Rotary tablet press design punch

The pharmaceutical industry produces tablets almost exclusively on rotary tablet presses from pilot plant to commercial manufacture. The output from different tablet presses may range from a few thousand tablets per hour to more than 1 million tablets per hour. By design, the compression event occurs using three parts a die, lower punch, and upper punch. The dies and punches are mounted on a rotating turret. The shape of the die controls the shape of the tablets, while the distance between the lower and upper punch tips at the maximum compression force determines the thickness of the tablets. The tablet compression process is divided into three steps powder filling into the die, compression, and tablet ejection from the die.85... 

Upper precompression and main compression rollers insertion depth adjustments Insertion depth for both precompression and main compression is adjusted in the upper cam section. The insertion depth determines the location of tablet formation in the die cavity relative to the top of the die table as shown in Fig. 5. It is measured as the distance at which the upper punch enters into the die at the tangent between the upper punch head and the compression roller. Insertion depth can be varied between 2 and 6 mm on most machines and is typically maintained between 3 and 4 mm. For precompression and main compression, the insertion depth should be maintained at approximately the same position. On most modern rotary tablet presses, the adjustments for precompression and main compression insertion depth are independent. However, on many older designs, the precompression roller is attached to the main compression roller assembly and its position is measured relative to the main compression roller position. In this way, the ratio of precompression to main compression remains constant as machine adjustments are made. 

In single-punch tablet presses (reciprocating tablet presses), the punches are fixed to the punch holders which travel up and down, and in many cases fixation screws are used. Each make has its own holder design for punches and dies, and consequently for the tooling sets as well. Therefore little can be said in general terms, but it would appear that on the whole the remarks on the rotary press tooling apply correspondingly. 

Mechanically powered compaction simulators are also available to replicate the compression event of tablet presses (3). These machines leverage the design of traditional rotary tablet presses where the punches are forced between a set of roll wheels to enable the compression event. The punch type and roll wheels can be changed to replicate the compression event of different press types. In some models, the fill station, compression station(s), and ejection station arc aligned in series on a linear track, where the punches and die travel along this track from station to station to complete the fUl-comprcss-ejection cycle. 

---