Voltammetric measurements nonaqueous solvents

A vacuum spectroelectrochemical cell that also contains an optically transparent thin-layer electrode (OTTLE) is shown in Figures 18.16 and 18.17. The cell can function either as a spectroelectrochemical cell employing an OTTLE or as an electrochemical cell for voltammetric measurements. This low-volume cell is useful for UV/Vis spectral studies in nonaqueous solvents when the reduction product is sensitive to traces of molecular oxygen present in the solvent. The cell is physically small enough to fit inside the sample compartment of the spectrophotometer. The performance of such a cell was evaluated from visible spectroscopy and coulometry of methyl viologen in propylene carbonate [45]. 

When voltammetry measurements are made in nonaqueous solvents, the problems of an adequate reference electrode are compounded. Until the 1960s the most common reference electrode was the mercury pool, because of its convenience rather than because of its reliability. With the advent of sophisticated electronic voltammetric instrumentation, more reliable reference electrodes have been possible, especially if a three-electrode system is used. Thus, variation of the potential of the counter electrode is not a problem if a second non-current-canying reference electrode is used to monitor the potential of the sensing electrode. If three-eleetrode instrumentation is used, any of the conventional reference electrodes common to potentiometry may be used satisfactorily. Our own preference is a silver chloride electrode connected to the sample solution by an appropriate noninterfering salt bridge. The one problem with this system is that it introduces a junction potential between the two solvent systems that may be quite large. However, such a reference system is reproducible and should ensure that two groups of workers can obtain the same results. 

---