Voltammetry nanosecond

Quantitative investigations of the kinetics of these a-coupling steps suffered because rate constants were beyond the timescale of normal voltammetric experiments until ultramicroelectrodes and improved electrochemical equipment made possible a new transient method calledjhst scan voltammetry [27]. With this technique, cyclic voltammetric experiments up to scan rates of 1 MV s are possible, and species with lifetimes in the nanosecond scale can be observed. Using this technique, P. Hapiot et al. [28] were the first to obtain data on the lifetimes of the electrogenerated pyrrole radical cation and substituted derivatives. The resulting rate constants for the dimerization of such monomers lie in the order of 10 s . The same... 

The mechanism of the iodide formation at platinum immersed in aqueous electrode was recently studied by laser-activated voltammetry in a channel flow cell system [161]. In this technique, solid deposits of iodine are removed from the electrode continuously by short nanosecond high-power laser pulses. By removing deposits on electrode surfaces within a channel flow cell, the voltammetric measurements becomes time independent and data can be analyzed and modeled quantitatively. Laser activation using a 10-Hz pulsed Nd YAG 532-nm laser was shown to remove bulk iodine from the electrode surface so that under sustained pulsed... 

In such cases, results may be obtained with scan rates in the range of the megavolts per second [11]. So, voltammetry appears as a kinetic method on a nine order of magnitude of time, from second to nanosecond. 

When the electrochemical properties of some materials are analyzed, the timescale of the phenomena involved requires the use of ultrafast voltammetry. Microelectrodes play an essential role for recording voltammograms at scan rates of megavolts-per-seconds, reaching nanoseconds timescales for which the perturbation is short enough, so it propagates only over a very small zone close to the electrode and the diffusion field can be considered almost planar. In these conditions, the current and the interfacial capacitance are proportional to the electrode area, whereas the ohmic drop and the cell time constant decrease linearly with the electrode characteristic dimension. For Cyclic Voltammetry, these can be written in terms of the dimensionless parameters yu and 6 given by... 

Other forms of voltammetry are as follows (1) fast-scan cyclic voltammetry useful in neuroelectrochemistry (2) nanosecond voltammetry for a 5-pm disk working microelectrode with RC < 1 gs, scan rates of 2.5 MV/s allow for fast kinetics measurements (3) differential-pulse voltammetry with staircase pulses, potential resolutions of 0.04 V and detection limits of 10 8M can be attained (4) anodic (cathodic) stripping voltammetry traces... 

Yet when applied to current reversal techniques, such as double-step chronampero-metry of cyclic voltammetry, these methods require that an appreciable current be observed during the backward perturbation, that is, for t > 0, in potentiostatic methods or after the potential scan inversion in cyclic voltammetry. This requires that the characteristic time 0 of the method is adjusted to match the half-life ti/2 of the electrogenerated intermediate. Today, owing to the recent development of ultramicroelectrodes, 0 can be routinely varied from a few seconds to a few nanoseconds [102]. Yet with basic standard electrochemical equipment, 0 is usually restricted from the second to the low millisecond range. Thus for experimental situations involving faster chemical reactions, current rever-... 

ABSTRACT. Several aspects of electrochemistry at ultramicroelectrodes are presented and discussed in relevance to their application to the analysis of chemical reactivity. The limits of fast scan cyclic voltammetry are examined, and the method shown to allow kinetic investigations in the nanosecond time scale. On the other hand, the dual nature of steady state at ultramicroelectrodes is explained, and it is shown how steady state currents may be used, in combination with transient chronoamperometry, for the determination of absolute electron stoichiometries in voltammetric methods. Finally the interest of electrochemistry in highly resistive conditions for discussion and investigation of chemical reactivity is presented. 

Nanosecond Time Resolved Cyclic Voltammetry 2.1. Factors that distort a cyclic voltammogram... 

Amatore, C., and E. Maisonhaute, When voltammetry reaches nanoseconds Anal. Chem., Vol. 77, 2005 pp. 303A-311A. 

Amatore C, Maisonhaute E (2005) When voltammetry reaches nanoseconds. Anal Chem 77 303A-311A... 

Banks CE, Rees NV, Compton RG (2002) Sonoelectrochemistry understood via nanosecond voltammetry sono-emulsions and the measurement of the potential of zero charge of a solid electrode. J Phys Chem B 106 5810-5813... 

---