Test method spring

Surveys of gasoline quality in Europe and North America in Spring, 1969, show octane numbers by the "Research and Motor test methods, as given in Table 2 20>. 

D 3706 Test Method for Hot Tack of Wax Polymer Blends by the Flat Spring Test... 

Liquid Propellant Test Methods Recommended, Chemical Propulsion Information Agency, The Johns Hopkins University Applied Physics Laboratory, Silver Spring, Md., 1959. 

ASTM E855-90. (1990) Standard Test Methods for Bend Testing of Metallic Flat Materials for Spring Applications Involving Static Loading, American Society for Testing Materials. 

The two most common types of durometers used for plastics are the Shore Type A and Shore Type D. They differ in the spring force and the geometry of the indentor, as shown in Figure 3.45. Due to creep, readings should be taken after a fixed time interval, often chosen as 10 sec. Typical hardness values of some of the common plastics measured by different test methods are shown in Table 3.4. 

Domack, M. S., Stress Corrosion Evaluation of Powder Metallurgy Aluminum Alloy 7091 with the Breaking Load Test Method, Presented at the Tri-Service Corrosion Conference, Colorado Springs, CO, 5-7 May 1987, p. 21... 

Abrasion resistance is another complex area. One of the reasons for confusion is that the various test methods do not agree well with each other. There is a perception that hard surfaces lead to the best abrasion resistance, however, that does not jibe with the facts. In actuality, it is elastomeric surfaces that have excellent abrasion resistance. Look, for example, at rubber car tires and PVC flooring, which is always coaled with a polyurethane elastomer layer to provide wear resistance. Elastomers deform and spring back undamaged, so scratch and wear resistance is good [17]. 

D-2293. Test Method for Creep Properties of Adhesives in Shear by Compression Loading (Metal-to-Metal). Fig. 20 shows the specimen and spring actuated loading device for... 

D-2919. Test Method for Determining Durability of Adhesive Joints Stressed in Shear by Tension Loading. Fig. 25 shows the lap shear specimen and spring-type loading device used. A number of standard environments are also suggested for use. 

ASTM. 2009b. Standard test method for bending fatigue testing for copper-alloy spring materials. ASTM B593-96(2009)el. West Conshohocken, PA ASTM International. 

With respect to the harmonic content of the strain signal, a correction method was therefore developed for torque harmonics, based on observations made when testing an ideal elastic body, for instance, the calibration spring. T(n(x>/ (a) data are corrected according to... 

---