Silver electrodes, pyridine absorbed

Ever since Albrecht and Creighton [85], and Jenmarie and van Duyne [86], observed that the Raman cross-section for pyridine absorbed on a roughened silver electrode was larger than that in solution by six orders of magnitude, surface enhanced Raman spectroscopy (SERS) has steadily gained ground in analytical instrumentation. The sensitivity of this technique... 

Fig. 4.13. (a) Frequency-dependent SER spectrum of pyridine, INDO/S-SOS, with applied field being 2.81 eV. (b) Experimental SER spectrum of pyridine absorbed on a rough silver electrode in water at - 0.25 V vs a saturated Ag/AgCl/KCl reference electrode. 

M. Fleischmann, P.J. Hendra, A.J. McQuillan Raman spectra of pyridine absorbed at a silver electrode. Chem. Phys. Lett. 26, 163 (1974)... 

I. 4-methoxyacetophenone (30 //moles) was added as an internal standard. The reaction was stopped after 2 hours by partitioning the mixture between methylene chloride and saturated sodium bicarbonate solution. The aqueous layer was twice extracted with methylene chloride and the extracts combined. The products were analyzed by GC after acetylation with excess 1 1 acetic anhydride/pyridine for 24 hours at room temperature. The oxidations of anisyl alcohol, in the presence of veratryl alcohol or 1,4-dimethoxybenzene, were performed as indicated in Table III and IV in 6 ml of phosphate buffer (pH 3.0). Other conditions were the same as for the oxidation of veratryl alcohol described above. TDCSPPFeCl remaining after the reaction was estimated from its Soret band absorption before and after the reaction. For the decolorization of Poly B-411 (IV) by TDCSPPFeCl and mCPBA, 25 //moles of mCPBA were added to 25 ml 0.05% Poly B-411 containing 0.01 //moles TDCSPPFeCl, 25 //moles of manganese sulfate and 1.5 mmoles of lactic acid buffered at pH 4.5. The decolorization of Poly B-411 was followed by the decrease in absorption at 596 nm. For the electrochemical decolorization of Poly B-411 in the presence of veratryl alcohol, a two-compartment cell was used. A glassy carbon plate was used as the anode, a platinum plate as the auxiliary electrode, and a silver wire as the reference electrode. The potential was controlled at 0.900 V. Poly B-411 (50 ml, 0.005%) in pH 3 buffer was added to the anode compartment and pH 3 buffer was added to the cathode compartment to the same level. The decolorization of Poly B-411 was followed by the change in absorbance at 596 nm and the simultaneous oxidation of veratryl alcohol was followed at 310 nm. The same electrochemical apparatus was used for the decolorization of Poly B-411 adsorbed onto filter paper. Tetrabutylammonium perchlorate (TBAP) was used as supporting electrolyte when methylene chloride was the solvent. 

---