Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About
0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | a | b | c | d | e | f | g | h | i | j | k | l | m | n | o | p | q | r | s | t | u | v | w | x | y | z

   |<      <<      >>     > |    


Typical, fictitious pressure densification plots developing during high-pressure agglomeration Chapter 13.3, ref. 147

Typical. isotherms for various electrolytes of the reduced activity coefficients vs. the total ionic strength

Typical13C chemical shifts of selected fulgides in CDC13

TypicalarrangementofBerstorffgearmixingelementsassembledonaZE90A twin-screw extruder

Typicalbeam-gas or crossed molecular beam apparatus, with one or two tuneable lasers LIF observation of both reagents and products is prepared, at 45 to the particle laserbeam axes

Typicalfingering patterns formed by air .

Typically , the intramolecular exchange of Re and Si complexes is several times faster than the dissociation to reform the solvate complex.

Typically a minimum of 3 cores for each case are used for 0.6 mm cores.

Typically asymmetric membrane cross-sectional structures.

Typically deep, sharp-sided pits usually found under disbonded coatings or hard accumulations on a pipe surface. When disturbed the area may smell of hydrogen sulfide, a telling sign of microbial activity.

Typically enter via fresh water.

Typically observed morphology of block copolymers as the composition Is varied

Typically observed voltage-current characteristic curve for PEC ceii. Js a short-circuit photocurrent Voc- a open circuit photovoltage FF

Typically observed vs. T diagram of the second order transition.

Typically strain-tune curves of viscoelastic polymer fibers under constant stress.

Typically the mirrors are fabricated using a Bragg dielectric stack consisting of multilayers of dielectrics with different indices of refraction, , stacked alternately with high and low indices of refraction for several cycles. The thickness of each layer is chosen so that a quarter-wavelength of the light that is to be filtered fits in the gap

Typically the unit cell preamplifier integrates signal charge throughout the integration time. Integration time starts with the release of reset and ends when the signal is sampled.

Typically used basic proton solvents and monomers for poly acid membrcuies

Typically, a good model is formed when at least 99.9 of the variance in the data has been accounted for in the factors. For this data set, this occurs at 7 factors, although it is difficult to see in this plot.

Typically, a scientist using ISIS works with ISIS Draw and ISIS Base at the desktop level and manipulates search results in popular programs such as spreadsheets

Typically, class A products comprise 80 per cent of sales value taken on just 20 per cent of orders. They tend to be more standardised, have lower forecast errors and lower volume variation. Lean logistics methods are therefore often appropriate. Class B products, on the other hand, are often subject to higher forecast errors, and have higher volume variations. They tend to be better served by agile approaches.

Typically, foams can be categorized as short-lived systems where film rupture is described as a spinodal decomposition , reproduced with permission from lOP publishing limited

Typically, from 200 to 1000 such measurements are made, depending on the design of the scanner, at equally spaced angular intervals in order to generate one CT slice.

TypicalTOFspectrafortheD atom produced inthereactionOH D2 — HOD D.AdaptedfromStrazisar etal. Science, 2000,290

TypicalU02 Ceramic Fuel Pellets



   |<      <<      >>     > |    

SEARCH



© 2024 chempedia.info