Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About
0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | a | b | c | d | e | f | g | h | i | j | k | l | m | n | o | p | q | r | s | t | u | v | w | x | y | z

   |<      <<      >>     > |    


Typical yields with Co-ThO -MgO-kieselguhr catalyst at 1 atm. and 7 atm.

Typical Z-scan measurement setup.

Typical z-scan spectra of 2 for 4-ns pulse train with about 0.06 mW input power for

Typical ZEBRA cell design.

Typical Zeneca patents.

Typical zeolite pore sizes compared to the diameter of various molecules.

Typical zero-field Mossbauer spectra

Typical zero-field-cooled and field-cooled dc magnetization of a Hg-1223 film.

Typical zero-order and corresponding second-derivative electronic absorption spectra of ethanol-reconstituted lipid chloroform extracts of autoxidized model polyunsaturated fatty-acid compounds and inflammatory synovial fluid obtained after untreated rheumatoid knee-joint synovial fluid.

Typical Zimm plot for an alternating copolymer of ethylene and tetrafluoioethylene in diisobutyl adipate at 240 C

Typical Zimm plot for an alternating copolymer of ethylene and tetrafluoroethylene in diisobutyl adipate at 240 C

Typical Zimm plot for thermally sensitive and biocompatible poly in water at 25 C.

Typical Zimm plot the slope of Kc As g versus c for 0 0 gives the value of the second virial coefficient .

Typical zinc-chlorine cell

Typical Zintl clusters as building block candidates for the construction of porous semiconductors

Typical ZnO-TFT characteristics with the channel layer deposited at room temperature by rf magnetron sputtering, for a TFT with a width-to-length ratio of 1.4. Output characteristics for a ZnO-TFT. The saturation was about 230 pA under a gate bias of 40 V. The ZnO-TFT exhibits hard saturation, evidenced by the flatness of slope of each Ids curve, for large Vds- The dashed line represents the saturation drain current that follows an exponential dependence on the voltage.

Typical ZOI test result

Typical zone plan located adjacent to a fire panel

Typical zones on a extruder screw

Typical —V curve in H F and nonfluoride, nonalkaline solutions.

Typical, 3C spin-lattice relaxation times toluene-d8, 35 C. All measurements at 25.2 MHz.

Typical, although not frequent, ECG pattern in

Typical, Circular Dichroism Spectra of D-Glycosiduronic Acids. Left

Typical, effective monodentate ligands

Typical, fictitious pressure den-sification plots developing during high-pressure agglomeration Chapter 13.3, ref. 147



   |<      <<      >>     > |    

SEARCH



© 2024 chempedia.info