Vinyl addition living

Because of these consecutive steps, initiation by iodine is slow. Purposeful addition of HI with I2 leads to significantly better initiation and, in the case of -butyl vinyl ether, living polymerization (49). 

Cationic Polymerization. For decades cationic polymerization has been used commercially to polymerize isobutylene and alkyl vinyl ethers, which do not respond to free-radical or anionic addition (see Elastomers, synthetic-BUTYLRUBBEr). More recently, development has led to the point where living cationic chains can be made, with many of the advantages described above for anionic polymerization (27,28). 

The monosubstituted intermediate does not seem to be effectively bridged, since syn addition predominates. Avery short-lived vinyl cation appears to be the best description of the intermediate in this case. ... 

An alternate way to make block copolymers involving PDMS blocks 124,125) is to have these chains fitted with epoxide functions at chain end, and to react them with a vinylic or dienic polymer carrying terminal COOH functions. Sequential addition of monomers has also been used, the ring opening polymerization of the cyclic trimer (D3) being initiated by the anionic site of a living polymer126). 

Vinyl copolymers contain mers from two or more vinyl monomers. Most common are random copolymers that are formed when the monomers polymerize simultaneously. They can be made by most polymerization mechanisms. Block copolymers are formed by reacting one monomer to completion and then replacing it with a different monomer that continues to add to the same polymer chain. The polymerization of a diblock copolymer stops at this point. Triblock and multiblock polymers continue the polymerization with additional monomer depletion and replenishment steps. The polymer chain must retain its ability to grow throughout the process. This is possible for a few polymerization mechanisms that give living polymers. 

To 5.3 g of 4-vinylpyridine is added to THE up to a volume of 50 ml 5 ml of this solution (containing 5 mmol 4-vinyl pyridine) are added in the same way to the above solution containing the "living" polystyrene, with vigorous agitation. After 15 min another 40 mmol of styrene are added, followed 15 min later by another 5 mmol of 4-vinylpyridine this operation is repeated once more. 15 min after the last addition of monomer the block copolymer is precipitated by dropping the solution into a mixture of 300 ml of diethyl ether and 300 ml of petroleum ether.The polymer is filtered, washed with ether,filtered again, and dried in vacuum at room temperature. 

---