Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Boundary conditions solution

Initial conditions are a second source of LES results variability these conditions are often unknown and any small change in initial conditions may trigger significant changes in the LES solution. Boundary conditions, in particular the unsteady velocity profiles imposed at in-... [Pg.287]

The prescription is not unique, since any p-independent rotation of T is also a solution boundary conditions are imposed on (A7) by requiring V(p) to coincide with e(p) at some p (local diabaticity... [Pg.409]

The equations are transcendental for the general case, and their solution has been discussed in several contexts [32-35]. One important issue is the treatment of the boundary condition at the surface as d is changed. Traditionally, the constant surface potential condition is used where po is constant however, it is equally plausible that ag is constant due to the behavior of charged sites on the surface. [Pg.181]

For many-electron systems such as atoms and molecules, it is obviously important that approximate wavefiinctions obey the same boundary conditions and symmetry properties as the exact solutions. Therefore, they should be antisynnnetric with respect to interchange of each pair of electrons. Such states can always be constmcted as linear combinations of products such as... [Pg.31]

The solutions of such partial differential equations require infomiation on the spatial boundary conditions and initial conditions. Suppose we have an infinite system in which the concentration flucPiations vanish at the infinite boundary. If, at t = 0 we have a flucPiation at origin 5C(f,0) = AC (f), then the diflfiision equation... [Pg.721]

The solution of Laplace s equation, (A3.3.71), with these boundary conditions is, for [Pg.749]

Smoluchowski theory [29, 30] and its modifications fonu the basis of most approaches used to interpret bimolecular rate constants obtained from chemical kinetics experiments in tenus of difhision effects [31]. The Smoluchowski model is based on Brownian motion theory underlying the phenomenological difhision equation in the absence of external forces. In the standard picture, one considers a dilute fluid solution of reactants A and B with [A] [B] and asks for the time evolution of [B] in the vicinity of A, i.e. of the density distribution p(r,t) = [B](rl)/[B] 2i ] r(t))l ] Q ([B] is assumed not to change appreciably during the reaction). The initial distribution and the outer and inner boundary conditions are chosen, respectively, as... [Pg.843]

Often in numerical calculations we detennine solutions g (R) that solve the Scln-odinger equations but do not satisfy the asymptotic boundary condition in (A3.11.65). To solve for S, we rewrite equation (A3.11.65) and its derivative with respect to R in the more general fomi ... [Pg.973]

A is a coelTicient matrix that is designed to transfomi between solutions that obey arbitrary boundary conditions and those which obey the desired boundary conditions. A and S can be regarded as unknowns in equation (A3.11.72) and equation (A3.11.73). This leads to the following expression for S ... [Pg.973]

A fiill solution of tlie nonlinear radiation follows from the Maxwell equations. The general case of radiation from a second-order nonlinear material of finite thickness was solved by Bloembergen and Pershan in 1962 [40]. That problem reduces to the present one if we let the interfacial thickness approach zero. Other equivalent solutions involved tlie application of the boundary conditions for a polarization sheet [14] or the... [Pg.1277]

Pick s second law of difflision enables predictions of concentration changes of electroactive material close to the electrode surface and solutions, with initial and boundary conditions appropriate to a particular experiment, provide the basis of the theory of instrumental methods such as, for example, potential-step and cyclic voltanunetry. [Pg.1924]

Here the distortion (diagonal) and back coupling matrix elements in the two-level equations (section B2.2.8.4) are ignored so that = exp(ik.-R) remains an imdistorted plane wave. The asymptotic solution for ij-when compared with the asymptotic boundary condition then provides the Bom elastic ( =f) or inelastic scattering amplitudes... [Pg.2045]

Numerical solution of this set of close-coupled equations is feasible only for a limited number of close target states. For each N, several sets of independent solutions F.. of the resulting close-coupled equations are detennined subject to F.. = 0 at r = 0 and to the reactance A-matrix asymptotic boundary conditions,... [Pg.2049]

