Slip trimming

Track 3 shows the results of a slip trim to the same position. 

Slip trimming is performed by pressing the Alt key on yonr keyboard while dragging the edge of an event. Watch for the mouse cursor to change from the regnlar Draw or Paint tool cursor to the special slip trim cursor when the Alt key is pressed. 

A basic process flow diagram for the SNCR TDN process is shown in Figure 17.3. Anhydrous or aqueous ammonia is vaporized and mixed with a carrier gas of air or steam for transport to injection/distribution modules. The injection distribution modules distribute ammonia and/or hydrogen reagent and carrier gas to proprietary spray nozzles or injection lances. Reagent flow control can be controlled and trimmed by outlet NOx signals or ammonia slip measurements. 

A 1 piece and a V piece of brass pipe are used to make the endcap assembly. Split the 1 piece and trim as before until It will slip into the V piece, flush with one end. Solder in place. A IV washer is slipped into this end and is soldered in place. The endcap should now slide into the front end of the 8 tube and come to rest against both It, and the front of the 4 tube. Tape the endcap in place for step 0. 

After the liner is trimmed, slip it into the nipple. The position of the liner s seam when placed in the nipple should be 90° from each positive electrode port hole in the nipple (halfway in between them). Mark the position of the holes through the pipe nipple. 

Fig. 3. Orientation of the sample. A. The sample map (arrow). B. The position of the block before (thin arrow) and after (thick arrows) the detachment from the cover slip. C. The sample before its trimming the external view of the block. D. Scheme of the grid and the position of the cell (green, thick arrow) and cavities (circles, thin arrows). The cavities should form a horizontal line (red broken line). E. Position of the pyramid. F. The position of the sample after the orientation and trimming of the upper and lower edges (thick arrows) of the sample. The cell of interest is shown by the double arrow. The small arrow indicates the position of the glass knife related to the pyramid.

PLACE THE NEW TOILET. Toilets are heavy, so if you re not built like an offensive lineman, get help. Slip the holes over the bolts and set the toilet down gently on top of the wax ring. Sit on the toilet to press it into the wax ring until the toilet sits flush (no pun intended) on the floor. If the toilet rocks or the floor is uneven, use toilet shims to make it level and then use a utility knife or short handsaw to trim the shims until you can t see them. 

The traditional rule has been that one stage of neutralization is required for every 2 pH units the influent pH is away from the set point. For example, to go from an influent at 1 pH to a set point of 7 pH requires three stages of neutralization. A more exact rule would add another stage of neutralization if the control valve resolution was estimated to be more than half the allowable reagent error for the control band. This means that control valves with very low stick-slip and advanced control strategies that allow manipulation of a trim and a coarse valve on the same stage could eliminate a stage of neutralization. 

---