Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Water assisted injection moulding

S. Lang and M. J. Parkinson, Two-component water assisted injection moulding. [Pg.44]

Water injection moulding (WIM) or water assisted injection moulding (WAIM) is much newer and less well established. [Pg.214]

W. Michaeli, A. Brunswick and M. Gruber, Step on the Gas with Water Injection Water Assisted Injection Moulding (WAIM) An Alternative to Gas Injection Kunststoff Plast Europe, 1999, 89, 4, 20. [Pg.251]

Whilst injection moulding can be considered a relatively young manufacturing technology, many variants of the basic process have been developed. Examples include processes such as injection-compression, gas assisted, water injection, co-injection and over-moulding. Each of these processes are suitable for specific market applications. An overview of the technologies covered in this chapter is shown in Figure 10.1. [Pg.213]

See other pages where Water assisted injection moulding is mentioned: [Pg.130]    [Pg.241]    [Pg.255]    [Pg.274]    [Pg.130]    [Pg.241]    [Pg.255]    [Pg.274]    [Pg.241]    [Pg.162]    [Pg.214]   
See also in sourсe #XX -- [ Pg.214 , Pg.241 ]



SEARCH



INJECTION MOULD

Water injection

Water injection moulding

© 2024 chempedia.info