Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Voltage phase

No ni ial syste n voltage kV r.m.s.) Rated maximum system voltage V, kV(r.tn.s.) Standard one-minute power frequency withstand voltage KV (r.m.s.) Standard lightning impulse (1.2/50 ps) withstand voltage phase to ground kV (peak) ... [Pg.344]

Type and specifications on fan driver, gear types, pow er voltage, phase, cycles. Motors should at least meet specifications equivalent to totally enclosed, fan cooled, or if in explosive hazardous area, TEFC Class I, Group D (except this not acceptable in hydrogen or acetylene atmosphere). Due to moisture conditions around this equipment, it should be protected against moisture penetration and corrosion. [Pg.387]

The available operating voltage, phase, and frequency must be given to the motor manufacturer. When the question of off-standard conditions arises, every effort should be made to use the standard or stock motors. [Pg.654]

Give voltage, phase, and cycles of your electric current ... [Pg.738]

Voltage, phase cycle, amps (control circuit power)... [Pg.337]

L1, L2, L3 phase conductors 1/1, 1/2, 1/3 voltages phase to neutral C1, C2, C3 capacitances phase to earth PE protective earthed conductor RF earth fault resistance UN, PE voltage between neutral N and PE in case of an earth fault... [Pg.494]

Should motor be standard open, totally enclosed or explosion proof . Give voltage, phase, and cycles of your electric current ... [Pg.738]

When 7 exceeds 7, a constant phase difference can no longer be maintained and a voltage develops across the junction. The phases on the two sides of the junction begin to slip with respect to each other, with the rate of slippage governed by the Josephson voltage-phase relation... [Pg.108]

In equivalent electrical model in form of parallel connection of resistance R resistor and ideal capacitor of C capacity, the active current part Ir = U / R (U voltage phase) and passive Ic = j Cp C U (voltage lags the current by n/2 phase) represent leakage current and capacitor charging current respectively. Complex admittance measured for that circuit can be represented by ... [Pg.325]

The product mix and the production capacities planned for the present and as per planning for the future shall be considered for making a list of the process units and utilities required. The list shall clearly indicate horsepowers (as well as operating voltage, phases, and frequency) and running hours of each motor which will be... [Pg.182]

Electrical specifications power supply frequency, voltage, phases (single phase or three phase) (supply frequency is not same in all countries—it is 50 Hz or 60 Hz and the rotational speed of motor RPM depends on it). [Pg.185]

Details of power supply available at site (voltage, phases and frequency)... [Pg.29]

Electrical specifications HP, frequency, voltage, phases (single phase or three... [Pg.189]

See other pages where Voltage phase is mentioned: [Pg.123]    [Pg.345]    [Pg.815]    [Pg.851]    [Pg.84]    [Pg.82]    [Pg.289]    [Pg.123]    [Pg.760]    [Pg.177]    [Pg.84]    [Pg.515]    [Pg.495]    [Pg.19]    [Pg.615]    [Pg.759]    [Pg.13]    [Pg.757]    [Pg.782]    [Pg.703]    [Pg.760]    [Pg.643]    [Pg.667]    [Pg.430]    [Pg.282]    [Pg.63]    [Pg.447]    [Pg.448]    [Pg.562]    [Pg.565]    [Pg.239]    [Pg.576]   
See also in sourсe #XX -- [ Pg.289 ]



SEARCH



© 2024 chempedia.info