If tire diffusion coefficient is independent of tire concentration, equation (C2.1.22) reduces to tire usual fonn of Pick s second law. Analytical solutions to diffusion equations for several types of boundary conditions have been derived [M]- In tlie particular situation of a steady state, tire flux is constant. Using Henry s law (c = kp) to relate tire concentration on both sides of tire membrane to tire partial pressure, tire constant flux can be written as... [Pg.2536]

An advantage of Eq. (90) for computational purposes is that the solutions are subject to single-valued boundary conditions. It is also readily verified that inclusion of an additional factor qjj the right-hand side of Eq. (89) adds a... [Pg.27]

This justifies the use of the simpler language over the one. The solution of the Poisson equation and the boundary conditions used are explained in detail elsewhere [55]. Here, we will present some selected results. [Pg.200]

The diabatic LHSFs are not allowed to diverge anywhere on the half-sphere of fixed radius p. This boundary condition furnishes the quantum numhers n - and each of which is 2D since the reference Hamiltonian hj has two angular degrees of freedom. The superscripts n(, Q in Eq. (95), with n refering to the union of and indicate that the number of linearly independent solutions of Eqs. (94) is equal to the number of diabatic LHSFs used in the expansions of Eq. (95). [Pg.212]

Another subject with important potential application is discussed in Section XIV. There we suggested employing the curl equations (which any Bohr-Oppenheimer-Huang system has to obey for the for the relevant sub-Hilbert space), instead of ab initio calculations, to derive the non-adiabatic coupling terms [113,114]. Whereas these equations yield an analytic solution for any two-state system (the abelian case) they become much more elaborate due to the nonlinear terms that are unavoidable for any realistic system that contains more than two states (the non-abelian case). The solution of these equations is subject to boundary conditions that can be supplied either by ab initio calculations or perturbation theory. [Pg.714]

HyperChem uses th e ril 31 water m odel for solvation. You can place th e solute in a box of T1P3P water m oleeules an d impose periodic boun dary eon dition s. You may then turn off the boundary conditions for specific geometry optimi/.aiion or molecular dynamics calculations. However, th is produces undesirable edge effects at the solvent-vacuum interface. [Pg.62]

Often yon need to add solvent molecules to a solute before running a molecular dynamics simiilatmn (see also Solvation and Periodic Boundary Conditions" on page 62). In HyperChem, choose Periodic Box on the Setup m en ii to enclose a soln te in a periodic box filled appropriately with TIP3P models of water inole-cii les. [Pg.84]

This is Che required boundary condition for the mass mean velocity, Co be applied at the tube surface r = a. With a non-vanishing value for v (a), Che Poiseuille solution (4.5) must now be replaced by the simple modification. [Pg.30]

Equipped with a proper boundary condition and a complete solution for the mass mean velocity, let us now turn attention to the diffusion equations (4.1) which must be satisfied everywhere. Since all the vectors must... [Pg.30]


See other pages where Boundary conditions solution is mentioned: [Pg.56]    [Pg.16]    [Pg.56]    [Pg.16]    [Pg.142]    [Pg.182]    [Pg.400]    [Pg.275]    [Pg.748]    [Pg.792]    [Pg.819]    [Pg.853]    [Pg.963]    [Pg.963]    [Pg.972]    [Pg.1098]    [Pg.2854]    [Pg.2866]    [Pg.2870]    [Pg.25]    [Pg.201]    [Pg.636]    [Pg.10]    [Pg.13]    [Pg.273]    [Pg.310]    [Pg.25]    [Pg.26]    [Pg.118]   
See also in sourсe #XX -- [ Pg.56 ]




SEARCH



Boundary Conditions and Solutions

Boundary conditions solute

Boundary conditions solute

Boundary solution

Conditioning solution

Particular solutions and boundary conditions

Stationary-state solutions Dirichlet boundary conditions

Stationary-state solutions Robin boundary conditions

© 2024 chempedia.info