Ceramics seeds

Precipitation of a hydrated titanium oxide by mixing aqueous solutions of titanium chloride with alkaU forms the precipitation seeds, which are used to initiate precipitation in the Mecklenburg (50) variant of the sulfate process for the production of pigmentary titanium dioxide. Hydrolysis of aqueous solutions of titanium chloride is also used for the preparation of high purity (>99.999%) titanium dioxide for electroceramic appHcations (see Ceramics). In addition, hydrated titanium dioxide is used as a pure starting material for the manufacture of other titanium compounds. 

In the glass (qv) and ceramic industry (see Ceramics), barite can be used both as a flux, to promote melting at a lower temperature or to increase the production rate, and as an additive to increase the refractive index of glass. The viscosity of barite-containing glass often needs to be raised. Alumina in the form of feldspar is sometimes used. To offset any color produced by iron from the barite addition, more decolorizer may be needed. When properly used, barytes help reduce seed, increase toughness and brilliancy, and reduce annealing time. Barite is also a raw material for the manufacture of other barium chemicals. 

In the flux-growth method, crystals of the desired ceramic are precipitated from a melt containing the components of the product phase, often in addition to additives used to suppress the melting point of the flux. These additives remain in solution after crystal growth is complete. Crystals are precipitated onto seeds by slowly cooling the melt or the seed, or occasionally by evaporating volatile components of the melt such as alkaH haHdes, depressing the solubiHty of the product phase. 

Hollow and porous polymer capsules of micrometer size have been fabricated by using emulsion polymerization or through interfacial polymerization strategies [79,83-84, 88-90], Micron-size, hollow cross-linked polymer capsules were prepared by suspension polymerization of emulsion droplets with polystyrene dissolved in an aqueous solution of poly(vinyl alcohol) [88], while latex capsules with a multihollow structure were processed by seeded emulsion polymerization [89], Ceramic hollow capsules have also been prepared by emulsion/phase-separation procedures [14,91-96] For example, hollow silica capsules with diameters of 1-100 micrometers were obtained by interfacial reactions conducted in oil/water emulsions [91],... 

M.P. Colombini, F. Modugno, E. Ribechini, Organic mass spectrometry in archaeology evidence for Brassicaceae seed oil in Egyptian ceramic lamps, Journal of Mass Spectrometry, 40, 890 898 (2005). 

Hoffmann, M. Hofer, C. Schneller, T. Bottger, U. Waser, R. 2002. Preparation and aging behavior of chemical-solution-deposited (Pb(Mg1/3Nb2/3)03)i x-(PbTi03)x thin films without seeding layers. J. Am. Ceram. Soc. 85 1867-1869. 

An increase of the fracture toughness from 2 to 6 MPa m1/2 was observed in hot pressed Si3N4 ceramics with 50 vol% residual a-Si3N4 by adding 5 vol% seeds [635],... 

---