to afford a vacant coordination site on the metal. Coordination of alkene then allows access into route A of the mechanism shown in Scheme 34. Protonation is also... 

In fact, a mechanism for this reaction can be drawn that does not involve Pd at all, but let s assume that Pd is required for it to proceed. Cl- must be nucleophilic. It can add to Cl of the alkyne if the alkyne is activated by coordination to Pd(II). (Compare Hg-catalyzed addition of water to alkynes.) Addition of Cl- to an alkyne-Pd(II) complex gives a o-bound Pd(II) complex. Coordination and insertion of acrolein into the C2-Pd bond gives a new a-bound Pd(II) complex. In the Heck reaction, this complex would undergo P-hydride elimination, but in this case the Pd enolate simply is protonated to give the enol of the saturated aldehyde. 

Fig. 10.6. 3D structure of the open complex between acrolein and Me(ethynyl)CuLI LiCI, with Me20 coordinated to each lithium atom (B3LYP/631 A). Bond lengths are in angstroms. 

The ene reaction is strongly catalyzed by Lewis acids such as aluminum chloride and diethylaluminum chloride204 Coordination by the aluminum at the carbonyl group increases the electrophihcity of the conjugated system and allows reaction to occur below room temperature, as illustrated in Entry 6. Intramolecular ene reactions can be carried out under either thermal (Entry 3) or catalyzed (Entry 7) conditions 205 Formaldehyde in acidic solution can form allylic alcohols, as in entry 1. Other carbonyl ene reactions are carried out with Lewis acid catalysts. Aromatic aldehydes and acrolein undergo the ene reaction with activated alkenes such as enol ethers in the presence of Yb(fod)3 206 Sc(03SCF3)3 has also been used to catalyze ene reactions.207... 

The stoichiometric interaction of an enyne and [RuCl(PCy3)(pcymene)]B(Ar )4 XVIIIa containing a bulky non-coordinating anion B(ArF)4 showed by NMR at —30 ° C the formation of the alkenyl alkylidene ruthenium complex and acrolein. This formation could be understood by the initial formation of a vinylidene intermediate and transfer of a hydride from the oxygen a-carbon atom to the electrophilic vinylidene carbon, as a retroene reaction step (Scheme 8.13) [54]. 

The liquid-phase oxidation of acrolein (AL), the reaction products, their routes of formation, reaction in the absence or presence of catalysts such as acetylacetonates (acac) and naphthenates (nap) of transition metals and the influence of reaction factors were discussed in an earlier paper (22). The coordinating state of cobalt acetylacetonate in the earlier stage of the reaction depends on the method of addition to the reaction system (25, 26). The catalyst, Co(acac)2-H20-acrolein, which was synthesized by mixing a solution of Co(acac)2 in benzene with a saturated aqueous solution, decreases the induction period of oxygen uptake and increases the rate of oxygen absorption. The acrolein of the catalyst coordinated with its cobalt through the lone pair of electrons of the aldehyde oxygen. Therefore, it is believed that the coordination of acrolein with a catalyst is necessary to initiate the oxidation reaction (10). 

In the liquid-phase oxidation of acrolein, the metal ion with higher valence coordinates acrolein to produce an acyl radical by hydrogen abstraction. 

The acyl radical formed from acrolein, maintaining its coordination with a catalyst, may react preferably with oxygen, rather than decompose to produce carbon monoxide, though it is generally believed that a free acyl radical is formed after the abstraction of aldehyde hydrogen by a metal. In such a case, the catalyst metal is considered as behaving as a mononuclear, not a binuclear complex. The molecular weight of the catalyst recovered from the oxidation solution was measured (Table V). 

---