Solid/liquid separation test numbers

As noted earlier, some of the steps that precede the insertion of the treated sample into the instrument for measurement (e.g. dissolution, clean-up, preconcentration, individual separation, derivatization) can have a critical influence on accuracy and precision depending on the particular step. All analytical processes include a sample preparation step which is a function of a number of factors such as the physical state of the sample, the nature of the sample matrix and analytes or the type of detector, for example. The first distinction therefore refers to the nature of the sample solid, liquid or gas. Solid samples are the most difficult to process as most analytical instruments cannot handle them. Therefore, the first operation in solid sample preparation involves transferring the target analytes to a liquid phase. This can be carried out in various ways including total dissolution of the test sample or partial dissolution or separation of a portion thereof. The different choices, which can be assisted by ultrasound, are depicted in Fig. 2.2, and discussed in the following sections. 

Note that filter aid selection must be based on planned laboratory tests. Guidelines for selection may only be applied in the broadest sense, since there is almost an infinite number of combinations of filter media, filter aids, and suspensions that will produce varying degrees of separation. The hydrodynamics of any filtration process are highly complex filtration is essentially a multiphase system in which interaction takes place between solids from the suspension, filter aid, and filter medium, and a liquid phase. Experiments are mandatory in most operations not only in proper filter aid selection but in defining the method of application. Some general guidelines can be applied to such studies the filter aid must have the minimum hydraulic resistance and provide the desired rate of separation an insufficient amount of filter aid leads to a reduction in filtrate quality — excess amounts result in losses is filtration rate and it is necessary to account for the method of application and characteristics of filter aids. 

Suspension films separating two solid surfaces, and Wetting films separating a solid or liquid from a vapour. The minimum water content for which a small sample of soil or similar material will barely flow in a standardized test method. Also termed the upper plastic limit . See also Atterberg Limits, Plastic Limit, Plasticity Number. Light non-aqueous phase liquid. See Non-aqueous Phase Liquid. 

Plastics are frequently used for applications requiring erosion resistance, but there does not seem to be much activity or interest in the tribology community of the 1990s. However, there are a number of tests that are applied and have been used to rate erosion resistance of plastics. Erosion, by definition, is progressive loss of material fiom a solid surface due to mechanical interaction between that surfitce and a fluid, a multicomponent fluid, or impinging liquid or solid particles (3). The field of erosion is usually separated into a number of forms of erosion liquid erosion, either continuous stream or droplet, solid particle erosion, slurry erosion, and cavitation erosion. Each have separate laboratory tests. 

---