Surface viscosity problems

Supercritical Low surface tension and viscosity Problem of stability and activity of enzyme... 

It will be obvious that, when the substrate is much smaller than the trough and the surface viscosity is appreciable, there will exist a complicated flow pattern round the substrate which may cause difficulties. Various ingenious devices designed to overcome this problem have been... 

To the extent that viscosity and surface viscosity influence foam stability, one would predict that stability would vary according to the effect of temperature on the viscosity. Thus some petroleum industry processes exhibit serious foaming problems at low process temperatures, which disappear at higher temperatures. Ross and Morrison [25] cite some examples of petroleum foams that become markedly less stable above a narrow temperature range that may be an interfacial analogue of a melting point. 

Thus, in order to solve the hydrodynamic problem of liquid motion in view of the change of 2 at the interface, we should first And out the distribution of substance concentration, temperature and electric charge over the surface. These distributions, in turn, are influenced by the distribution of hydrodynamic parameters. Therefore the solution of this problem requires utilization of conservation laws - the equations of mass, momentum, energy, and electric charge conservation with the appropriate boundary conditions that represent the balance of forces at the interface the equality of tangential forces and the jump in normal forces which equals the capillary pressure. In the case of Boussinesq model, it is necessary to know the surface viscosity of the layer. From now on, we are going to neglect the surface viscosity. 

It becomes apparent now that the effects of surface viscosities can be included in the boimdary conditions for all problems involving dynamic interfaces, including those considered in Chapters 5 and 6. 

The choice of the solvent also has a profound influence on the observed sonochemistry. The effect of vapor pressure has already been mentioned. Other Hquid properties, such as surface tension and viscosity, wiU alter the threshold of cavitation, but this is generaUy a minor concern. The chemical reactivity of the solvent is often much more important. No solvent is inert under the high temperature conditions of cavitation (50). One may minimize this problem, however, by using robust solvents that have low vapor pressures so as to minimize their concentration in the vapor phase of the cavitation event. Alternatively, one may wish to take advantage of such secondary reactions, for example, by using halocarbons for sonochemical halogenations. With ultrasonic irradiations in water, the observed aqueous sonochemistry is dominated by secondary reactions of OH- and H- formed from the sonolysis of water vapor in the cavitation zone (51—53). 

Some concerns directly related to a tomizer operation include inadequate mixing of Hquid and gas, incomplete droplet evaporation, hydrodynamic instabiHty, formation of nonuniform sprays, uneven deposition of Hquid particles on soHd surfaces, and drifting of small droplets. Other possible problems include difficulty in achieving ignition, poor combustion efficiency, and incorrect rates of evaporation, chemical reaction, solidification, or deposition. Atomizers must also provide the desired spray angle and pattern, penetration, concentration, and particle size distribution. In certain appHcations, they must handle high viscosity or non-Newtonian fluids, or provide extremely fine sprays for rapid cooling. 

---