Separators high pressure type

The Indian PHWR is a pressure tube type reactor using heavy water moderator, heavy water coolant (in a separate high pressure high temperature system) and natural uranium oxide fuel. 

The steam engine has been perfected from the embryonic Savery type to the Watt type with a separate condenser and to the high pressure type of Trevithick. 

Another example is the purification of a P-lactam antibiotic, where process-scale reversed-phase separations began to be used around 1983 when suitable, high pressure process-scale equipment became available. A reversed-phase microparticulate (55—105 p.m particle size) C g siUca column, with a mobile phase of aqueous methanol having 0.1 Af ammonium phosphate at pH 5.3, was able to fractionate out impurities not readily removed by hquid—hquid extraction (37). Optimization of the separation resulted in recovery of product at 93% purity and 95% yield. This type of separation differs markedly from protein purification in feed concentration ( i 50 200 g/L for cefonicid vs 1 to 10 g/L for protein), molecular weight of impurities (<5000 compared to 10,000—100,000 for proteins), and throughputs ( i l-2 mg/(g stationary phasemin) compared to 0.01—0.1 mg/(gmin) for proteins). 

Fig. 23. Two types of hollow-fiber modules used for gas separation, reverse osmosis, and ultrafiltration applications, (a) Shell-side feed modules are generally used for high pressure appHcations up to - 7 MPa (1000 psig). Fouling on the feed side of the membrane can be a problem with this design, and pretreatment of the feed stream to remove particulates is required, (b) Bore-side feed modules are generally used for medium pressure feed streams up to - 1 MPa (150 psig), where good flow control to minimise fouling and concentration polarization on the feed side of the membrane is desired.

Reverse Osmosis. Membranes are used for the separation of smaller components (<500 daltons). They have smaller pore space and are tighter than those used for ultrafiltration. High pressure pumps, usually of the positive piston or multistage centrifugal type, provide pressures up to 4.14 MPa (600 psi). 

At the time of the solvent methanol experiments a metering pump was used. In some experiments the pulsating action of the pump can be disturbing, so a high-pressure syringe-type pump can be used. Since mass flow controllers are available now, the combination of a gas-pressurized feed tank on an electronic scale for liquid level indication and a mass flow controller seems to be a good choice. Both the feed tank and separator can be heated or cooled. In the case of the solvent methanol experiments. 

Depending on the number of stages, the gas that flashes in the lowci pressure separators can be compres.sed and then recombined with the gas from the high-pressure separator. Both reciprocating and centrifugal compressors are commonly used. In low-horsepower installations, especially lor compressing gas from stock tanks (vapor recovery), rotary aiuf vane type compressors are common. 

For gases, both permeation and diffusion data are best measured by permeation tests, many different types been described elsewhere. The same sheet membrane permeation test can quantify permeation coefficient Q, diffusion coefficient D, solubility coefficient s, and concentration c. The membrane, of known area and thickness, must be completely sealed to separate the high-pressure (initial) region from that containing the permeated gas it may need an open-grid support to withstand the pressure. The permeant must be suitably detected and quantified (e.g., by pressure or volume buildup, infrared (IR) spectroscopy, ultraviolet (UV), gas chromatography, etc.). 

---