Types, mechanical INDEX

Although the Langelier index is probably the most frequently quoted measure of a water s corrosivity, it is at best a not very reliable guide. All that the index can do, and all that its author claimed for it is to provide an indication of a water s thermodynamic tendency to precipitate calcium carbonate. It cannot indicate if sufficient material will be deposited to completely cover all exposed metal surfaces consequently a very soft water can have a strongly positive index but still be corrosive. Similarly the index cannot take into account if the precipitate will be in the appropriate physical form, i.e. a semi-amorphous egg-shell like deposit that spreads uniformly over all the exposed surfaces rather than forming isolated crystals at a limited number of nucleation sites. The egg-shell type of deposit has been shown to be associated with the presence of organic material which affects the growth mechanism of the calcium carbonate crystals . Where a substantial and stable deposit is produced on a metal surface, this is an effective anticorrosion barrier and forms the basis of a chemical treatment to protect water pipes . However, the conditions required for such a process are not likely to arise with any natural waters. 

The partitioning of the activated inhibitor between direct covalent inactivation of the enzyme and release into solution is an important issue for mechanism-based inactivators. The partition ratio is of value as a quantitative measure of inactivation efficiency, as described above. This value is also important in assessing the suitability of a compound as a drug for clinical use. If the partition ratio is high, this means that a significant proportion of the activated inhibitor molecules is not sequestered as a covalent adduct with the target enzyme but instead is released into solution. Once released, the compound can diffuse away to covalently modify other proteins within the cell, tissue, or systemic circulation. This could then lead to the same types of potential clinical liabilities that were discussed earlier in this chapter in the context of affinity labels, and would therefore erode the potential therapeutic index for such a compound. 

Chatteijee, A. 2005. Application of localized reactivity index in combination with periodic DFT calculation to rationalize the swelling mechanism of clay type inorganic material. J. Chem. Sci. 117 533-539. 

Of the 3 possible types of peroxy carbonate esters-dialkyl monoperoxy carbonates, dialkyl diperoxycarbonates and dialkyl peroxydicarbonates-, the latter are by far the least stable group. Several of the 16 alkyl and substituted-alkyl esters prepared decomposed violently or explosively at temperatures only slightly above the temperature of preparation (0-10°C), owing to self-accelerating exothermic decomposition. Several were also explosive on exposure to heat, friction or shock [1], Amines and certain metals cause accelerated decomposition of dialkyl peroxydicarbonates by a true catalytic mechanism [2], Individually indexed compounds are ... 

Also other Type B and C series from Table II are consistent with the above elimination mechanisms. The dehydration rate of the alcohols ROH on an acid clay (series 16) increased with the calculated inductive effect of the group R. For the dehydrochlorination of polychloroethanes on basic catalysts (series 20), the rate could be correlated with a quantum-chemical reactivity index, namely the delocalizability of the hydrogen atoms by a nucleophilic attack similar indices for a radical or electrophilic attack on the chlorine atoms did not fit the data. The rates of alkylbenzene cracking on silica-alumina catalysts have been correlated with the enthalpies of formation of the corresponding alkylcarbonium ions (series 24). Similar correlations have been obtained for the dehydrosulfidation of alkanethiols and dialkyl sulfides on silica-alumina (series 36 and 37) in these cases, correlation by the Taft equation is also possible. The rate of cracking of 1,1-diarylethanes increased with the increasing basicity of the reactants (series 33). 

Structure effects on the rate of selective or total oxidation of saturated and unsaturated hydrocarbons and their correlations have been used successfully in the exploration of the reaction mechanisms. Adams 150) has shown that the oxidation of alkenes to aldehydes or alkadienes on a BijOj-MoOj catalyst exhibits the same influence of alkene structure on rate as the attack by methyl radicals an excellent Type B correlation has been gained between the rate of these two processes for various alkenes (series 135, five reactants, positive slope). It was concluded on this basis that the rate-determining step of the oxidation is the abstraction of the allylic hydrogen. Similarly, Uchi-jima, Ishida, Uemitsu, and Yoneda 151) correlated the rate of the total oxidation of alkenes on NiO with the quantum-chemical index of delo-calizability of allylic hydrogens (series 136, five reactants). 

---