Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Same , definitions

The same definition of viscosity applies to oil as gas (see Section 5.2.6), but sometimes the kinematic viscosity is quoted. This is the viscosity divided by the density (u = i7p), and has a straight line relationship with temperature. [Pg.109]

The Fair Packaging and Labeling Act, which uses the same definitions for dmgs and cosmetics as the Food, Dmg and Cosmetic Act, only has jurisdiction over retail products sold to the consumer for use at home. This condition exempts free samples and professional use products not sold to a consumer for personal use. [Pg.460]

Same definitions as 5-26-M. ILff = effective viscosity from power law model, Pa-s. <3 = surface tension liquid, N/m. [Pg.617]

E] Use s BoUes Fair (Ref. 75) data base to determine new effective area to use with Onda et al. (Ref. 126) correlation. Same definitions as 5-28-D. P = total pressure, atm Mq = gas, molecular weight m = local slope of equilibrium curve Lf /Gf = slope operating line Z = height of packing in feet. [Pg.622]

Interconversion between two tautomeric structures can occur via discrete cationic or anionic intermediates (scheme 24, where T is an anion capable of reacting with a proton at a minimum of two distinct sites). Alternatively, interconversion can occur by simultaneous loss and gain of different protons (scheme 25, w here T has the same definition as in scheme 24). These mechanisms are well established for acyclic compounds, but they have been much less thoroughly investigated for heteroaromatic systems. The rate of interconversion of two tautomers is greatest when both of the alternative atoms to which the mobile proton can be attached arc hetero atoms, and isolation of the separate isomers is usually impossible in this case. If one of the alternative atoms involved in the tautomerization is carbon, the rate of interconversion is somewhat slower, but still fast. When both of the atoms in question are carbon, however, interconversion is... [Pg.317]

Soil specific weight is the measure of the concentration of packing of particles in a soil mass. It is also an index of compressibility. Less dense, or loosely packed, soils are much more compressible under loads. Soil specific weight may be expressed numerically as soil ratio and ptorosity (porosity for soils being basically the same definition as that for rocks discussed earlier in this section). Soil porosity e is... [Pg.270]

Different terms are used when discussing the subject of designing with plastics. Many of them could be repeated in this book. To eliminate repeating the same definition the Appendix B TERMINOLOGY has been prepared. Where it is important to describe a term in the text, its definition is only used in the text. The INDEX includes the definitions in the text. [Pg.36]

The term proton in these definitions refers to the hydrogen ion, H+. An acid is a species containing an acidic hydrogen atom, which is a hydrogen atom that can be transferred as its nucleus, a proton, to another species acting as a base. The same definitions were proposed independently by the English chemist Thomas Lowry, and the theory based on them is called the Bronsted-Lowry theory of acids and bases. [Pg.515]

The subscripts m, L, S, and G will represent the local two-phase mixture, liquid phase, solid phase and gas phase, respectively. The definitions below are given in terms of solid-liquid (S-L) mixtures, where the solid is the more dense distributed phase and the liquid the less dense continuous phase. The same definitions can be applied to gas-liquid (G-L) flows if the subscript S is replaced by L (the more dense phase) and the L by G (the less dense phase). The symbol

volume fraction of the more dense phase, and s is the volume fraction of the less dense phase (obviously (p = 1 — e). An important distinction is made between ([Pg.444]

This definition completely coincides with the characteristic time of the probability evolution introduced in Ref. 32 from the geometrical consideration, when the characteristic scale of the evolution time was defined as the length of rectangle with the equal square, and the same definition was later used in Refs. 33-35. Similar ideology for the definition of the mean transition time was used in Ref. 30. Analogically to the MTT (5.4), the mean square d2(c,x, d) = (f2) of the transition time may also be defined as... [Pg.378]

Using the same definition in Table 8.1, the sensitivity in surface sensing can be then expressed as... [Pg.216]

To develop a coherent kit of components, we must begin by defining a common set of connectors and common models of what the components talk to one another about. In a bank, for example, there is no hope of making the components reconfiguiable unless all of them use the same definition of basic concepts such as customer, account, and money (at their connectors, if not internally). [Pg.18]

We have seen that the joint velocity, composition PDF treats both the velocity and the compositions as random variables. However, as noted in Section 6.1, it is possible to carry out transported PDF simulations using only the composition PDF. By definition, x, t) can be found from /u,< >(V, 0 x, t) using (6.3). The same definition can be used with the transported PDF equation derived in Section 6.2 to find a transport equation for / (0 x, r). [Pg.268]

The same definitions apply to longer n systems Suprafacial use of ao bond involves bonding in the same way at both terminals. So there is retention of configuration at both ends or inversion a both ends. [Pg.33]

The fuel oils coming out of olefin plants are also characterized by an abundance of polynuclear aromatic molecules, (Same definition as for Figure 2—1). They are sometimes inaccurately referred to as having a high aromatics content. Nomenclature aside, because of this, the burning characteristics of pyrolysis gas oil and pyrolysis pitch are poor. They are smoky, sooty, and gum formers they rend to be more viscous, and because of their polynuclear aromatic concent, they are suspected carcinogens. They are basically a witchs brew of unsavory hydrocarbons.. ... [Pg.74]

The same definitions apply to strong and weak bases as to strong and weak acids. [Pg.32]

By using the same definitions, the profile for combined Doppler, natural, and collision broadening may be expressed in terms of the Voigt function ... [Pg.43]

All these studies essentially use the same definition for responder (i.e., 20% improvement on a standard rating instrument, usually the Positive and Negative Symptoms Scale [PANSS]). Because this criterion is the standard and was decided beforehand, there is no statistical problem of a post hoc choice of optimal cutoff points for dichotomization. [Pg.58]

Warnings imply that the patient should be monitored very carefully and may become eligible for other treatments. The same definitions ean be used to define the response after IM dose escalation. [Pg.135]

Arbitrarily using the same definition with Bingham plastics gives... [Pg.92]

In the Kohn Sham equations (A.116) [324, 325], the core Hamiltonian operator h( 1) has the same definition as in HF theory (equation A.6), as does the Coulomb operator, 7(1), although the latter is usually expressed as... [Pg.245]


See other pages where Same , definitions is mentioned: [Pg.617]    [Pg.617]    [Pg.621]    [Pg.2309]    [Pg.558]    [Pg.271]    [Pg.43]    [Pg.128]    [Pg.101]    [Pg.87]    [Pg.87]    [Pg.393]    [Pg.396]    [Pg.132]    [Pg.46]    [Pg.222]    [Pg.230]    [Pg.607]    [Pg.83]    [Pg.116]    [Pg.108]    [Pg.94]    [Pg.393]    [Pg.279]    [Pg.773]    [Pg.208]    [Pg.219]    [Pg.197]    [Pg.88]   
See also in sourсe #XX -- [ Pg.159 ]




SEARCH



© 2024 chempedia.info