Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Vibrational dynamics representation

Equation (33) assumes that IV// is large compared to 2J (i.e., no electronic and vibrational recurrences). In addition, Eq. (33) deals only with population dynamics Interferences between different Franck-Condon factors are neglected. These interferences do influence the rate, and the interplay between electronic and vibrational dynamics can be quite complex [25], Finally, as discussed by Jean et al. [22], Eq. (33) does not separate the influence of pure dephasing (T-T) and population relaxation (Ti). These two processes (defined as the site representation [22]) can have significantly different effects on the overall rate. For example, when (T () becomes small compared to Eq. (33) substantially overestimates the rate compared to... [Pg.177]

Fig. 11.1. Schematic of the accuracy of the n-mode representation of the potential and the method of treatment of the vibrational dynamics. Fig. 11.1. Schematic of the accuracy of the n-mode representation of the potential and the method of treatment of the vibrational dynamics.
Another approach has been chosen by Bonacic-Koutecky and coworkers [136]. Together with Jortner, they applied the density matrix method in the Wigner representation (see Sect. 2.2.3) to investigate the vibrational dynamics of the trimer. Within this approach the simulation of the real-time photoion spectra involves three steps ... [Pg.163]

Luckhaus D 2000 6D vibrational quantum dynamics generalized coordinate discrete variable representation and (a)diabatic contraction J. Chem. Phys. 113 1329—47... [Pg.1088]

SPACEEIL has been used to study polymer dynamics caused by Brownian motion (60). In another computer animation study, a modified ORTREPII program was used to model normal molecular vibrations (70). An energy optimization technique was coupled with graphic molecular representations to produce animations demonstrating the behavior of a system as it approaches configurational equiHbrium (71). In a similar animation study, the dynamic behavior of nonadiabatic transitions in the lithium—hydrogen system was modeled (72). [Pg.63]

A typical initial condition in ordinary wave packet dynamics is an incoming Gaussian wave packet consistent with particular diatomic vibrational and rotational quantum numbers. In the present case, of course, one has two diatomics and with the rotational basis representation of Eq. (30) one would have, for the full complex wave packet. [Pg.16]

Messina et al. [25] test the time-dependent Hartree reduced representation with a simple two-degree-of-freedom model consisting of the h vibration coupled to a one-harmonic-oscillator bath. The objective function is a minimum-uncertainty wavepacket on the B state potential curve of I2. Figure 12, which displays a typical result, shows that this approximate representation gives a rather good account of the short-time dynamics of the system. [Pg.267]

In applying the methods of group theory to problems related to molecular structure or dynamics, the procedure that is followed usually involves deriving a reducible representation for the phenomenon of interest, such as molecular vibration, and then decomposing it into its irreducible components. (A reducible representation will always be a sum of irreducible ones.) Although the decomposition can sometimes be accomplished by inspection, for the more general case, the following reduction... [Pg.43]

In contrast to the subsystem representation, the adiabatic basis depends on the environmental coordinates. As such, one obtains a physically intuitive description in terms of classical trajectories along Born-Oppenheimer surfaces. A variety of systems have been studied using QCL dynamics in this basis. These include the reaction rate and the kinetic isotope effect of proton transfer in a polar condensed phase solvent and a cluster [29-33], vibrational energy relaxation of a hydrogen bonded complex in a polar liquid [34], photodissociation of F2 [35], dynamical analysis of vibrational frequency shifts in a Xe fluid [36], and the spin-boson model [37,38], which is of particular importance as exact quantum results are available for comparison. [Pg.389]

Transitions between electronic states are formally equivalent to transitions between different vibrational or rotational states which were amply discussed in Chapters 9 11. Computationally, however, they are much more difficult to handle because they arise from the coupling between electronic and nuclear motions. The rigorous description of electronic transitions in polyatomic molecules is probably the most difficult task in the whole field of molecular dynamics (Siebrand 1976 Tully 1976 Child 1979 Rebentrost 1981 Baer 1983 Koppel, Domcke, and Cederbaum 1984 Whetten, Ezra, and Grant 1985 Desouter-Lecomte et al. 1985 Baer 1985b Lefebvre-Brion and Field 1986 Sidis 1989a,b Coalson 1989). The reasons will become apparent below. The two basic approaches, the adiabatic and the diabatic representations, will be outlined in Sections 15.1 and 15.2, respectively. Two examples, the photodissociation of CH3I and of H2S, will be discussed in Section 15.3. [Pg.348]

A molecule contains a nuclear distribution and an electronic distribution there is nothing else in a molecule. The nuclear arrangement is fully reflected in the electronic density distribution, consequently, the electronic density and its changes are sufficient to derive all information on all molecular properties. Molecular bodies are the fuzzy bodies of electronic charge density distributions consequently, the shape and shape changes of these fuzzy bodies potentially describe all molecular properties. Modern computational methods of quantum chemistry provide practical means to describe molecular electron distributions, and sufficiently accurate quantum chemical representations of the fuzzy molecular bodies are of importance for many reasons. A detailed analysis and understanding of "static" molecular properties such as "equilibrium" structure, and the more important dynamic properties such as vibrations, conformational changes and chemical reactions are hardly possible without a description of the molecule itself that implies a description of molecular bodies. [Pg.171]

The first step in the symmetry determination of the dynamic properties is the selection of the appropriate basis. Appropriate here means the correct representation of the changes in the properties examined. In the investigation of molecular vibrations (Chapter 5), either Cartesian displacement vectors or internal coordinate vectors are used. In the description of the molecular electronic structure (Chapter 6), the angular components of the atomic orbitals are frequently used... [Pg.213]


See other pages where Vibrational dynamics representation is mentioned: [Pg.510]    [Pg.13]    [Pg.412]    [Pg.64]    [Pg.1982]    [Pg.264]    [Pg.164]    [Pg.323]    [Pg.34]    [Pg.369]    [Pg.292]    [Pg.135]    [Pg.497]    [Pg.132]    [Pg.194]    [Pg.195]    [Pg.149]    [Pg.172]    [Pg.489]    [Pg.589]    [Pg.114]    [Pg.114]    [Pg.1029]    [Pg.164]    [Pg.327]    [Pg.510]    [Pg.221]    [Pg.98]    [Pg.54]    [Pg.303]    [Pg.317]    [Pg.210]    [Pg.154]    [Pg.220]    [Pg.46]    [Pg.169]    [Pg.170]    [Pg.38]   
See also in sourсe #XX -- [ Pg.273 ]




SEARCH



Vibrational dynamics

Vibrational dynamics adiabatic representation

© 2024 chempedia.info