Z-chloride

Fig. 6.36. Mechanism of the preparation of a Z-protected amino acid by acylation of an amino acid with Z-chloride.

Cl—C(=0)—Cl, which is a gas, because both reagents are very poisonous. As the substitution product one obtains chloroformic acid benzyl ester A, which is also called Z-chloride. ... 

Various heteroatom nucleophiles carry out an SN reaction at the carboxyl carbon of Z-chloride (whereby they displace a chloride ion). The most important nucleophiles of this type are amino acids. They give rise to benzyloxycarbonyl-protected amino acids (Z-protected amino acids Figure 6.29).They are standard components for peptide synthesis (cf. Figure 6.26). 

Z>) Toluene-p-sulphonylotion (p. 247). Proceed as in 3(a), but using 1 5 g of toluene-p-sulphonyl chloride, either finely pow dered or in concentrated acetone solution. Note. The sulphonyl derivative of a primary amine is soluble in aqueous sodium hydroxide, and the final solution must be diluted and acidified to precipitate the product. Recrystallise and take the m.p. (M.ps., pp. 550-551.)... 

To a solution of 0.30 mol of ethyllithium (note 1) in about 270 ml of diethyl ether (see Chapter II, Exp. 1) v/as added 0.30 mol of methoxyallene at -20°C (see Chapter IV, Exp. 4) at a rate such that the temperature could be kept between -15 and -2Q°C. Fifteen minutes later a mixture of 0.27 mol of >z-butyl bromide and 100 ml of pure, dry HMPT ivas added in 5 min with efficient cooling, so that the temperature of the reaction mixture remained below 0°C. The cooling bath was then removed and the temperature was allowed to rise. After 4 h the brown reaction mixture was poured into 200 ml of ice-water. The aqueous layer was extracted twice with diethyl ether. The combined solutions were washed with concentrated ammonium chloride solution (which had been made slightly alkaline by addition of a few millilitres of aqueous ammonia, note 2) and dried over potassium carbonate. After addition of a small amount (2-5 ml) of... 

Chiral 2-oxazolidones are useful recyclable auxiliaries for carboxylic acids in highly enantioselective aldol type reactions via the boron enolates derived from N-propionyl-2-oxazolidones (D.A. Evans, 1981). Two reagents exhibiting opposite enantioselectivity ate prepared from (S)-valinol and from (lS,2R)-norephedrine by cyclization with COClj or diethyl carbonate and subsequent lithiation and acylation with propionyl chloride at — 78°C. En-olization with dibutylboryl triflate forms the (Z)-enolates (>99% Z) which react with aldehydes at low temperature. The pure (2S,3R) and (2R,3S) acids or methyl esters are isolated in a 70% yield after mild solvolysis. 

In the reaction of the 1,1-dichloro-l-alkene 611 with phenylzinc chloride, only monoarylation takes place regioselectively to give the (Z)-l-chloro-l-phe-nylalkene 612[468,474],... 

Arenediazonium salts are also used for the couplina[563], (Z)-Stilbene was obtained unexpectedly by the reaction of the ti-stannylstyrene 694 by addition-elimination. This is a good preparative method for cu-stilbene[564]. The rather inactive aryl chloride 695 can be used for coupling with organostannanes by the coordination of Cr(CO)3 on aromatic rings[3.565]. 

It was claimed that the Z-form of the allylic acetate 430 was retained in homoallylic ketone 431 obtained by reaction with the potassium enolate of 3-vinylcyclopentanone (429), after treatment with triethylborane[282]. Usually this is not possible. The reaction of a (Z)-allylic chloride with an alkenylaluminum reagent to give 1,4-dienes proceeds with retention of the stereochemistry to a considerable extent when it is carried out at -70 C[283]. 

