Surface metal carburization

Accelerated deterioration of metals in carbonaceous gases at elevated temperatures to form a dust-fike corrosion product a unique form of high-temperature corrosion that forms a dust-hke corrosion product and sometimes develops hemispherical pits on a susceptible metal surface simultaneous carburization is generally observed. 

P/M steels can be heat treated in the same manner as cast or wrought steels. They may be austenitized, quenched, and tempered. Surface hardening includes pack or gas carburization or nitriding, ie, heating in a nitrogen-containing atmosphere. Because of the greater amount of exposed surface area in the form of porosity, a protective atmosphere is needed (see Metal surface treatments). 

Carbides may also be prepared, either by dhect carburizing, as in the case of steel, in which a surface carbide film dissolves into the subsuate steel, or by refractoty metal carbide formation as in die cases when one of the refractory metal halides is mixed with methane in the plasma gas. 

The equation for the rate of oxidation of the transition metals at high temperatures, which form a solid solution of oxygen before the oxide appears at the surface has die same form as that derived for die carburizing of die metal, and... 

Bad-kasten, m. (electrolytic) cell, -nitrieren, n. Metal.) fused-salt nitriding, -patentieren, n. Wire) patenting with cooling in a lead or salt bath, -spannung, /. bath tension, cell voltage, -Spiegel, m, bath level, bath surface, -zementieren, n. Metal.) bath cementation, liquid carburizing,... 

The first syntheses of transition metal nitrides and carbides were derived from metallurgical processes,1,3 and consisted in the nitridation or carburization of the metal or of the oxide at severe conditions, in particular at high temperatures (>1500 K). Consequently, the resulting powders generally had low specific surface areas (Sg). 

No epitaxy could be obtained by reaction of the metal films with reactive gas for short reactions times. This is understandable as the carburization and nitridation reactions progress from the surface of the metal films to the substrate and occur with a change in crystal structure of the film (for instance bcc to hex). So even if the starting metal film is epitaxial, the final carbide or nitride compound could be polycrystalline. For high temperatures and for long time treatments (>15 h), however, perfect epitaxial Y Mo2N films could be obtained on MgO (100).17 In this last case, the crystalline state of the precursor metal film had no effect on the final parallel orientation of the nitride. 

In such reactions as the tarnishing of silver in air, the oxidation of aluminum in air, or attack of lead in sulfate-containing environments, thin, tightly adherent protective films are formed, and the metal surface remains smooth. It should be mentioned that underground corrosion is frequently observed as localized corrosion. Oxidation, sulfidation, carburization, hydrogen effects, and hot corrosion can be considered as types of general corrosion.20... 

The feedstock in hydrodealkylation units is heated to 1,200° F (650°C) in a preheat furnace before entering the reactor. Above 1,100°F (590°C), metal dusting or catastrophic carburization occurs on ail alloys that are otherwise suitable for the temperature conditions. The attack is very rapid and takes the form of round bottom pits. The surface of the remaining metal is heavily carburized. A small quantity of sulfur (0.05 to 0.5 wt%) in the form of hydrogen sulfide or mercaptan added to the feed will prevent attack. Aluminizing has also been used to prevent attack. 

---