Stator-rotor starters

Reversitig DOL starter Star-delta starter Auto transformer starter Primary resistance starter Dual-speed starter Three stage stator-rotor starter Schematic for panel space heater and internal illutnination Schematic for instrutnent wiritig... 

Figure 13.60 Typical three-stage stator-rotor starter...

The.se arc similar to stator resistance starters, as discussed in Section 4.2..3 and can be used in the rotor circuit to control the rotor side resistance. Figure 5.10 shows the smooth variation of resistance by electrolytic vaporization compared to a conventional metallic resistance variation. I hc self-variable resistance of electrolyte is equivalent to almost three or four steps of a metallic resistance and makes such starters economical. Normally one step is sufficient for motors up to 160 h.p. (For spccd-torquc... 

Adequate single-phase protection is provided on low-voltage ac motor starters by three overload relays, which are now standard. Rotor heating is not particularly a problem on smaller motors which have more thermal capacity, but it is important to protect the stator windings of these machines against burnout. 

The exciter is an AC generator with a stator-mounted field. Direct cur rent for the exciter field is provided from an external source, typically u small variable voltage rectifier mounted at the motor starter. Exciter oui put is converted to DC through a three-phase, full-wave, silicon-diode bridge rectifier. Thyristors (silicon-controlled rectifiers) switch the cur rent to the motor field and the motor-starting, field-discharge resistors These semiconductor elements are mounted on heat sinks and assembled on a drum bolted to the rotor or shaft. 

---