A major advantage of this hydride approach lies in the separation of the remaining elements of the analyte solution from the element to be determined. Because the volatile hydrides are swept out of the analyte solution, the latter can be simply diverted to waste and not sent through the plasma flame Itself. Consequently potential interference from. sample-preparation constituents and by-products is reduced to very low levels. For example, a major interference for arsenic analysis arises from ions ArCE having m/z 75,77, which have the same integral m/z value as that of As+ ions themselves. Thus, any chlorides in the analyte solution (for example, from sea water) could produce serious interference in the accurate analysis of arsenic. The option of diverting the used analyte solution away from the plasma flame facilitates accurate, sensitive analysis of isotope concentrations. Inlet systems for generation of volatile hydrides can operate continuously or batchwise. 

Naturally occurring isotopes of any element are present in unequal amounts. For example, chlorine exists in two isotopic forms, one with 17 protons and 18 neutrons ( Cl) and the other with 17 protons and 20 neutrons ( Cl). The isotopes are not radioactive, and they occur, respectively, in a ratio of nearly 3 1. In a mass spectrum, any compound containing one chlorine atom will have two different molecular masses (m/z values). For example, methyl chloride (CH3CI) has masses of 15 (for the CH3) plus 35 (total = 50) for one isotope of chlorine and 15 plus 37 (total = 52) for the other isotope. Since the isotopes occur in the ratio of 3 1, molecular ions of methyl chloride will show two molecular-mass peaks at m/z values of 50 and 52, with the heights of the peaks in the ratio of 3 1 (Figure 46.4). 

A diagrammatic illustration of the effect of an isotope pattern on a mass spectrum. The two naturally occurring isotopes of chlorine combine with a methyl group to give methyl chloride. Statistically, because their abundance ratio is 3 1, three Cl isotope atoms combine for each Cl atom. Thus, the ratio of the molecular ion peaks at m/z 50, 52 found for methyl chloride in its mass spectrum will also be in the ratio of 3 1. If nothing had been known about the structure of this compound, the appearance in its mass spectrum of two peaks at m/z 50, 52 (two mass units apart) in a ratio of 3 1 would immediately identify the compound as containing chlorine. 

Figure 9.17 Plot of log [i ]M versus retention volume for various polymers, showing how different systems are represented by a single calibration curve when data are represented in this manner. The polymers used include linear and branched polystyrene, poly(methyl methacrylate), poly(vinyl chloride), poly(phenyl siloxane), polybutadiene, and branched, block, and graft copolymers of styrene and methyl methacrylate. [From Z. Grubisec, P. Rempp, and H. Benoit, Polym. Lett. 5 753 (1967), used with permission of Wiley.]...

Both ( )- and (Z)-l-halo-l-alkenes can be prepared by hydroboration of 1-alkynes or 1-halo-l-alkynes followed by halogenation of the intermediate boronic esters (244,245). Differences in the addition—elimination mechanisms operating in these reactions lead to the opposite configurations of iodides as compared to bromides and chlorides. 

The following commercially available dialkyl peroxides are produced according to equations 24—27 di-Z fZ-butyl peroxide from hydrogen peroxide and sulfated tert-huty alcohol or isobutylene dicumyl peroxide from a-cumyl hydroperoxide and cumyl alcohol, cumyl chloride, and/or a-methylstyrene m- and -di(2-/ f2 -butylperoxyisopropyl)ben2ene [2781-00-2] from tert-huty hydroperoxide [75-91-2] and m- and -di(2-hydroxyisopropyl)ben2ene ... 

Fig. 1. Chemical stmctures of barrier polymers, (a) Vlaylidene chloride copolymers (b) hydroly2ed ethylene—vinyl acetate (EVOH) (c) acrylonitrile barrier polymers (d) nylon-6 (e) nylon-6,6 (f) amorphous nylon (Selar PA 3426), y = x - - z-, (g) nylon-MXlD6 (h) poly(ethylene terephthalate) and (i) poly(vinyl...

Aside from their extensive use in metaHacarborane chemistry, the dicarboUide anions are important intermediates in the synthesis of other carborane compounds. For example, aqueous ferric chloride oxidation of the 1 anion results in the 10-vertex cage nido- b ()-(Z, 2 (H8) and the... 

---