Rheology component

Fundamental mechanisms of adhesion. All classical adhesion tests involve a rheological component, in the deformation of the near-interface material, and a surface chemical component. With the recent availability of microscopic techniques to study surface forces, one can possibly go after the surface chemical component, separately from the rheological component. More generally, the configurational and dynamic behavior of macromolecular interfacial regions remains a very rich area. 

The rheological component is likewise dependent on the particle size and the resulting surface area, but also on the structure and the surface chemistry. Finely divided pigment blacks have a relatively high surface area and therefore a strong thickening effect If the particle size increases, the surface area decreases and the thickening effect is reduced. This means ... 

What are the characteristics of that material which will affect metering viscosity (rheology), component ratio, filled or unfilled, abrasive or nonabrasive, pot life ... 

Note that convected derivatives of the stress (and rate of strain) tensors appearing in the rheological relationships derived for non-Newtonian fluids will have different forms depending on whether covariant or contravariant components of these tensors are used. For example, the convected time derivatives of covariant and contravariant stress tensors are expressed as... 

Four modes of characterization are of interest chemical analyses, ie, quaUtative and quantitative analyses of all components mechanical characterization, ie, tensile and impact testing morphology of the mbber phase and rheology at a range of shear rates. Other properties measured are stress crack resistance, heat distortion temperatures, flammabiUty, creep, etc, depending on the particular appHcation (239). 

The solvent-borne NR adhesives show an important mechanical component in the bonding process, and therefore bulk mechanical and rheological properties (addition of fillers is quite effective) are important. In fact, these adhesives are mainly suitable when at least one of the surfaces to be joined is water-porous (paper, concrete, leather, textiles). 

From the y(jc) functions and the two melt temperatures used, and by using the viscosity curves from rheological examinations (Fig. 11), viscosity distributions T](jc) of the two pure components were easily determined, as shown in Figs. 15a and 15b. Subsequently, the viscosity ratio functions 6(jc) were also calculated (Fig. 16). All four curves fall slightly from the core to the outside. 

Mechanical compatibilization is accomplished by reducing the size of the dispersed phase. The latter is determined by the balance between drop breakup and coalescence process, which in turn is governed by the type and severity of the stress, interfacial tension between the two phases, and the rheological characteristics of the components [9]. The need to reduce potential energy initiates the agglomeration process, which is less severe if the interfacial tension is small. Addition... 

---