Storage and discharge

Lithium foil is made by extruding a lithium ingot through a slit. A study of the influence of the extrusion atmosphere on the kind of native film produced showed that lithium covered with Li2CO, is superior both in terms of storage and discharge because of its stability and because a lithium anode has a low impedance [3, 4],... 

Surface Water Control through Storage and Discharge of Water... 

The flowability of the final blend is especially critical during storage and discharge from an IBC. The IBC may be a bin (tote) or even a drum that is used to store and transfer the final blend from the blender to the press. When a drum is used, an attachment such as a conical hoppef may be attached to the cone to mate the drum to downstream equipment with a smaller inlet (e.g., press hopper). In both cases, the IBC consists of two primary sections (Fig. 1) ... 

Short-term storage and associated phosphorus dynamics signihcantly impact long-term storage and discharge water quality. 

The storage system operates well away from the maximum power point of the semiconductor device, and therefore storage and discharge efficiency is poor. The cell uses a salt bridge between the two compartments and is of the form... 

Anonymous (1935). Gilerest, Bruce. Silver Spruce Yearbook 121. Colostate Fort Collins. P Gilerest, B.R., Marsh, L.E. (1941). Channel-storage and discharge-relations in the Lower Ohio River Valley. Trans. AGU22(3) 637-649. 

FIGURE 14.14 Capacity retention of Li/SOj batteries after ambient storage and discharge at the 2 amp rate. 

Roberts, A. W. (1990). Storage and discharge of bulk solids from silos with special reference to the use of inserts, POSTEC Research Report, Porsgrunn, Norway. 

Caro, L. G., and Palade, G. E., 1964, Protein synthesis, storage, and discharge in the pancreatic exocrine cell. An autoradiographic study, /. Cell Biol. 20 473. 

---