Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Virtual inventory

Apparel Made for You (AM4U) PD for virtual inventory apparel manufacturing... [Pg.48]

Virtual inventory manufacturing alhance (VIMA) http //www.vimalliance.org/... [Pg.56]

However, it is sometimes quite difficult to separate costs and particularly manufacturing overhead costs into fixed and variable components. In the long term virtually all costs are variable. The difference between the two methods assumes great importance in inventory evaluation. In cost accounting, costs are identified with cost centers. These are accounting devices which may or may not have a physical existence. In the simplest case of a plant manufacturing a single product, the entire plant may be the cost center. [Pg.846]

Inosine 5 -Monophosphate Dehydrogenase. A series of 21 known inosine 5 -monophosphate dehydrogenase (IMPDH) inhibitors was used to validate a virtual screening protocol. By application of a molecular weight filter (80 < MW < 400), 3425 compounds were extracted from an in-house reagent inventory system. Docking of these compounds into a substrate-IMPDH complex 3D structure was performed with the program FlexX three... [Pg.401]

Endrin is no longer manufactured in the United States. Velsicol Chemical Company, Memphis, Tennessee, was the producer of endrin until the final voluntary cancellation of registration with the Office of Pesticide Programs in 1991 (Bishop 1984, 1985, 1986 EPA 1983e USDA 1995). It is estimated that 2.3-4.5 million kg (5.1-9.9 million pounds) of endrin were sold in the United States in 1962, while less than 450,000 kg (990,000 pounds) were produced in 1971 (IARC 1974). More recent estimates of domestic production of endrin could not be found (HSDB 1995). As with many toxic chemicals, information on production or use of pesticides is often proprietary, and quantitative estimates of production of endrin are virtually impossible to obtain (Bason and Colbom 1992). Chemical manufacturers in the United States however, can legally produce pesticides for export that are currently banned or not registered for use in the United States (FASE 1996). No information on the production of endrin was available from the Toxic Release Inventory (TRI) because endrin is not one of the chemicals that facilities are required to report (EPA 1995a). [Pg.104]

Modifications of the system continue to be infused as methods and processes improve. In 1998, the SYSCO Order Selector (SOS), another module of SUS, was installed to improve order accuracy and inventory control. A wrist-mounted scanner verifies at the touch of a finger that the product selected is indeed what the customer ordered and virtually eliminates the opportunity for visual errors. Usage of this unit has improved the accuracy of products selected from one error in 800 to one in every three or four thousand items picked by the product selector, significantly improving efficiency and customer satisfaction, and reducing restocking costs. [Pg.78]

Figure 23.7 Vertical profiles of water temperature (dotted line) and of measured (circles) and calculated (solid line) PCE concentration in Greifensee (Switzerland) for the period May to October 1985. Numbers give PCE inventory in moles (M = measured, C = calculated). From the model calculation it can be concluded that between May 6 and July 1, 1985, about 360 moles of PCE entered the lake, thus leading to a significant increase of the concentration in the lake during several months. After July 1, the input was virtually zero. Figure 23.7 Vertical profiles of water temperature (dotted line) and of measured (circles) and calculated (solid line) PCE concentration in Greifensee (Switzerland) for the period May to October 1985. Numbers give PCE inventory in moles (M = measured, C = calculated). From the model calculation it can be concluded that between May 6 and July 1, 1985, about 360 moles of PCE entered the lake, thus leading to a significant increase of the concentration in the lake during several months. After July 1, the input was virtually zero.
If the aim of the catalytic process is to optimize yield and selectivity, one can distinguish two extremes fast reactions and slow reactions (Figure 25). In slow reactions, the intrinsic reaction kinetics control the process, so the catalyst inventory should be as high as possible. Increasing the wall thickness of a monolith can have the desired effect. In fact the degree of variation in this way is virtually from 10-90 volume %, whereas a packed bed will always yield an inventory of around 60% or lower if hollow catalyst particles are used. [Pg.231]

Figure 6.5. Changes in soil organic C storage and mineral content along a chronosequence in Hawaii (Torn et al., 1997). The substrate for soil development are basaltic ash deposits of known age. Climate and vegetation are virtually the same across the sites. (A) Soil organic C inventory versus ash substrate age. The solid line is the whole mineral soil to the C horizon, and the dashed line is the top 20 cm. The increase and subsequent decrease in SOM with soil age is mostly due to changes in the subsurface mineral soil. (B) The correlation of soil carbon in mineral horizons with the amount of noncrystalline minerals. Figure 6.5. Changes in soil organic C storage and mineral content along a chronosequence in Hawaii (Torn et al., 1997). The substrate for soil development are basaltic ash deposits of known age. Climate and vegetation are virtually the same across the sites. (A) Soil organic C inventory versus ash substrate age. The solid line is the whole mineral soil to the C horizon, and the dashed line is the top 20 cm. The increase and subsequent decrease in SOM with soil age is mostly due to changes in the subsurface mineral soil. (B) The correlation of soil carbon in mineral horizons with the amount of noncrystalline minerals.
Three basic features of integrated chemical processes lie at the root of our need to consider the entire plant s control system (1) the effect of material recycle, (2) the effect of energy integration, and (3) the need to account for chemical component inventories. If we did not have to worry about these issues, then we would not have to deal with a complex plantwide control problem. However, there are fundamental reasons why each of these exists in virtually all real processes. [Pg.18]

Value creation 11-21, 26-35 Value-driver trees 156, 159 Vendor managed inventory (VMI) 84 Ventro 34 Venture capital funds biotechnology 67, 77 corporate 117-118 innovation 32, 114 Venture capitalists 31, 66-67, 118 Vertical integration 37, 40-42 Vestolit 39 Victrex 98 Vinnolit 39 Virtual crackers 43 Virtual organization 122 Vopak 34, 35... [Pg.5]


See other pages where Virtual inventory is mentioned: [Pg.49]    [Pg.55]    [Pg.99]    [Pg.132]    [Pg.65]    [Pg.80]    [Pg.166]    [Pg.49]    [Pg.55]    [Pg.99]    [Pg.132]    [Pg.65]    [Pg.80]    [Pg.166]    [Pg.1911]    [Pg.1975]    [Pg.302]    [Pg.383]    [Pg.404]    [Pg.56]    [Pg.180]    [Pg.26]    [Pg.5]    [Pg.364]    [Pg.4]    [Pg.11]    [Pg.144]    [Pg.240]    [Pg.160]    [Pg.510]    [Pg.281]    [Pg.185]    [Pg.27]    [Pg.32]    [Pg.74]    [Pg.1669]    [Pg.1733]    [Pg.321]    [Pg.363]    [Pg.1682]    [Pg.5024]    [Pg.15]    [Pg.54]   
See also in sourсe #XX -- [ Pg.166 ]




SEARCH



Virtual Inventory Management

© 2024 chempedia.info